Magnetic field hysteresis of critical currents in Bi(2223)/Ag tapes and a way to overcome it

Experiments showing hysteresis of critical currents versus the external magnetic field I_c(B_e) were performed with two multifilamentary Bi(2223)/Ag tapes. The I_c(B_e) hysteresis is observable in the transversal as well as in the longitudinal orientation of the long axis of the tape with respect to the magnetic field. Based on the idea that the hysteresis is the effect of trapped flux in a network of well-connected current paths, a way to overcome this effect has been proposed and experimentally verified. The induced frozen-in screening currents are split into several parallel current patterns by cycling the external magnetic field around the adjusted value. Using the proposed method, the ‘neutral’ I_c(B_e) characteristics have been found. Approximate calculations of the penetration depth of the trapped flux show that the network of well-connected current paths could be formed by several disk-shaped grains (≈ Φ8 × 0.4 μ) stacked into more or less axially ordered (quasi cylindrical) colonies of average dimensions estimated to ≈ Φ8 × 4 μm.     

SO_3磺化法合成PNTS新工艺的研究

本文采用正交设计及方差分析法,确定了 SO_3磺化法合成 PNTS 新工艺的最佳工艺条件;并从技术及经济方面将新工艺同国内现有的生产老工艺进行了分析对比。     

Structure and properties of injection‐molded polypropylenes with different molecular weight distribution and tacticity characteristics

Two series of polypropylenes with different molecular weight distribution and tacticity characteristics were injection molded into flexural test specimens by varying cylinder temperature and the effects of the molecular weight distribution and tacticity on the structure and properties of the moldings were studied. Measured propertied were flexural modulus, flexural strength, heat distortion temperature, Izod impact strength, and mold shrinkage and structures studied were crystallinity, the thickness of skin layer, a*‐axis‐oriented component fraction and crystalline orientation functions. The relations between the structures and properties were also studied. It was found that the molecular weight distribution and tacticity characteristics affect the properties mainly through the molecular orientation and crystallinity, respectively. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 84: 2142–2156, 2002     

300脚MSA 10 Gbit/s Transponder模块

分析了开发10Gbit/sTransponder模块的必然性，介绍了10Gbit/sTransponder模块的原理、特点和参数指标。并且用开发出的两只40km300脚10Gbit/sTransponder模块成功地进行了43km的无误码传输试验和测试。     

Alternating,all-trans polyenynes: Model compounds for poly(diacetylene)s with defined conjugation length

The syntheses of polyenynes as model compounds for poly(diacetylene)s (PDAs) are described. Variation of properties (UV–VIS, Raman, NMR and bond geometries) as a function of the chain length was investigated. After extrapolation to infinite chain length these data were compared to those for PDAs. From UV–VIS spectra a value of λ = 551 nm (2.25 eV) was calculated corresponding to the electronic transition of a single polyenyne chain. This energy is located at the low energy end of a yellow PDA solution spectrum. From Raman scattering v_(C?C) = 2108–2128 cm^?1 and v_(C?C) = 1505–1532 cm^?1 were calculated after extrapolation. Similarly sp-C¹³C NMR data yielded a shift of δ = 100 ppm. These data are almost identical to data known for yellow PDA solutions. Bond geometries are almost identical to those of poly(diacetylene)s and theoretical data.     

Hot-drawing of poly(methyl methacrylate) and simulation using a glass-rubber constitutive model

The large-deformation three-dimensional glass-rubber constitutive model for isotropic, amorphous, linear polymers near the glass transition, previously proposed, has been extended to include a spectrum of network relaxations. In addition, an experimental programme of uniaxial tension and compression tests was carried out on high molecular weight cast sheets of poly(methyl methacrylate) (PMMA), with varying strain-rate and temperature across the range from 114 to 190 °C, encompassing the thermoforming range of practical importance. The extended model was found to fit successfully the data for PMMA, provided a doublet network relaxation spectrum was employed. The original model, with only a single network relaxation, was found to be grossly inadequate when there was significant network relaxation by entanglement slippage. Parameters of the model for PMMA, obtained by fitting to the new data, were compared with values obtained by other routes.     

Ionomer composites based on sepiolite/hydrogenated poly(styrene butadiene) block copolymer systems

Ionomeric composites based on sepiolite and hydrogenated poly(styrene butadiene) block copolymer were obtained and characterized from a microstructural and electrical point of view. Before blending, because of the high silanol group concentration in the sepiolite, the latter could be organophilized with suitable coupling agents. The resulting materials were easily processed into thin films or membranes 0.2–0.4 mm thick, their conductivity in some cases approaching 10^?1 S/cm. Their suitability for film formation and good electrical properties indicate potential applications as electrolytes in polymer fuel cells. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 86: 3512–3519, 2002     

未来十年综合航电系统的发展趋向

本文主要阐述未来十年国外综合航电系统的总的发展趋向，重点介绍了在开放式系统结构的研究与应用、采用COTS技术、模块化、多传感器综合技术等方面的发展趋向。     

Synthesis and Spectral Properties of Mixed-Ligand Complexes of Lanthanide Perchlorate with Bis-(phenylsulfinyl)ethane and Organic Lewis Bases

ＳｙｎｔｈｅｓｉｓａｎｄＳｐｅｃｔｒａｌＰｒｏｐｅｒｔｉｅｓｏｆＭｉｘｅｄＬｉｇａｎｄＣｏｍｐｌｅｘｅｓｏｆＬａｎｔｈａｎｉｄｅＰｅｒｃｈｌｏｒａｔｅｗｉｔｈＢｉｓ（ｐｈｅｎｙｌｓｕｌｆｉｎｙｌ）ｅｔｈａｎｅａｎｄＯｒｇａｎｉｃＬｅｗｉｓＢａｓｅ...     

空气中^131I的取样和测量方法的研究

本文介绍一种气态和气载~(131)I 取样器。着重介绍了一种指数分布源的效率刻度方法,讨论了与取样有关的一些问题。