Catalytic Combustion of Model Carbon Particles (CPs) over Pt/β-SiC Catalyst

Platinum catalyst supported on a medium surface area -SiC was successfully used for the catalytic combustion of model carbon particles and compared to a catalyst supported on a low surface area -SiC. The -SiC-based catalyst showed no deactivation as a function of cycling tests while a strong deactivation was observed on the -SiC-based catalyst. This deactivation was attributed to the progressive encapsulation of the platinum particles by a layer of silica which built up during the combustion cycle. These results render possible the use of Pt/-SiC catalyst as a diesel carbon particle catalytic filter with continuous regeneration.     

Micro cam system driven by electrostatic comb-drive actuators based on SOI-MEMS technology

Microsystem Technologies - This paper reports a design and fabrication process of a micro cam system (MCS) with a flat-faced translating follower. The cam rim with cover diameter of 2.4 mm...     

A printed circuit board capacitive sensor for air bubble inside fluidic flow detection

This paper presents a three-electrode capacitive fluidic sensor for detecting an air bubble inside a fluidic channel such as blood vessels, oil or medical liquid channels. The capacitor is designed and fabricated based on a printed circuit board (PCB). The electrodes are fabricated by using copper via structure through top to bottom surface of the PCB. A plastic pipe is layout through the capacitive sensor and perpendicular to the PCB surface. Capacitance of sensor changes when an air bubble inside fluidic flow cross the sensor. The capacitance change can be monitored by using a differential capacitive amplifier, a lock-in amplifier, filter and an NI acquisition card. Signal is processed and calculated on a computer. Air bubble inside the liquid flow are detected by monitor the unbalance signal between the three electrode potential voltages. Output voltage depends on the volume of the air bubble due to dielectric change between capacitor’s electrodes. Output voltage is up to 53 mV when an 2.28 mm³ air bubble crosses the sensing channel. Air bubble velocity can be estimated based on the output pulse signal. This proposed fluidic sensor can be used for void fraction detection in medical devices and systems; fluidic characterization; and water–gas, oil–water and oil–water–gas multiphase flows in petroleum technology. That structure also can apply to the micro-size for detecting in microfluidic to monitor and control changes in microfluidic channels.     

Picture-Neutrosophic Trusted Safe Semi-Supervised Fuzzy Clustering for Noisy Data

Clustering is a crucial method for deciphering data structure and producing new information. Due to its significance in revealing fundamental connections between the human brain and events, it is essential to utilize clustering for cognitive research. Dealing with noisy data caused by inaccurate synthesis from several sources or misleading data production processes is one of the most intriguing clustering difficulties. Noisy data can lead to incorrect object recognition and inference. This research aims to innovate a novel clustering approach, named Picture-Neutrosophic Trusted Safe Semi-Supervised Fuzzy Clustering (PNTS3FCM), to solve the clustering problem with noisy data using neutral and refusal degrees in the definition of Picture Fuzzy Set (PFS) and Neutrosophic Set (NS). Our contribution is to propose a new optimization model with four essential components: clustering, outlier removal, safe semi-supervised fuzzy clustering and partitioning with labeled and unlabeled data. The effectiveness and flexibility of the proposed technique are estimated and compared with the state-of-art methods, standard Picture fuzzy clustering (FC-PFS) and Confidence-weighted safe semi-supervised clustering (CS3FCM) on benchmark UCI datasets. The experimental results show that our method is better at least 10/15 datasets than the compared methods in terms of clustering quality and computational time.     

Applying Wide & Deep Learning Model for Android Malware Classification

Android malware has exploded in popularity in recent years, due to the platform’s dominance of the mobile market. With the advancement of deep learning technology, numerous deep learning-based works have been proposed for the classification of Android malware. Deep learning technology is designed to handle a large amount of raw and continuous data, such as image content data. However, it is incompatible with discrete features, i.e., features gathered from multiple sources. Furthermore, if the feature set is already well-extracted and sparsely distributed, this technology is less effective than traditional machine learning. On the other hand, a wide learning model can expand the feature set to enhance the classification accuracy. To maximize the benefits of both methods, this study proposes combining the components of deep learning based on multi-branch CNNs (Convolutional Network Neural) with wide learning method. The feature set is evaluated and dynamically partitioned according to its meaning and generalizability to subsets when used as input to the model’s wide or deep component. The proposed model, partition, and feature set quality are all evaluated using the K-fold cross validation method on a composite dataset with three types of features: API, permission, and raw image. The accuracy with Wide and Deep CNN (WDCNN) model is 98.64%, improved by 1.38% compared to RNN (Recurrent Neural Network) model.     

Short packet communication in underlay cognitive network assisted by an intelligent reflecting surface

We propose short packet communication in an underlay cognitive radio network assisted by an intelligent reflecting surface (IRS) composed of multiple reconfigurable reflectors. This scheme, called the IRS protocol, operates in only one time slot (TS) using the IRS. The IRS adjusts its phases to give zero received cumulative phase at the secondary destination, thereby enhancing the end-to-end signal-to-noise ratio. The transmitting power of the secondary source is optimized to simultaneously satisfy the multi-interference constraints, hardware limitations, and performance improvement. Simulation and analysis results of the average block error rates (BLERs) show that the performance can be enhanced by installing more reconfigurable reflectors, increasing the blocklength, lowering the number of required primary receivers, or sending fewer information bits. Moreover, the proposed IRS protocol always outperforms underlay relaying protocols using two TSs for data transmission, and achieves the best average BLER at identical transmission distances between the secondary source and secondary destination. The theoretical analyses are confirmed by Monte Carlo simulations.     

Stock-Price Forecasting Based on XGBoost and LSTM

Using time-series data analysis for stock-price forecasting (SPF) is complex and challenging because many factors can influence stock prices (e.g., inflation, seasonality, economic policy, societal behaviors). Such factors can be analyzed over time for SPF. Machine learning and deep learning have been shown to obtain better forecasts of stock prices than traditional approaches. This study, therefore, proposed a method to enhance the performance of an SPF system based on advanced machine learning and deep learning approaches. First, we applied extreme gradient boosting as a feature-selection technique to extract important features from high-dimensional time-series data and remove redundant features. Then, we fed selected features into a deep long short-term memory (LSTM) network to forecast stock prices. The deep LSTM network was used to reflect the temporal nature of the input time series and fully exploit future contextual information. The complex structure enables this network to capture more stochasticity within the stock price. The method does not change when applied to stock data or Forex data. Experimental results based on a Forex dataset covering 2008–2018 showed that our approach outperformed the baseline autoregressive integrated moving average approach with regard to mean absolute error, mean squared error, and root-mean-square error.     

Visualization of diversity in large multivariate data sets

Understanding the diversity of a set of multivariate objects is an important problem in many domains, including ecology, college admissions, investing, machine learning, and others. However, to date, very little work has been done to help users achieve this kind of understanding. Visual representation is especially appealing for this task because it offers the potential to allow users to efficiently observe the objects of interest in a direct and holistic way. Thus, in this paper, we attempt to formalize the problem of visualizing the diversity of a large (more than 1000 objects), multivariate (more than 5 attributes) data set as one worth deeper investigation by the information visualization community. In doing so, we contribute a precise definition of diversity, a set of requirements for diversity visualizations based on this definition, and a formal user study design intended to evaluate the capacity of a visual representation for communicating diversity information. Our primary contribution, however, is a visual representation, called the Diversity Map, for visualizing diversity. An evaluation of the Diversity Map using our study design shows that users can judge elements of diversity consistently and as or more accurately than when using the only other representation specifically designed to visualize diversity.     

Recognition and analysis of cell nuclear phases for high-content screening based on morphological features

Automated analysis of molecular images has increasingly become an important research in computational life science. In this paper some new and efficient algorithms for recognizing and analyzing cell phases of high-content screening are presented. The conceptual frameworks are based on the morphological features of cell nuclei. The useful preprocessing includes: smooth following and linearization; extraction of morphological structural points; shape recognition based morphological structure; issue of touching cells for cell separation and reconstruction. Furthermore, the novel detecting and analyzing strategies of feed-forward and feed-back of cell phases are proposed based on gray feature, cell shape, geometrical features and difference information of corresponding neighbor frames. Experiment results tested the efficiency of the new method.