Trenched‐Sinker LDMOSFET (TS‐LDMOS) Structure for 2 GHz Power Amplifiers

This paper proposes a new LDMOSFET structure with a trenched sinker for high‐power RF amplifiers. Using a low‐temperature, deep‐trench technology, we succeeded in drastically shrinking the sinker area to one‐third the size of the conventional diffusion‐type structure. The RF performance of the proposed device with a channel width of 5 mm showed a small signal gain of 16.5 dB and a maximum peak power of 32 dBm with a power‐added efficiency of 25% at 2 GHz. Furthermore, the trench sinker, which was applied to the guard ring to suppress coupling between inductors, showed an excellent blocking performance below ?40 dB at a frequency of up to 20 GHz. These results confirm that the proposed trenched sinker should be an effective technology both as a compact sinker for RF power devices and as a guard ring against coupling.     

Data retention characteristics of sub-100 nm NAND flash memory cells

In contrast to the conventional theories, we have revealed that the most distinguished mechanism in the data retention phenomenon after Fowler-Nordheim (FN) stress in sub-100 nm NAND Flash memory cells is the annihilation of interface states. Interface state generation rate increases rapidly as the channel width of NAND flash cell decreases. Comparison of interface states and stress-induced leakage current (SILC) component during retention mode shows that the annihilation of interface states strongly affects data retention characteristics of the programmed cells.     

Adaptive contour smoothing based on inter-region contrast

An adaptive contour smoothing algorithm designed as a preprocessor for shape coders is presented. In the method, the degree of the adaptive smoothing is controlled based on the significance of each contour point, which is quantified according to inter-region contrast in an intensity image. The actual smoothing consists of an expansion operator and a thinning algorithm.     

Mechanism of simultaneous solutes separation and concentration by size exclusion cyclic separation

The semicontinuous separation/concentration of two solutes with different molecular size by the size exclusion cyclic separation method is based on the opposite swelling responses of two gels to a temperature change. Experimental results of separation and concentration of solutes are verified qualitatively by the theoretical models based on the local equilibrium assumption. Separation of two solutes is shown by the breakthrough curves in coupled gel columns. In closed coupled columns, the volumetric space for the large molecules which are totally excluded from the gels becomes smaller, creating a concentrating effect as the gels swell when temperature changes. A mechanistic model is suggested to predict the large molecule concentration to increase to its solubility limit as cycle repeats.     

Role of conserved Asn-Tyr-Asp-Tyr sequence in bacterial copper/2,4, 5-trihydroxyphenylalanyl quinone-containing histamine oxidase

Copper amine oxidase contains a covalently bound quinonoid cofactor, 2,4,5-trihydroxyphenylalanyl quinone (TPQ), which is synthesized by post-translational modification of a specific tyrosyl residue occurring in the highly conserved sequence, Asn-Tyr-(Asp/Glu)-Tyr. To elucidate the role(s) of the conserved sequence in the biogenesis of TPQ, each of the corresponding residues at positions 401-404 in the recombinant histamine oxidase from Arthrobacter globiformis has been replaced with other amino acids by site-directed mutagenesis. When Asn-401 was changed to Asp or Gln, the rate of TPQ formation by copper-dependent self-processing was 10(3)- to 10(4)-fold slower than in the wild-type enzyme. When Tyr-402 was replaced by Phe, TPQ was not formed at all, showing that Tyr-402 is essential as the precursor to TPQ. In contrast, Asp-403 could be replaced by Glu without changes in the rate of TPQ formation, whereas its replacement by Asn led to a marked decrease. Furthermore, when Tyr-404 was changed to Phe, TPQ was formed swiftly on incubation with copper ions, but the TPQ enzyme exhibited very low activity with altered substrate specificity. These results collectively indicate that a very rigorous structural motif is required for efficient formation of TPQ and for the catalytic activity in the active site of copper amine oxidases.     

Reduction of loading effect by tungsten etchback in a magneticallyenhanced reactive ion etcher

The plug loading effect occurring during the etchback of tungsten was investigated in a magnetically enhanced reactive ion etcher using SF ₆/Ar mixtures. It was found that while the plug loading effect is independent of varying SF₆/Ar flow rate ratio and magnetic field intensity, it is reduced under the condition of high selectivity of tungsten relative to TiN which was achieved at high chamber pressure and low RF power. It is proposed that when TiN is used as a glue layer, the W etch rate enhancement in the plug is mainly controlled by a local loading effect. Under the optimized etchback conditions the plug loss was successfully controlled without the tungsten residue left on severe topology     

Analysis of culture fluorescence by a fiber-optic sensor inNicotiana tabacum plant cell culture

The on-line sensing of viable cell weight in plant cell culture process is applied to analysis and control of process. The fiber-optic fluorescence sensor was constructed to measure the NADH-dependent fluorescence inNicotiana tabacum plant cell culture and the analysis of fluorescence signal was done to be correlated with the viable cell weight. The structured kinetic model for cell growth was proposed to estimate the theoretical viable cell weight. The dimensional analysis was proposed for the interpretation of fluorescence signal, in which the path length, the inner filter effect and the hydrodynamic conditions were considered as the key factors on fluorescence signal. The dimensional analysis and empirical correlation of fluorescence signal to viable cell weight was applied to the interpretation of the detected fluorescence signal during cultivation. The proposed interpretation of fluorescence signal using dimensional analysis was well correlated with the viable cell weight estimated by the structured kinetic model as well as by empirical correlation.     

Multiresolution segmentation of respiratory electromyographicsignals

Analysis of respiratory electromyographic (EMG) signals in the study of respiratory control requires the detection of burst activity from background (signal segmentation), and focuses upon the determination of onset and cessation points of the burst activity (boundary estimation). The authors describe a new automated multiresolution technique for signal segmentation and boundary estimation. During signal segmentation, a new transitional segment is defined which contains the boundary between background a burst activity. Boundary estimation is then performed within this transitional segment. Boundary candidates are selected and a probability is attributed to each candidate, using an artificial neural network. The final boundary for a given transitional segment is the boundary estimate with the maximum a posteriori probability. This new method has proved accurate when compared to boundaries chosen by two investigators