Subunit exchange of lens alpha-crystallin: a fluorescence energy transfer study with the fluorescent labeled alphaA-crystallin mutant W9F as a probe

A chemical study of the common Caribbean sea plume Pseudopterogorgia acerosa from Puerto Rico has produced two previously undescribed secondary metabolites. One of them, 1, is a new representative of the pseudopterane family of diterpenes possessing the uncommon 3,4;5,6 diepoxyfuran moiety. The other metabolite, 2, is a rare norcembranolide diterpene. Their chemical structures, including relative stereochemistry, were established by detailed analysis of the spectral data in addition to NMR spectral comparisons with known pseudopterane and cembrane models.     

RF electro-thermal modeling of LDMOSFETs for power-amplifier design

A new approach for the electro-thermal modeling of LDMOSFETs for power-amplifier design that bypasses pulsed-IVs and pulsed-RF measurements is presented in this paper. The existence of low-frequency dispersion in LDMOSFETs is demonstrated by comparing pulsed IVs with iso-thermal IVs. The modeling technique uses iso-thermal IV and microwave measurements to obtain the temperature dependence of small-signal parameters. Optimized tensor-product B-splines, which distribute knots to minimize fitting errors, are used to represent the small-signal parameters and extract the large-signal model as a function of voltages and temperature. The model is implemented on ADS and is verified by simulating and measuring the power harmonics and IMD large-signal performance of a power amplifier. The impact on the model of temperature-dependent drain and gate charge is investigated. The presented model is found to compare well and, in some cases, exceed the existing MET model for LDMOSFETs     

RADIATION EFFECT ON BIOSYNTHESES OF ASCORBIC ACID AND RIBOFLAVIN IN GERMINATING CHICKPEA

The influence of irradiation on biosyntheses of ascorbic acid and riboflavin in germinating chickpea seeds at ambient (25-35℃) conditions, was investigated. The rate of syntheses of these vitamins significantly increased with increasing germination time upto 120 h depending upon the treatment (P<0.05). Maximum amounts of ascorbic acid, 22.32 and 16.84 mg/100g, were found in the 0.10 kGy sample after 120 h of germination in tap and distilled water respectively. However, a radiation dose of 0.15 kGy resulted in the development of maximum values of riboflavin, 11.40 and 11.38 μ g/g, on germination in tap and distilled water respectively. A significant linear relation (r = 0-954 to 0.997) was observed between the biosyntheses of these vitamins and the germination time upto 120 h of irradiated and unirradiated chickpea seed (P<0.05).     

TSAT is a better predictor than ferritin of hemoglobin response to Epoetin alfa in US dialysis patients

Clinical guidelines recommend concurrent treatment of anemia in end‐stage renal disease with erythropoiesis‐stimulating agents (ESAs) and iron. However, there are mixed data about optimal iron supplementation. To help address this gap, the relationship between iron markers and hemoglobin (Hb) response to ESA (Epoetin alfa) dose was examined. Electronic medical records of 1902 US chronic hemodialysis patients were analyzed over a 12‐month period between June 2009 and June 2010. The analysis included patients who had at least one Hb value during each 4‐week interval for four consecutive intervals (k ? 2, k ? 1, k, and k + 1; k is the index interval), received at least one ESA dose during intervals k ? 1 or k, had at least one transferrin saturation (TSAT) value at interval k, and at least one ferritin value during intervals k ? 2, k ? 1, or k. Effect modification by TSAT and ferritin on Hb response was evaluated using the generalized estimating equations approach. Patients had a mean (standard deviation) age of 62 (15) years; 41% were Caucasian, 34% African American, 65% had hypertension, and 39% diabetes. Transferrin saturation, but not ferritin, had a statistically significant (P < 0.05) modifying effect on Hb response. Maximum Hb response was achieved when TSAT was 34%, with minimal incremental effect beyond these levels. Of the two standard clinical iron markers, TSAT should be used as the primary marker of the modifying effect of iron on Hb response to ESA. Long‐term safety of iron use to improve Hb response to ESA warrants further study.     

Self‐Assembly of Ferromagnetic Organic–Inorganic Perovskite‐Like Films

Perovskite‐based organic–inorganic hybrids hold great potential as active layers in electronics or optoelectronics or as components of biosensors. However, many of these applications require thin films grown with good control over structure and thickness—a major challenge that needs to be addressed. The work presented here is an effort towards this goal and concerns the layer‐by‐layer deposition at ambient conditions of ferromagnetic organic–inorganic hybrids consisting of alternating CuCl₄‐octahedra and organic layers. The Langmuir‐Blodgett technique used to assemble these structures provides intrinsic control over the molecular organization and film thickness down to the molecular level. Magnetic characterization reveals that the coercive field for these thin films is larger than that for solution‐grown layered bulk crystals. The strategy presented here suggests a promising cost effective route to facilitate the excellently controlled growth of sophisticated materials on a wide variety of substrates that have properties relevant for the high density storage media and spintronic devices.     

部件运送系统的设计及其在微成形领域中的应用(英文)

当前对微成形的研究主要集中在基础理论以及实验过程上,而忽略了某些和实际生产相关的关键问题。例如,一个微成形机,如果没有与之相匹配的合适的部件传送系统,就难于满足工业化生产的要求,而且很不切实际。连续的生产过程需要的不仅仅是高效率的生产设备本身,还需要与其效率和生产过程同步的材料/部件运送系统。这一系统的功能应该包括自动将成品/零件运送出成形环境并打包以便运输。文章提出了一种微型冲压成品/零件的运送策略,工作主要集中在运送设备及整个系统的研究以及设计考虑,并已应用于英国思特莱斯克莱德大学研制的一套全新的板材微成形设备上。该系统进给方法的特征以及定位精度采用有限元方法进行分析,现已构建成功,并经过了试验校准。     

DLTS study of annihilation of oxidation induced deep-level defects in Ni/SiO2/n-Si MOS structures

This paper describes the fabrication of MOS capacitor and DLTS study of annihilation of deeplevel defects upon thermal annealing. Ni/SiO₂/n-Si MOS structures fabricated on n-type Si wafers were investigated for process-induced deep-level defects. The deep-level traps in Si substrates induced during the processing of Ni/SiO₂/n-Si have been investigated using deep-level transient spectroscopy (DLTS). A characteristic deep-level defect at E _C = 0·49 eV which was introduced during high-temperature thermal oxidation process was detected. The trap position was found to shift to different energy levels (E _C = 0·43, 0·46 and 0·34 eV) during thermal annealing process. The deep-level trap completely anneals at 350°C. Significant reduction in trap density with an increase in recombination life time and substrate doping concentration as a function of isochronal annealing were observed.     

Radiological hazards of TENORM in precipitated calcium carbonate generated as waste at nitrophosphate fertilizer plant in Pakistan

The NORM (naturally occurring radioactive material) in phosphate rock is transferred as TENORM (technologically enhanced naturally occurring radioactive material) to phosphatic fertilizers and to the waste generated by the chemical processes. The waste generated at the NP (nitrophosphate) fertilizer plant at Multan in Pakistan is PCC (precipitated calcium carbonate). Thirty samples of the PCC were collected from the heaps of the waste near the fertilizer plant. Activity concentrations of radionuclides in the waste samples were measured by using the technique of gamma ray spectrometry consisting of coaxial type HPGe (high purity germanium) detector coupled with a PC (personal computer) based MCA (multichannel analyzer) through a spectroscopy amplifier. Activity concentrations of ²²⁶Ra, ²³²Th and ⁴⁰K in the waste samples were determined to be 273 ± 23 (173-398), 32 ± 4 (26-39) and 56 ± 5 (46-66) Bq kg⁻¹ respectively. The activity concentration of ²²⁶Ra in the PCC waste was found to be higher than that in naturally occurring calcium carbonate (limestone and marble) and in worldwide soil. Radiological hazard was estimated from indoor and outdoor exposure to gamma rays from the PCC. Indoor annual effective dose was higher than 1 m Sv. Potential radiological pollution in the environment from TENORM in the PCC has also been addressed.     

Family B DNA polymerase from a hyperthermophilic archaeon Pyrobaculum calidifontis: cloning, characterization and PCR application

The 2352 bp gene coding for 783 amino acid family B DNA polymerase from Pyrobaculum calidifontis was cloned and expressed in Escherichia coli. Expression of the gene resulted in the production of Pca-Pol in soluble fraction. After heat denaturation of the host proteins, the Pca-Pol was further purified by ion exchange and hydrophobic interaction chromatographies. Activity gel analysis showed the presence of a catalytically active polypeptide of about 90 kDa. The mass of the protein, determined by Matrix-Assisted Laser Desorption/Ionization-Time of Flight Mass Spectrometry was found to be 89,156 Da. The isoelectric point of the enzyme was found to be 6.13. The optimal pH and magnesium ion concentration for the enzyme activity were 8.5 and 4mM, respectively. Unlike other commercially available DNA polymerases the enzyme activity of Pca-Pol was inhibited by monovalent cations such as ammonium and potassium. The half-life of the polymerase at 95 °C and 100 °C was 4.5h and 0.5h, respectively. The enzyme possessed 3'→5' exonuclease activity and was able to amplify, under suitable conditions, up to 7.5 kb DNA fragments by polymerase chain reaction which makes it a potential candidate for amplification of long DNA fragments.     

The influence of substrate temperature on the structural and optical properties of ZnS thin films

Thin films of ZnS were deposited on soda lime glass substrates by a modified close-space sublimation technique. The change in optical and structural properties of the films deposited at various substrate temperatures (150–450°C) was investigated. X-ray diffraction spectra showed that films were polycrystalline in nature having cubic structure oriented only along (111) plan. The crystallinity of films increased with the substrate temperature up to 250°C. However, crystallinity decreased with further increase of substrate temperature and films became amorphous at 450°C. The atomic force microscopy data revealed that the films become more uniform and dense with the increase of substrate temperature. Optical properties of the films were determined from the transmittance data using Swanepoel model. It was observed that the energy band gap is increased from 3.52 to 3.65 eV and refractive index of the films are decreased with the increase of substrate temperature. Moreover, considerable improvement in blue response of the films was noticed with increasing substrate temperature.