A record of accelerated erosion in the recent sediments of Blelham Tarn in the English Lake district

Two frozen cores from Blelham Tarn were subsampled and measured using mineral magnetic, loss-on-ignition (LOI), radiometric, granulometric and diatom analyses. A detailed chronology was established using varves, radioisotopes and diatoms. This has enabled an accurately dated reconstruction of sedimentation over the past forty years. Despite a large increase in lake productivity, evidence suggests that the observed exponential increase in sedimentation rates can be attributed to erosion within the catchment. The predominant sediment source has been identified as surface soil. A comparison between the trend of accelerated sedimentation and the record of increased sheep stocking density for the area within which the most of the catchment lies, as well as observations of contemporary surface processes within the catchment, both suggest that much of the recent erosion is a direct response to increased pressure from sheep grazing.     

Streambank fish-shelter structures help stabilize tributary streams in Wisconsin

 A significant proportion of stream sediment yield in North America comes from stream channel and bank erosion. One method used for stream stabilization is the bank installation of timber and stone fish-shelter structures, but there is little evidence for their potential effectiveness. Nine to nineteen years of precise survey data from Coon Creek, Wisconsin, however, show that fish structures enhance sediment deposition along the stream and may retard lateral migration of channels. Such structures have greater utility for sediment control when streams are eroding away a high bank and replacing it with a lower bank. Received: 18 October 1996 · Accepted: 4 February 1997     

Geotechnical Hazards Associated with Desert Environment

The aridity of the Arabian Peninsula's deserts ranges between arid to hyperarid with hot dry climate, scarce precipitation and sparse vegetation. These harsh environmental conditions enhance some geomorphologic processes more than others, cause specific geotechnical problems, and increase desertification.From west to east, the general physiography of Saudi Arabia shows the Red Sea coastal plains and the escarpment foothills called Tihama followed by the Arabian Shield mountains, the Arabian Shelf plateau and finally the Arabian Gulf coastal plains. Sand moves by wind either as drifting sand or migrating dunes in four major sand seas, over the Arabian Shelf, and in the inter-mountain valleys, in the Arabian Shield causing problems of erosion and deposition. Human activities in the deserts may cause more instability to the sand bodies, enlarging the magnitude of the problem. Fine silty soil particles also move by wind, depositing loess mainly in selected areas downwind in the Tihama. These loess deposits subside and may form earth fissures by the process of hydrocompaction upon wetting. The addition of water can be either natural through storms or man-made through human agricultural or civil activities. Extensive sabkhas exist along the coastal plains of both the Red Sea and Arabian Gulf. The sabkha soil may also heave by salt re-crystallization or collapse by wetting. The shallow groundwater brines present in sabkhas also attack and corrode civil structures. Urbanization and excessive groundwater pumping may also deplete the fresh groundwater resources and may cause subsidence, ground fissuring and surface faulting as observed in some locations in the Arabian Shield. Although the average annual precipitation is very low, rain usually falls in the form of torrential storms, collected by dry valley basins and causing floods to unprotected downstream areas on the coastal plains of the Red Sea.The desert environment, being a fragile echo system, needs to be treated with care. Intercommunications between different national and international agencies and education of the layman should help to keep the system balanced and reduce the resulting environmental hazards. In addition, any suggested remedial measures should be planned with nature and engineered with natural materials.     

RILL EROSION PROCESS ON STEEP SLOPE LAND OF THE LOESS PLATEAU

IntheLoessPlateau,alongtheslopelengthfromthetoptothebottom,soilerosionischaracterizedbyobviousverticalzonaldivision,thatis,sheeterosionzone,sheeterosionandrillerosionzone,rillerosionandshallowgullyerosionzoneandgullyerosionzone.Inthesheetandrillero..sionzone,rillerosionamounttakesup70%ofthetotalsoilloss[TANGKenetal.,1983,ZHENGFenlietal.,19871;intherillandshallowgullyerosionzone,rillerosionamountaccountsfor30--40%ofthetotalsoilloss.Sorillerosionisamajorerosionpatternonsteepslopeland.Riller…     

Erosion rates of alpine bedrock summit surfaces deduced from in situ Be and Al

We have measured the concentration of in situ produced cosmogenic ¹⁰Be and ²⁶Al from bare bedrock surfaces on summit flats in four western U.S. mountain ranges. The maximum mean bare-bedrock erosion rate from these alpine environments is 7.6 ± 3.9 m My⁻¹. Individual measurements vary between 2 and 19 m My⁻¹. These erosion rates are similar to previous cosmogenic radionuclide (CRN) erosion rates measured in other environments, except for those from extremely arid regions. This indicates that bare bedrock is not weathered into transportable material more rapidly in alpine environments than in other environments, even though frost weathering should be intense in these areas. Our CRN-deduced point measurements of bedrock erosion are slower than typical basin-averaged denudation rates ( 50 m My⁻¹). If our measured CRN erosion rates are accurate indicators of the rate at which summit flats are lowered by erosion, then relief in the mountain ranges examined here is probably increasing.

We develop a model of outcrop erosion to investigate the magnitude of errors associated with applying the steady-state erosion model to episodically eroding outcrops. Our simulations show that interpreting measurements with the steady-state erosion model can yield erosion rates which are either greater or less than the actual long-term mean erosion rate. While errors resulting from episodic erosion are potentially greater than both measurement and production rate errors for single samples, the mean value of many steady-state erosion rate measurements provides a much better estimate of the long-term erosion rate.     

坡地系统土壤侵蚀定量评价方法

区域性土壤侵蚀的定量评在涉及到泥沙输移的非连续性难题和众多的非确定性因素，目前应用较普遍的小区定量难以适用。所提出的定量评价方法是利用ＧＩＳ技术、模糊数学、将以分布参数为特征的区域坡地系统划分成若干类具有集中参数特征的基本侵蚀单元，结合ＵＳＬＥ方程来模拟空间上不同侵蚀背景条件下土壤侵蚀的强度，并可以确定影响土壤侵蚀的主要因子及其排序，该方法适用性强，可用于不同空间尺度的土壤侵蚀定量评价。     

Crater formation in soils by raindrop impact

The process of crater formation by the impact of water drops on soil, sand and various other target material was studied. Craters of various shapes and sizes were observed on different target materials or conditions, ranging from circumferential depression to completely hemispherical shape. Crater shape was dependent upon target material, its ?ow stress or shear strength and the presence and thickness of water on the surface. Between 5 and 22 per cent of impact energy was spent on cratering, but the relationship between crater volume and kinetic energy of a raindrop was curvilinear, indicating a lower ef?ciency of impact energy in removing target material as the energy increases. Impact impulse, on the other hand, showed a more linear relationship with crater volume, and the ratio of impulse over crater volume (I/V) remained constant for the entire range of drop sizes, impact velocities, and surface conditions used in this study. Surface shear strength, represented by the penetration depth of fall‐cone penetrometer, appeared to be a key factor involved in this process. An equation was developed which related crater volume to cone penetration depth and impact impulse. Crater volume, which appeared to be a better indicator of the total amount of material dislodged by a raindrop than splash amount, can thus be predicted using this equation. Copyright © 2004 John Wiley & Sons, Ltd.     

Earthquake‐related geomorphic environment and pond sediment information

Shaking during the 1995 Kobe earthquake caused surface material to be more mobile in catchment areas in the Rokko Mountains, Kobe, where there are some active fault lines. As a result, there were many landslides associated with the earthquake. The sedimentation rate in a pond in the mountains increased several fold, then exponentially decreased with seasonality over several years. Six years after the earthquake there were no marked surface movements related to the earthquake, even though the sedimentation rates had increased slightly. A new steady state for the structure of the earthquake‐modi?ed surface had evidently been reached. Copyright © 2004 John Wiley & Sons, Ltd.     

化学腐蚀下砂岩三轴细观损伤机理及损伤变量分析

利用CT识别技术对化学腐蚀下的砂岩进行了三轴加载全过程的即时扫描试验，得到了在不同级荷载作用下砂岩的压密、微裂纹萌生、扩展和破裂的CT图像和CT数，分析了砂岩损伤演化的细观机理。同时，建立了一个基于化学腐蚀影响和CT数的损伤变量模型。