Inhibiting and deactivating effects of water on the selective catalytic reduction of nitric oxide with ammonia over MnOx/Al2O3

The effect of water on the selective catalytic reduction (SCR) of nitric oxide with ammonia over alumina supported with 2–15 wt.-% manganese oxide was investigated in the temperature range 385–600 K, with the emphasis on the low side of this temperature window. Studies on the effect of 1–5 vol.-% water vapour on the SCR reaction rate and selectivity were combined with TPD experiments to reveal the influence of water on the adsorption of the single SCR reactants. It turned out that the activity decrease due to water addition can be divided into a reversible inhibition and an irreversible deactivation. Inhibition is caused by molecular adsorption of water. TPD studies showed that water can adsorb competitively with both ammonia and nitric oxide. Additional kinetic experiments revealed that adsorbed ammonia is present in excess on the catalyst surface, even in the presence of water. Reduced nitric oxide adsorption is responsible for the observed reversible decrease in the reaction rate; the fractional reaction order changes from 0.79 in the absence of water to 1.07 in its presence. Deactivation is probably due to the dissociative adsorption of water, resulting in the formation of additional surface hydroxyls. As the amount of surface hydroxyls formed is limited to a saturation level, the deactivating effect on the catalyst is limited too. The additional hydroxyls condense and desorb in the temperature range 525–775 K, resulting in a lower degree of deactivation at higher temperature. A high temperature treatment at 775 K results in a complete regeneration. The amount of surface hydroxyls formed per unit surface area decreases at increasing MnO_x-loading. The selectivity to the production of nitrogen is enhanced significantly by the presence of gas phase water.     

Temperature effects on the mass flow rate in the SBI and similar heat‐release rate test equipment

In various medium‐to‐large‐scale fire test equipments like the ISO room corner test (RC), and more recently, the single burning item test (SBI) the mass flow rate measurement of the combustion gases plays a key role in the determination of the heat‐release rate and smoke‐production rate. With the knowledge of the velocity profile and the temperature of the flow, the mass flow rate is obtained by measuring the velocity on the axis of the duct. This is done by means of a bi‐directional probe based on the pitot principle. However, due to the variation of the mean temperature and the temperature gradient in any cross section of the duct, introduced by ever changing combustion gas temperatures, the velocity nor the density profile are constant in time. This paper examines the resulting uncertainty on the mass flow rate. Copyright © 2006 John Wiley & Sons, Ltd.     

Detection of failure sites by focused ion beam and nano-probing in the interconnect of three-dimensional stacked circuit structures

Focused ion beam (FIB) and nano-probing were applied for failure analysis of three-dimensional stacked circuits with copper through-silicon-vias between the stacked chips. The failure analysis was done after high temperature storage and thermal cycling tests. Passive voltage contrast in FIB allowed to pinpoint the open sites. FIB cross-sections showed the presence of opens at the bottom of the copper vias. The failure cause was suspected to be an interlayer particle, which was confirmed by optical profilometry. Nano-probing was used on another sample to pinpoint the failure location through the measurement of the local resistance within the daisy chains. The failure was traced out to be related with surface contamination.     

Solubility of actinide surrogates in nuclear glasses

This paper discusses the results of a study of actinide surrogates in a nuclear borosilicate glass to understand the effect of processing conditions (temperature and oxidizing versus reducing conditions) on the solubility limits of these elements. The incorporation of cerium oxide, hafnium oxide, and neodymium oxide in this borosilicate glass was investigated. Cerium is a possible surrogate for tetravalent and trivalent actinides, hafnium for tetravalent actinides, and neodymium for trivalent actinides. The material homogeneity was studied by optical, scanning electron microscopy. Cerium L_III XANES spectroscopy showed that the Ce³⁺/Ce_total ratio increased from about 0.5 to 0.9 as the processing temperature increased from 1100 to 1400 °C. Cerium L_III XANES spectroscopy also confirmed that the increased Ce solubility in glasses melted under reducing conditions was due to complete reduction of all the cerium in the glass. The most significant results pointed out in the current study are that the solubility limits of the actinide surrogates increases with the processing temperature and that Ce³⁺ is shown to be more soluble than Ce⁴⁺ in this borosilicate glass.     

The influence of packaging materials on RF performance

At frequencies beyond 1 GHz, every component of the IC package contributes to the RF performance, whether required or not. In this work, we study the effects of packaging materials namely, the substrate and the globtop/underfill material on RF performance. We have measured interconnects on two area-array CSPs, the ball grid array and the polymer stud grid array using IMEC’s MCM-D technology. The measurements on the package interconnect show that the losses in the package substrate material account for about 50% of the total losses at 1.8 GHz and this drops to less than 20% at 5.2 GHz. The losses due to impedance mismatch dominate the losses especially below 10 GHz and considerable improvement in performance cannot be obtained by using an improved/expensive substrate. The other study is about the influence of globtop/underfill materials on wirebonds (through 3D EM simulations) as well as on standard 50 Ω MCM-D transmission lines (through experiments). While a higher value of dielectric constant of the globtop/underfill material is better on wirebonds, the influence of loss tangent is felt only above values of 0.1. The influence of seven different globtop/undefill materials on 50 Ω transmission lines has been used to extract their dielectric constant and loss tangent values at 30 GHz. These results are very valuable since one can hardly find the properties of globtop/underfill materials beyond 1 GHz.     

Pseudorandomness of Basic Structures in the Block Cipher KASUMI

The notion of pseudorandomness is the theoretical foundation on which to consider the soundness of a basic structure used in some block ciphers. We examine the pseudorandomness of the block cipher KASUMI, which will be used in the next‐generation cellular phones. First, we prove that the four‐round unbalanced MISTY‐type transformation is pseudorandom in order to illustrate the pseudorandomness of the inside round function FI of KASUMI under an adaptive distinguisher model. Second, we show that the three‐round KASUMI‐like structure is not pseudorandom but the four‐round KASUMI‐like structure is pseudorandom under a non‐adaptive distinguisher model.     

Mesomorphism of Lanthanide(Ⅲ) 4-Hexyloxybenzoates

The 4-alkoxybenzoic acids are well-known liquid crystals showing several mesophases(nematic,smectic C phase or both)depending on the alkoxy chain length and whereby the rigid core of the mesogen is formed by intermolecular hydrogen bonds.In this paper it is shown that the thermal behaviour of lanthanide salts of 4-hexyloxybenzoic acids depends on the lanthanide ion(Ln=La,Pr,Nd,Sm,Eu).The lanthanum(Ⅲ)and praseodymium(Ⅲ)4-hexyloxybenzoates exhibit a smectic A mesophase.No mesophase is found for the corresponding compounds of heavier lanthanides.The thermal properties of the lanthanide(Ⅲ)4-hexyloxybenzoates were investigated by differential scanning calorimetry(DSC),polarising thermo-optical microscopy and synchrotron X-ray radiation.     

DBS电视接收机低中频与直接转换调谐器的比较

CMOS技术是把L波段卫星调谐器、解调器和其它功能整合至低成本、高效能单芯片的关键。本文将探讨新型低中频和传统零中频DBS调谐器架构在单芯片DBS射频前端设计中的优缺点。     

The effect of an antiphlogistic incorporated in liposomes on experimentally induced inflammation

The antiphlogistic Ibuprofen incorporated in liposomes caused a decrease of the inflammatory edema induced by Carrageenan in the distal part of the rat's hind leg after both the intramuscular and percutaneous administration. The antiphlogistic effect of free Ibuprofen in the cream was weaker. Intramuscular administration of empty liposomes slowed down in the initial stages the development of inflammation and slightly diminished the size of edema.