关于天然气水合物钻采工艺技术进展的研究

目前全球正面临着前所未有的能源危机，天然气水合物由于储量大、能量密度高而将成为一种诱人的新型能源。天然气水合物主要存在于冻土带和海洋，在地下处于低温和高压状态，以现有的技术，钻井和开采都存在很大的困难。简要介绍了天然气水合物的性质及储量，阐述了天然气水合物钻井的六个挑战及目前国外天然气水合物的两种钻探方法；同时阐述了以热力法、降压法和化学试剂注入法为主的天然气水合物开采方法，并针对天然气水合物钻采技术现状指出了下一步的研究方向。     

球罐自动焊应用现状及其焊缝跟踪技术研究

球罐制造是以焊接为主要加工手段的一个复杂的系统工程,涉及到多门学科理论和技术领域。基于球罐制造过程的特殊性,综述了球罐自动化焊接技术的发展概况和应用现状,从工程应用发展角度出发,分析了球罐自动焊接过程中焊缝跟踪技术的研究进展和应用前景。     

Degree-of-polarization and eye-closure penalty associated with optical signals with orthogonal polarizations

We perform a systematic measurement of the degree-of-polarization (DOP) and eye-closure penalty for optical signals with orthogonal polarizations. We find that the symmetry of DOP is maintained for the orthogonal polarizations under both first and higher order polarization-mode dispersion (PMD), whereas the symmetry of eye-closure penalty is broken under second-order PMD. An orthogonal polarization pair can have large disparity of eye-closure penalty despite an identical DOP. We also demonstrate a novel approach to estimate the maximum eye-closure penalty asymmetry with three orthogonal polarizations on the Poincare/spl acute/ sphere.     

机载高分辨力SAR实时运动补偿的实现

本文详细地分析了载机运动误差与回波相位的关系,提出了基于G4DSP信号处理板的机载SAR实时运动补偿方法,该方法利用G4DSP的四个CPU构成流水线处理器,采用子孔径方法分段提取回波的多普勒调频斜率,然后利用调频斜率的变化计算载机的运动误差,通过相位误差函数与方位数据的时域相乘补偿运动误差。实时信号处理机的实验表明,本文方法能实时和有效的实现机载SAR运动补偿,获得满意的成像质量。     

地震勘探测量数据处理的全面解决方案

本文针对近年来地震勘探技术的发展对测量工作提出的新要求，分析了SSOffiee软件解决问题的方案和技术特色，最后提出了SSOffice软件的发展方向。     

周宁水电站工程项目管理实践

福建周宁水电站工程由闽东水电开发有限公司负责项目管理。该项目严格按照《招投标法》进行工程和设备的招标,进行了多项设计优化,注重工程质量和安全文明生产,积极开展达标投产工作,实现了进度快、质量优、投资省、效益好的管理目标。     

On the Feasibility of Growing Pb[(Zn1/3Nb2/3)0.91Ti0.09]O3 Single Crystals

Pb[(Zn_1/3Nb_2/3)_0.91Ti_0.09]O₃ (PZNT91/9) single crystals were grown by two methods: from solution using PbO as a self‐fluxing agent (SC method) and directly from the melt without fluxing (MC method). In both growth methods, an allomeric Pb[(Mg_1/3‐Nb_2/3)_0.69Ti_0.31]O₃ (PMNT69/31) single crystal was used as a seed. X‐ray diffraction patterns of ground crystals showed that phase‐pure perovskite PZNT91/9 single crystals were successfully fabricated by the above two methods. The composition of the crystals obtained by both the SC and MC methods was analyzed using X‐ray fluorescence, which confirmed that the crystal composition is close to the nominal value, although volatilization of PbO and segregation during crystal growth are inevitable. The MC PZNT91/9 crystals exhibit excellent piezoelectric properties, with the piezoelectric constant, d₃₃, in the range of 1800–2200 pC N^–1. This value is comparable to that of the SC crystals. However, the MC crystals show an abnormal dielectric behavior. In contrast with the SC crystals, in the MC crystals a much broader dielectric peak appears in the dielectric response curves, accompanied by a much lower peak temperature of around 105 °C. Furthermore, frequency dispersion is apparent over a much wider temperature range (even more apparent than in pure relaxors), where a large, i.e., about 70 °C, full width at half maximum (FWHM) for the dielectric peaks is observed in the dielectric response. It is speculated that such an unusual phenomenon correlates with defects, microinhomogeneities, and polar regions in the as‐grown MC crystals. The origins of this abnormality have not been interpreted in detail until now. However, optical observation of the domain structure confirms that both the SC and MC crystals possess complex structural states.     

A decision support system for interactive decision making - Part II: analysis and output interpretation

For pt.I see ibid., p.42-55 (2003). The development of a comprehensive decision support system, GMCR II, for the systematic study of real-world interactive decision problems is presented. The companion paper (Part I), discusses how GMCR II elicits, stores, and manages conflict models; here (Part II), the focus is on GMCR IIs analysis and output interpretation subsystems. Specifically, this paper describes the powerful and efficient analysis engine contained in GMCR II, its informative output presentation and interpretation facilities, and a number of follow-up analyses. Furthermore, an illustrative case study is used to demonstrate how GMCR II can be conveniently applied in practice.     

Wavelength and Waveband Assignment for Ring Networks Based on Parallel Multi‐granularity Hierarchical OADMs

In this paper we study the optimization issues of ring networks employing novel parallel multi‐granularity hierarchical optical add‐drop multiplexers (OADMs). In particular, we attempt to minimize the number of control elements for the off‐line case. We present an integer linear programming formulation to obtain the lower bound in optimization, and propose an efficient heuristic algorithm called global bandwidth resource assignment that is suitable for the design of large‐scale OADM networks.     

数字线性调频源设计

简要介绍了线性调频信号产生技术的现状,详细介绍了直接数字频率合成(DDS)的基本原理。给出了高性能DDS芯片AD9858的主要特点和配置方法,同时以图形方式给出了基于AD9858芯片硬件结构及互连方法,以及控制DDS芯片的VHDL语言工作波形图,描述了输出线性调频信号的控制流程。