0.25μm CMOS千兆以太网发送器设计

分析了千兆以太网体系结构,给出了符合IEEE 802.3z标准中1000BASE-X规范的发送器电路结构,并采用TSMC 0.25 μm CMOS 混合信号工艺设计了符合该规范的高速复接电路和锁相环时钟倍频电路.芯片核心电路面积分别为(0.3×0.26)mm2和(0.22×0.12)mm2.工作电压2.5 V时,芯片核心电路功耗分别为120 mW和100 mW.时钟倍频电路的10倍频输出时钟信号频率为1.25 GHz,其偏离中心频率1MHz处的单边带相位噪声仅为-109.7 dBc/Hz.在驱动50 Ω输出负载的条件下,1.25 Gbit/s的高速输出数据信号摆幅可达到410 mV.     

Effect of Y2O3, CeO2 on Sintering Properties of Si3N4 Ceramics

The effect of rare earth oxides Y203 or Ce02 on sintering properties of Si3N4 ceramics was studied and the mechanism of assisting action during sintering was analyzed. The results in dicate that the best sintering properties appear in Si3N4 ceramics with 5% Y203 or 8% CeO2. Secondary crystallites are formed at grain boundaries after heat treatment,which decreases the amount of glass phase and contributes to the improvement of high-temperature mechanical properties of silicon nitride.     

高频数字锁相环的研究

论文阐述了１００ＭＨｚ数字锁相环的设计过程，用１０ＭＨｚ晶体振荡器对１００ＭＨｚ数字压控振荡器进行锁相，使１００ＭＨｚ输出信号指标得到很大改善。论文还分析了各单元电路，关键点时域波形测试，频谱测试。     

非电量微机采集系统

实现水电厂电量快速微机巡回检测，温度采集较其它信号更为困难，本文着重讨论温度信号转换及与微机系统的连接。且介绍某水电厂微机控系统中非电量检测装置的硬件结构和软件编制。     

正交双频光栅CCD系统剪切干涉测量二维温度场

以半导体激光器为光源，利用正交双频光栅（ＯＤＦＧ）ＣＣＤ系统剪切干涉对带平板边界的半圆柱体热源的二维温度场进行实时诊断，分析剪切干涉图时，用柱函数系作为拟合基底，给出二维自然对流温度场的定量分布。     

筒体结构连续化模型的弹性动力时程分析

本文用连续化模型对高层筒体结构在地震作用下的动力时程反应进行分析．     

A Progressive Radiosity Algorithm for Scenes Containing Curved Surfaces

Based on the theory of light energy transfer between two differential diffuse surface areas, a generalized radiosity approach is presented. Unlike the conventional radiosity method, curved surfaces are subdivided into triangular surface patches, radiosity is assummed to be vary across each triangular surface patch. By adopting linear interpolation scheme over each triangular surface patch, we have established a complete set of approximated radiosity equations. Their unknowns are radiosities of differential surface areas located at all vertices of surface patches. The generalized radiosity equation has also been extended to non-diffuse environments. Theoretical analysis and experimental results demonstrate the great potential of this method,     

碳纳米管的制备及研究

介绍了在直流电弧放电法制备富勒烯过程中，从阴电极表面收集到大量的碳纳米管及巴基葱，产生率达到５０％，并用电子显微镜对其进行了观察和初步研究。     

结构陶瓷的高温疲劳强度衰减理论

提出了陶瓷材料疲劳强度衰减理论并由此导出了各种疲劳关系式。建立了疲劳基本方程ｄσ＿ｒ／ｄ＿ｉ＝一Ａσ（ｔ）￣ｎｔ￣（－ｍ），得出了疲劳寿命公式Ｔ＝Ｍ（σ＿０－σ）／Ａσ￣ｎ（静疲劳时Ｍ＝１，连续增载疲劳时Ｍ＝ｎ＋１，循环疲劳时Ｍ＝（ｎ＋１）／（１＋Ｒ＋Ｒ￣２＋……＋Ｒ￣ｎ），逐级加载时，并导出不同疲劳方式下疲劳寿命间的关系。同时，用多种Ｓｉ＿３Ｎ＿４材料在高温中作了论证试验，结果与理论一致。