Vibration thresholds for fretting corrosion in electrical connectors

Single frequency vibration tests were used to induce fretting corrosion in tin alloy plated contacts. The samples used in this study were connectors consisting of 25 pairs of mated pin and socket contacts. Experimental results for a variety of vibration levels, frequencies, and wiring tie-off lengths are presented. The experiments consisted of running a series of vibration tests at each frequency where the excitation level was stepped through a range of g-levels. During each test run contact resistance was monitored as a performance characteristic. The results exhibit threshold behavior at each frequency for the onset of fretting degradation. Typically a plateau region was observed where similar g-levels produced similar fretting rates. It was also found that outside the plateau region the g-levels varied according to the dynamic behavior of the mechanical system. In addition, a transfer matrix model was used to analyze these results. An empirical fit of the data correlated well with the model when damping was used. This analysis revealed the importance of the bending moment induced at the contact interface as a result of excitation levels and tie-off configurations. Consequently, it is concluded that dynamic response of the mechanical system under various g-levels and tie off configurations can greatly impact the performance of a connector system subjected to vibration stresses.     

浅析特殊人群的住宅设计

特殊人群住宅的设计要点及对特殊人群住宅建设的几点建议。     

高能超声处理对锡锑包晶合金凝固组织的影响

在锡锑包晶合金的凝固过程中导入高能超声，不仅显著细化α相和β相晶粒组织，同时使具有立方晶体特征的β相组织有明显的球化趋势，消除了密度偏析，分析了高能超声细化凝固组织的机理。     

弹簧钢棒线材质量投诉的分析研究

为分析研究某特钢厂用户投诉的原因及存在的问题，统计了其两年间的弹簧钢棒线材用户质量投诉，从缺陷类型及生产过程控制进行了分析，重点对多起断裂原因不明的投诉进行了深入的失效研究。结果表明，弹簧钢生产厂在设备工艺、过程控制和管理中存在很多不足，加上用户的使用工艺、材料的内外质量和规格等综合因素导致了材料的断裂失效。     

Effects of passive tilt and submaximal exercise on spectral heart rate variability in ventricular fibrillation patients without significant structural heart disease

It has been shown that tilt and exercise elicit significant changes in autonomic activity in normal subjects and that submaximal exercise causes a greater reduction in heart rate variability (HRV) in animals susceptible to ventricular fibrillation (VF). Whether there is an abnormal HRV response to tilt and exercise in patients at risk of sudden cardiac death (SCD) remains unknown. Short-term HRV before and during passive tilt and exercise was studied in 12 survivors of out-of-hospital cardiac arrest with documented VF and compared with 12 age- and sex-matched normal controls. No patient had significant structural heart disease or left ventricular dysfunction. HRV was computed as total-frequency (TF, 0.01 to 1.00 Hz), low-frequency (LF, 0.04 to 0.15 Hz) and high-frequency (HF, 0.15 to 0.40 Hz) components. There was no significant difference between normal controls and SCD survivors in HRV before or during tilt or submaximal exercise testing. The HF component was significantly decreased during tilt compared with that in the supine position in both normal controls (5.85 +/- 0.61 vs 5.08 +/- 0.95 In(msec2), p = 0.005) and patients (5.58 +/- 1.49 versus 4.74 +/- 1.18 In(msec2), p = 0.003). There was again no significant change in the TF or LF components during tilt in either patients or controls. All frequency components were significantly decreased during submaximal exercise testing in both patients and controls. However, there was no significant difference in any of these tilt- and exercise-induced changes in HRV between normal controls and SCD survivors.(ABSTRACT TRUNCATED AT 250 WORDS)     

压力传感器静态检定装置的测量不确定度

本文根据压力传感器（静态）国家计量检定规程，对压力传感器静态检定装置进行误差分析，得出该装置的测量不确定度。最后，通过实例说明实际测量不确定度与理论分析相符合。     

利用氧化铁皮烧结矿做炼钢氧化剂的探讨

用氧化铁皮研制烧结放代替铁矿石做炼钢氧化剂经试验表明，其理化性能均优于铁矿石，可替代铁矿石作为炼钢的氧化剂。氧化铁皮的开发利用，综合效益显著。     

血管数字减影图象中的结构特征提取

基于Ｘ线数字减影图象的三维血管结构重建很大程度上依赖于图象中血管的有效检测和结构关系描述。本文给出一个在局部特征检测基础上的结构特征提取和组织方法，涉及结构分析之前的中间视觉处理层次，即将图象中主要结构分离出来供结构分析之用。首先用一个突出结构检测算法独立地组织和选择中轴曲线片断和边缘曲线片断，然后将两者信号相结合以验证突出结构算法获得的结果并滤除噪声结构。     

太阳能热水器内表面电刷镀锌

用电刷镀的方法,对尺寸为2000mm×1000mm×0.8mm 的 A_3钢板电刷镀锌保护层;并对影响镀锌层质量的因素进行了充分的研究。     

双迭片弯曲压电陶瓷换能器及振动模态分析测量

介绍了双迭片弯曲压电陶瓷换能器的制作及边缘固定金属压电陶瓷双迭片弯曲振动，并利用有限元分析了换能器的谐振模式，采用激光多普勒干涉仪对换能器的谐振特性以及振动速度和位移分布进行了测量和分析，结果表明：换能器空载性能良好，通过有限元分析与先进测量手段的结合，能够对换能器器件的制作与分析进行指导。