Transparent zero-birefringence copolymer and its optical properties

Birefringence is caused by both orientation of polymer chains and photoelasticity. These birefringences were compensated by random copolymerization of negative birefringent methyl methacrylate and positive birefringent benzyl methacrylate, but orientational and photoelastic zero birefringences were achieved with quite different compositions of the copolymers. Note that the birefringence of the copolymer that occurred in the process of injection molding was almost completely eliminated with a composition for orientational zero birefringence. The orientational and photoelastic zero-birefringence copolymers possessed enough transparency as optical materials that the total scattering losses were 30.4 and 19.5 dB/km, respectively, competing with the transparency of homopolymers.     

Fundamental and clinical evaluation of cefozopran in low birth weight infants and neonates

We conducted fundamental and clinical evaluations of a cephem antibiotic, cefozopran (SCE-2787, CZOP), in infants with low birth weights and mature infants. (1) Blood concentrations CZOP was intravenously given in bolus dose of 20 mg/kg to the newborn. The blood antibiotic concentrations were 69.7 micrograms/ml at 30 minutes after administration and the elimination half life was 2.99 hours in mature infants aged 1 to 3 days. They were 38.7 micrograms/ml and 2.85 hours in those aged 4 to 7 days, and 40.8 micrograms/ml and 3.81 hours in those aged 8 days or elder, respectively. In infants with lower birth weights aged 4 to 7 days the blood antibiotic concentrations were 48.6 micrograms/ml at 30 minutes after i.v. administration and the elimination half life was 3.77 hours. The blood antibiotic concentrations at 30 minutes after intravenous doses of 10, 20 and 50 mg/kg in mature infants aged 8 days or elder were 21.1, 40.8 and 153.6 micrograms/ml (value at 60 minutes) and the elimination half lives were 2.24, 3.81 and 3.07 hours, respectively. Administration of CZOP at doses of 20 and 40 mg/kg by intravenous drip infusion over 30 minutes gave the blood drug concentrations of 48.0 and 103.2 micrograms/ml at the end of the infusion and the half lives were 2.60 and 3.33 hours, respectively. (2) Urinary excretion The urinary excretion rates after i.v. bolus doses of 10, 20 and 40 mg/kg were 28.4 to 58.6% of dose. The urinary excretion rate after i.v. drip infusion of 40 mg/kg over 30 minutes was 49.0% of dose. (3) Transfer into cereblospinal fluid The transfer of the antibiotic into cereblospinal fluid in patients with serous meningitis was 4.1 to 15.5 micrograms/ml at 1 hours after administration. (4) Clinical results The clinical efficacy was judged "good" or "excellent" in 2 of the 3 patients with septicemia and in all of the 10 patients with suspected septicemia. It was judged "excellent" in all of the 9 patients with pneumonia, 3 with urinary tract infections and 3 with intrauterine infections. Prophylactic use of the antibiotic was effective in all of the 12 patients. Of the patients in whom bacteriological evaluation was successful, 7 of the 10 causative organisms were confirmed to be eradicated. No adverse drug reactions of signs and symptoms were recognized. Fourteen abnormal alterations of the laboratory test values such as elevation of gamma-GTP and that of GPT were recognized in 8 patients (16.7%). None of them were particularly serious. These results indicate that CZOP is a drug useful for treatment and prevention of infections in infants with lower birth weights as well as in mature infants.     

“<Emphasis Type="Italic">It’s like holding a human heart</Emphasis>”: the design of Vital + Morph,a shape-changing interface for remote monitoring

Based on the concept of data physicalization, we developed Vital + Morph, an interactive surface for remote connection and awareness of clinical data. It enables users located in remote places to monitor and feel the vital signs measured from a hospitalized person through shape-change. We propose shape-changing interfaces as a way of making data physicalization a richer, intriguing and memorable experience that communicates complex information and insights about data. To demonstrate and validate our proposed concept, we developed an exploratory study about the design and its implications. For evaluating the social impact of shape-changing interfaces in the context of remote monitoring, we presented Vital + Morph in several Media Art festivals. We collected and analyzed the feedback from the visitors during the exhibitions, and discussed the possibilities of the proposed system. A preliminary evaluation shows how shape-changing displays are perceived by users, which establishes not only the potential benefits but also highlights the concerns that several users have raised. Through this study, we aim to contribute to the design of remote monitoring systems by providing a novel approach for displaying clinical data that consider the richness of the physical world. In today’s information-driven society, we should not just focus on how abstract data are collected and analyzed, but also on how it can be presented and incorporated into our daily lives.     

Dietary conjugated linolenic acid in relation to CLA differently modifies body fat mass and serum and liver lipid levels in rats

The present study compared the effect of dietary conjugated linolenic acid (CLNA) on body fat and serum and liver lipid levels with that of CLA in rats. FFA rich in linoleic acid, α-linolenic acid, CLA, or CLNA were used as experimental fats. Male Sprague-Dawley rats (4 wk old) were fed purified diets containing 1% of one of these experimental fats. After 4 wk of feeding, adipose tissue weights, serum and liver lipid concentrations, serum tumor necrosis factor (TNF)-α and leptin levels, and hepatic β-oxidation activities were measured. Compared with linoleic acid, CLA and, more potently, CLNA were found to reduce perirenal adipose tissue weight. The same trend was observed in the weight of epididymal adipose tissue. CLNA, but not CLA, was found to significantly increase serum and liver IG concentrations. Serum FFA concentration was also increased in the CLNA group more than in the other groups. The activity of β-oxidation in liver mitochondria and peroxisomes was significantly higher in the CLNA group than in the other groups. Thus, the amount of liver TG exceeded the ability of hepatic β-oxidation. Significant positive correlation was found between the adipose tissue weights and serum leptin levels in all animals (vs. perirenal: r=0.557, P<0.001; vs. epididymal: r=0.405, P<0.05). A less significant correlation was found between adipose tissue weights and serum TNF-α level (vs. perirenal: r=0.069, P<0.1; vs. epididymal: r=0.382, P<0.05). Although the mechanism for the specific effect of CLNA is not clear at present, these findings indicate that in rats CLNA modulated the body fat and TG metabolism differently from CLA.     

Tomakomai Large Scale Crude Oil Fire Experiments

This paper summarizes the results of large-scale crude oil fire experiments conducted in Tomakomai, Japan, in 1998 to obtain information that could be applied to the development of firefighting strategies for, and the design of, huge petroleum storages. Arabian light-equivalent crude oil was burned in pans 5-, 10-, and 20-m in diameter. Most of the experiments were performed under favorable conditions. Measured data include external radiation, infrared image of the flame, flame temperature, gas concentration inside the flame, and other burning characteristics. The height of the strongest radiant emittance was H/D=0.1 to 0.2, where D=pan diameter and H=height from the initial fuel surface, and a kind of fireball appeared occasionally at the intermittant flame zone. Emitted smoke particles were sampled on the ground and observed with a scanning electron micrograph, and the distribution of the diameters of primary smoke particles was examined. The average diameter of primary smoke particles is 53.0 (±10.5)nm. The dependence of burning characteristics and flame structure on pan diameter is discussed. The flame height of the 20-m diameter pan fire is 1.9 (±0.3) D. The burning rate increases as the pan diameters increase, but the radiative fraction decreases as pan diameter increases.     

High-throughput immunophenotyping by surface plasmon resonance imaging

Cell binding assays on antibody arrays permit the rapid immunophenotyping of living cells. The throughput of the analysis, however, is still limited due to our inability to perform parallel and quantitative detection of cells captured on the array. To address this limitation, we employed here an imaging technique based on surface plasmon resonance (SPR). SPR has been frequently used to monitor capture of proteins on antibody microarrays, while few cases were reported for capture of cells. Antibody arrays were prepared through the photopatterning of an alkanethiol monolayer on a gold-evaporated glass plate and the subsequent immobilization of various antibodies onto 4-9 separate spots created by photopatterning. A glass slip was mounted onto the array with a thin spacer to construct a parallel-plate chamber. Leukemia cells were injected into the chamber to conduct a binding assay, while refractive index changes at the vicinity of the array surface were monitored by SPR imaging. We observed that SPR signals were intensified on specific antibody spots but not on nonspecific spots. Confocal laser scanning microscopy revealed that the observed SPR signals were attributed to cell deformations caused by multivalent interactions with immobilized antibody, which effectively elevated the refractive index of a medium phase within an evanescent field. This effect could be suitably utilized to monitor quantitatively cell binding to multiple spots from a heterogeneous cell population.     

Kinetic studies on lipase-catalyzed acetylation of 2-alkanol with vinyl acetate in organic solvent

Lipase-catalyzed acetylation of 2-alkanol with vinyl acetate has been studied kinetically using Burkholderia cepacia lipase (BCL), enantiomerically pure (R)- and (S)-2-alkanols and different organic solvents. The rate equation was derived by the steady state method for the simplified mechanism. The second order rate constants (k(R) and k(S)) for (R)- and (S)-2-alkanols were evaluated from the slopes of the double reciprocal plots, v(-1) vs. [2-alkanol](-1), where v is the initial rate of the reaction. The log k(R) value increased with the solvent hydrophobicity log P, where P is a partition coefficient of a given solvent between octanol and water. The log k(S) value also increased with log P except the bulky solvents such as 1,4-dioxane and cyclohexane, in which the rates were faster than those expected from the log k(S) vs. log P plot. The slope of log k(S) vs. log P plot was larger than that for (R)-2-alkanol. Thus, log E (E=k(R)/k(S): enantioselectivity) decreased with log P except the bulky solvents. The rate constants and the enantioselectivity were different depending on the structure (carbon number CN) of 2-alkanol. The log E vs. CN plot was minimized at CN=8 and 10 and the log k(S) vs. CN plot maximized at CN=8 and 10. In contrast the log k(R) vs. CN plot showed a different feature from the log E vs. CN plot. These facts suggest that dependence of E on CN is more strongly affected by the reactivity of (S)-2-alkanol than that of (R) isomer in this acetylation.     

Effects of arc current and electrode size on electrode erosion in ac plasma torches

Heavy erosion of the electrode is a problem in using ac plasma torches. In a series of our studies, the effects of electrode stem size (diameter and length) and tip shape on the electrode erosion were clarified at a low current of 200 A. In this paper, on the basis of the 200-A data, in order to reduce the electrode erosion with the current increased, the effects of current and electrode size on electrode erosion were clarified experimentally and analytically between 100 and 550 A. The electrode used was of solid type and the material was tungsten containing 2 wt% of lanthanum oxide. The plasma gas was argon. Main results are as follows. (1) As the current increased, the electrode erosion increased linearly. In the case of thin electrodes (8 mm ø), between 450 and 550 A, the electrode tip was molten partially and the electrode erosion increased rapidly over 5 mg/h. However, for thick electrodes (13 mm ø), the electrode erosion did not increase rapidly. (2) The temperature distribution along the electrode axis was calculated. As a result, a good correlation was obtained between the calculated temperature of electrode tip and the measured electrode erosion. As the tip temperature decreased to 3000 K (cf. tungsten melting point: 3660 K), the electrode erosion decreased below 5 mg/h of the linearly increasing range.     

Method for calibrating system parameters of a multidirectional interferometers system

A multidirectional interferometer system has been proposed and developed to measure the position and orientation of a positioning stage. In this method the system parameters, such as positions of the corner-cube reflectors and directions of the rays in the interferometers, must be determined beforehand. However, it is difficult to find ways to determine the system parameters for each different system with necessary accuracy. This paper proposes a systematic method for calibrating the system parameters when the number of the interferometers is larger than the degrees of freedom of the stage. The method is verified for a two-dimensional stage by both simulation and experiment.     

Index characterization of differential–algebraic equations in hybrid analysis for circuit simulation

Modern modeling approaches in circuit simulation naturally lead to differential–algebraic equations (DAEs). The index of a DAE is a measure of the degree of numerical difficulty. In general, the higher the index, the more difficult it is to solve the DAE. The modified nodal analysis (MNA) is known to yield a DAE with index at most two in a wide class of nonlinear time‐varying electric circuits. In this paper, we consider a broader class of analysis method called the hybrid analysis. For linear time‐invariant RLC circuits, we prove that the index of the DAE arising from the hybrid analysis is at most one, and give a structural characterization for the index of a DAE in the hybrid analysis. This yields an efficient algorithm for finding an optimal hybrid analysis in which the index of the DAE to be solved attains zero. Finally, for linear time‐invariant electric circuits that may contain dependent sources, we prove that the optimal hybrid analysis by no means results in a higher index DAE than MNA. Copyright © 2008 John Wiley & Sons, Ltd.