Role of strain induced crystallization and oxidative crosslinking in fracture properties of rubbers

Tensile properties and crack propagation properties, especially critical strain energy release rate in mode I, G_IC, have been used to investigate fracture properties of elastomers and their relationships with microstructure. These investigations were mainly based on a series of comparisons: first, the behaviour of polychloroprene rubber (CR), undergoing stress hardening due to strain induced crystallization (SIC) and oxidative crosslinking (OCL) was compared with that of chlorinated polyethylene (CPE), which undergoes SIC but not OCL, and with a polyurethane based on hydroxyl terminated polybutadiene (PU) which undergoes OCL but not SIC. Comparisons were also made on CR between fracture behaviour at ambient temperature, where SIC occurs and at 100 °C where there is no SIC. Finally, oxidative crosslinking was used to vary in a continuous way the crosslink density in CR and PU, in order to evaluate the role of crosslinking in fracture behaviour.     

Numerical modelling of geothermal vertical heat exchangers for the short time analysis using the state model size reduction technique

According to the introduction of a dynamic operating mode in ground-coupled heat pump systems, a short time analysis within and around borehole heat exchangers is required in the modern geothermal system simulation. A numerical modelling could be a proper answer for this challenge. However, the numerical model is time consuming and necessitates a large memory particularly in such large systems. Therefore, the state model size reduction technique has been applied in this paper with various numerical techniques particularly in the finite elements method. As a result, the reduced model developed is: (a) relevant with a validation using a traditional analytical model (using 100% modes) and (b) efficient in calculation time, only using 6% modes and consequently reducing time consumption up to 95%.     

Structural stability of intermetallic phases in the Sn–Ti system

The total energies of intermetallic compounds in the Sn–Ti system are calculated employing electronic density-functional theory (DFT) using pseudopotentials constructed by the projector augmented waves (PAW) method in the generalized gradient (GGA) approximation for the exchange and correlation energy. The calculations are performed for the experimentally observed compounds at their ideal stoichiometry as well as for structures which are stable in systems of early transition metals or rare earth elements with p-elements of columns IIIB, IVB, and VB. The calculated formation enthalpy of the hexagonal Sn₅Ti₆ compound is slightly less exothermic than the value obtained by direct reaction calorimetry. For the stable intermetallic compounds, the calculated zero-temperature lattice parameters agree well with those obtained experimentally at ambient temperature. More, for stable phases with unit cell-internal degree(s) of freedom, the results of ab initio calculations show good agreement when compared with data obtained by structural analysis of X-ray diffraction. The composition dependence of the enthalpies of formation is slightly asymmetric. The electronic densities of state of the D8₈- Sn₃Ti₅ compound have been computed; the curve shows the hybridization of Sn 5p states with Ti 3d states. The stability of the intermetallic compounds in the Ti–Sn system is due to this hybridization.     

Experimental study of a mechanically ventilated double-skin façade with venetian sun-shading device: A full-scale investigation in controlled environment

The aim of this article is to present results of an experimental campaign performed on a full-scale facility provided with a double-skin façade. The behaviour of this architectural concept is tested under controlled climatic conditions. A summer case is scrutinised under different configurations: variation of the airflow through the double-skin façade and different angle of the solar shading device. This paper describes the experimental conditions, as well the test facility and the tested façade element. The results show the temperatures of the test cell and the façade and how they depend on the climatic conditions and the sun-shading device blade angles. One objective of this research was to measure and provide extensive data set detailing air and surface temperatures on the double-skin façade, together with airflow rates and air velocities. The experiments are fully described so that the results can be used for the validation of numerical models dealing with ventilated double-skin façades with venetian sun-shading device.     

Short-range synthetic aperture imaging at 633 nm by digital holography

We present an active optical synthetic aperture-imaging system. A phase-step digital holographic setup is used as a wavefront sensor in the far field. The overlap of the holograms enables the estimation and compensation of their relative positions and phase with a speckle cross-correlation algorithm. Experimental results on a short-range synthetic aperture setup at 633 nm are presented that are based on 128 x 128 holograms. The synthesis is executed in one direction by means of rotation of the object. Test images show a significant gain of resolution in the synthesis direction. Processing errors are estimated through experiment. Random processing errors of a synthetic pupil composed of 33 merged holograms are negligible, but biases induced by unknown optical aberrations ofthe reference wave induce defocusing and astigmatism.     

Reduction of the correlation sensitivity to the changes of the input illumination by a post processing based on the correlation statistics

Linear-correlation amplitude changes when the intensity level of the input image is modified. As recognition is often based on the correlation-peak level, a change of the input illumination may result in a false recognition. We propose an illumination-change compensation by a post processing of the correlation distribution that is based on statistical measures of the correlation histograms. The theoretical background and simulation results are provided in the frame of an actual application in biology.     

Author Index,Volume 8 (2002)

Authors Index

Author Index, Volume 8 (2002)     

Toxic effects of Irgarol 1051 on phytoplankton and macrophytes in Lake Geneva

Irgarol 1051 is a recent herbicidal compound, inhibitor of photosynthesis, used in antifouling paints. This toxic is persistent in aquatic environments, with low abiotic and biotic degradation, highly phytotoxic, and has already been detected in estuaries and coastal areas, with suspected negative impacts on non-target organisms (aquatic plants and algae). We measured the toxicity of Irgarol 1051 to macrophytes and phytoplankton from Lake Geneva (between Switzerland and France) by determining chlorophyll fluorescence yield, and phytoplankton primary production. Long-term toxicity for phytoplankton was estimated in a microcosm study, and growth inhibition tests were performed with isolated algal strains. The concentration of Irgarol 1051 was analysed in the water, and the most polluted site showed a higher level (up to 135 ng/L) than the lowest observed effect concentration for phytoplankton (8-80 ng/L), while the macrophytes appeared to be more tolerant to Irgarol 1051 in short-term tests. The microcosm study showed that phytoplankton structure might be even more sensitive to Irgarol 1051.