还原铁法处理印染废水生化出水及原理

采用还原铁粉处理印染废水生化出水,以ADMI7.6作为主要测试指标,考察铁粉投加量、反应时间以及进水pH对出水水质的影响,并研究在此过程中铁粉还原作用和混凝絮凝作用对整体效果的贡献比.结果表明,条件1:铁粉投加量=1.0 g.L-1,反应时间150 min,进水pH 2;条件2:铁粉投加量1.0 g.L-1,反应时间150 min,进水pH 3.条件1时,ADMI7.6去除率达到80%,但铁泥量大,酸碱消耗大,在此反应条件下,铁粉还原去除40%,混凝絮凝去除60%;条件2时,ADMI7.6去除率达到50%左右,产铁泥量小,经济合理;在此反应条件下,铁粉还原去除55%—63%左右,混凝絮凝去除37%—45%左右.经XAD8/XAD4树脂联用,分析疏水酸、非酸疏水物质、弱疏水物质及亲水物质4类有机物的去除情况表明,条件1时,能够高效去除非酸疏水物质,去除率为95%,对于疏水酸以及弱疏水物质也有一定的去除效果;条件2时,对4类有机物去除均有一定作用,但对于非酸疏水物质以及疏水酸的去除效果要略差于条件1.     

Marked changes in biochar’s ability to directly immobilize Cd in soil with aging: implication for biochar remediation of Cd-contaminated soil

Environmental Science and Pollution Research - To investigate the change in biochar’s ability to directly immobilize Cd in soil, a successive wheat cultivation experiment was conducted. Three...     

Remediation of arsenic contaminated soil by sulfidated zero-valent iron

• Sulfidation significantly enhanced As(V) immobilization in soil by zerovalent iron. • S-ZVI promoted the conversion of exchangeable As to less mobile Fe-Mn bound As. • Column test further confirmed the feasibility of sulfidated ZVI on As retention. • S-ZVI amendment and magnetic separation markedly reduced TCLP leachability of As. In this study, the influences of sulfidation on zero-valent iron (ZVI) performance toward As(V) immobilization in soil were systemically investigated. It was found that, compared to unamended ZVI, sulfidated ZVI (S-ZVI) is more favorable to immobilize As(V) in soil and promote the conversion of water soluble As to less mobile Fe-Mn bound As. Specifically, under the optimal S/Fe molar ratio of 0.05, almost all of the leached As could be sequestrated by>0.5 wt.% S-ZVI within 3 h. Although the presence of HA could decrease the desorption of As from soil, HA inhibited the reactivity of S-ZVI to a greater extent. Column experiments further proved the feasibility of applying S-ZVI on soil As(V) immobilization. More importantly, to achieve a good As retention performance, S-ZVI should be fully mixed with soil or located on the downstream side of As migration. The test simulating the flooding conditions in rice culture revealed there was also a good long-term stability of soil As(V) after S-ZVI remediation, where only 0.7% of As was desorbed after 30 days of incubation. Magnetic separation was employed to separate the immobilized As(V) from soil after S-ZVI amendment, where the separation efficiency was found to be dependent of the iron dosage, liquid to soil ratio, and reaction time. Toxicity characteristic leaching procedure (TCLP) tests revealed that the leachability of As from soil was significantly reduced after the S-ZVI amendment and magnetic separation treatment. All these findings provided some insights into the remediation of As(V)-polluted soil by ZVI.     

Degradation characteristics and metabolic pathway of 4-nitrophenol by a halotolerant bacterium Arthrobacter sp. CN2

Arthrobacter sp. strain CN2, capable of degrading 4-nitrophenol, was isolated from activated sludge. Degradation of 4-nitrophenol was optimized at pH 7.7, 30?°C, and 0.53% of glucose. Salt tolerance of 4-nitrophenol degradation was as high as 6% (w/v). Several biodegradation intermediates were identified and quantified by high-performance liquid chromatography and mass spectrometry. 4-Nitrocatechol is involved in the degradation of 4-nitrophenol by CN2. Scale-up of 4-nitrophenol degradation was conducted in a bioreactor with different salinity. When the salinity was below 7%, the degradation rate of 4-nitrophenol was above 90% (100 mg L^?1, 3 L).     

Numerical study of wave–current–vegetation interaction in coastal waters

Research on interactions among wave, current, and vegetation has received increasing attention. An explicit depth-averaged hydrodynamic model coupled with a wave spectral model (CMS-wave) was proposed in this study in order to simulate the wave and wave-induced current in coastal waters. The hydrodynamic model was based on the finite volume method while the intercell flux was computed by employing the Harten–Lax–van Leer approximate Riemann solver to investigate the dry-to-wet interface, and the drag force of vegetation was modeled as the sink terms in the momentum equations. The CMS-wave model was used to investigate the non-breaking and the breaking random waves propagation in vegetation fields. Afterwards, an empirical wave energy dissipation term with plant effect was derived to represent the resistance induced by aquatic vegetation in the wave-action balance equation. The established model was calibrated and validated with both the experimental and field data. The results showed that the wave height decreased significantly along the wave propagation direction in the presence of vegetations. The sensitivity analysis for the plant density, the wave height, and the water depth were performed by comparing the numerical results for the wave height attenuation. In addition, wave and wave-induced current through a finite patch of vegetation in the surf zone were investigated as well. The strong radiation stress gradient could be produced due to the variation of the energy dissipation by vegetation effect in the nearshore zone, which impacted the direction and amplitude of the longshore current. The calculated results showed that the coupling model had good performance in predicting wave propagation and the current over vegetated water regions.     

Flow structure and turbulence characteristics downstream of a spanwise suspended linear array

Laboratory experiments are conducted to quantify the mean flow structure and turbulence properties downstream of a spanwise suspended linear array in a uniform ambient water flow using Particle Tracking Velocimetry. Eighteen experimental scenarios, with four depth ratios (array depth to water column depth) of 0.35, 0.52, 0.78, and 0.95 and bulk Reynolds number (length scale is the array depth) from 11,600 to 68,170, are investigated. Three sub-layers form downstream of the array: (1) an internal wake zone, where the time-averaged velocity decreases with increasing distance downstream, (2) a shear layer which increases in vertical extent with increasing distance downstream of the array, and the rate of the increase is independent of the bulk Reynolds number or the depth ratio, and (3) an external wake layer with enhanced velocity under the array. The location of the shear layer is dependent on the depth ratio. The spatially averaged and normalized TKE of the wake has a short production region, followed by a decay region which is comparable to grid turbulence decay and is dependent on the depth ratio. The results suggest that the shear layer increases the transfer of horizontal momentum into the internal wake zone from the fluid outside of the array and that the turbulence in the internal wake zone can be modeled similarly to that of grid turbulence.     

Comparison of membrane fouling in ultrafiltration of down-flow and up-flow biological activated carbon effluents

The UF membrane fouling by down- and up-flow BAC effluents were compared. Up-flow BAC effluent fouled the membrane faster than down-flow BAC effluent. The combined effects dominated irreversible fouling. The extent of fouling exacerbated by inorganic particles was higher. The TMP, permeate flux, and normalized membrane flux during 21 days of UF of DBAC and UBAC effluents. Fouling during ultrafiltration of down- and up-flow biological activated carbon effluents was investigated to determine the roles of polysaccharides, proteins, and inorganic particles in ultrafiltration membrane fouling. During ultrafiltration of down- flow biological activated carbon effluent, the trans-membrane pressure was≤26 kPa and the permeate flux was steady at 46.7 L?m⁻²?h⁻¹. However, during ultrafiltration of up-flow biological activated carbon effluent, the highest trans-membrane pressure was almost 40 kPa and the permeate flux continuously decreased to 30 L?m⁻²?h⁻¹. At the end of the filtration period, the normalized membrane fluxes were 0.88 and 0.62 for down- and up-flow biological activated carbon effluents, respectively. The membrane removed the turbidity and polysaccharides content by 47.4% and 30.2% in down- flow biological activated effluent and 82.5% and 22.4% in up-flow biological activated carbon effluent, respectively, but retained few proteins. The retention of polysaccharides was higher on the membrane that filtered the down- flow biological activated effluent compared with that on the membrane that filtered the up-flow biological activated carbon effluent. The polysaccharides on the membranes fouled by up-flow biological activated carbon and down- flow biological activated effluents were spread continuously and clustered, respectively. These demonstrated that the up-flow biological activated carbon effluent fouled the membrane faster. Membrane fouling was associated with a portion of the polysaccharides (not the proteins) and inorganic particles in the feed water. When there was little difference in the polysaccharide concentrations between the feed waters, the fouling extent was exacerbated more by inorganic particles than by polysaccharides.     

Assessment of heavy metals in some wild edible mushrooms collected from Yunnan Province, China

Eight heavy metals (Cu, Zn, Fe, Mn, Cd, Cr, Ni, and Pb) in 14 different wild-growing edible mushroom species (Coprinus comatus, Voluariella volvacea, Pleurotus nebrodensis, Hypsizigus marmoreus, Hericium erinaceus, Agrocybe aegerita, Lenfinus edodes, Collybia velutipes, Agaricus bisporus, Russula albida, Clitocybe conglobata, Pleurotus eryngii, Lepista sordida, and Pleurotus ostreatus) collected from Yunnan province, China, were determined by inductively coupled plasma-atomic emission spectrometry after microwave digestion. All element concentrations were determined on a dry weight basis. The ranges of element concentrations for copper, zinc, iron, manganese, cadmium, chromium, nickel, and lead were 6.8-31.9, 42.9-94.3, 67.5-843, 13.5-113, 0.06-0.58, 10.7-42.7, 0.76-5.1, and 0.67-12.9 mg/kg, respectively. In general, iron content was higher than other metals in all mushroom species. The levels of zinc, cadmium, and lead in some edible mushroom samples were found to be higher than legal limits. The relative standard deviations were found below 10%. The accuracy of procedure was confirmed by certified reference material.     

Investigation of indole biodegradation by Cupriavidus sp. strain IDO with emphases on downstream biotransformation and indigo production

Environmental Science and Pollution Research - Indole, as a typical N-heterocyclic aromatic pollutant, poses risks to living things; however, indole-biotransformation mechanisms remain...     

四川沐川—马边（1994—12—30）5.5级地震山地灾害类型研究

地震诱发的次生山地灾害类型包括：崩塌、滚石、滑坡和重力地裂缝。其规模为中、小型，但类型较多，分布密集，造成不同程度危害。按照危险性区划，震区可划分为高、中、低三种山地灾害危险度区域。各区域面积为：ＵＤ＝９．４ｋｍ＾２；ＭＤ＝２５．９ｋｍ＾２；ＬＤ＝４０．４ｋｍ＾２。斜坡可分为梯状破坏模型：①Ｒｃ崩塌、滚石阶梯；②Ｌｄ滑坡阶梯；③Ｇｆ重力地裂缝阶梯。