Adsorption of bovine serum albumin to a polymer brush prepared by atom-transfer radical polymerization in a porous inorganic membrane

Protein adsorption was performed by a polymer brush prepared by atom-transfer radical polymerization (ATRP) to a porous inorganic membrane. The porous inorganic membrane, Shirasu Porous Glass made from silica, was modified with a halogen-containing compound to bind the active species for the polymerization. Glycidyl methacrylate was polymerized from the halogen compound by ATRP for a prescribed time, and subsequently chemically modified. The progression of the chemical modification allowed the membrane to lower the phosphate-buffer flux of the porous membrane due to the attachment of the polymer brush. Bovine serum albumin (BSA), as a model protein, was adsorbed at 12 mg per gram of the membrane in permeating BSA solution through the polymer-brush-attached porous membrane.     

纳米SiO_2制备方法研究

以溶胶—凝胶法(sol-gel)为基础,乙醇作溶剂,在氨水催化作用下,研究了正硅酸乙酯(TEOS)通过水解聚合反应制备Si O2微球的方法,并探讨n(水)/n(TEOS)(简称H)及反应时间等因素的影响。本实验借助激光散射粒度分布分析仪研究Si O2微球在溶液态的分布情况,同时使用SEM对烘烤干燥后的Si O2微球进行表征,该方法制得的纳米Si O2微球分布集中,平均粒径在90 nm左右。     

Direct Use of Benzylic Alcohols for Gold(III)‐Catalyzed S‐Benzylation of Mercaptobenzoic Acids in Water

We demonstrate the gold(III)‐catalyzed direct substitution of benzylic alcohols in water. These atom economic and environmentally benign protocols afford S‐benzylated products in moderate to excellent yields. In contrast, common Lewis or Brønsted acids as catalyst, and organic solvents such as dichloromethane or toluene were ineffective for the S‐benzylation of mercaptobenzoic acids. Water can be an attractive tool for new transition metal‐catalyzed reactions. A Hammett study for the rate constants with various substituted alcohols shows a good correlation (R²=0.97) between the log(k_X/k_H) and the σ⁺ value of the respective substituents. From the slope negative ρ values of 2.35 are obtained, suggesting that there is a build‐up of positive charge in the transition state. Our catalytic system can be performed with the use of only 2 mol% of gold(III) catalyst without any other additives in water, and scaled up to 10 mmol scale (85% isolated yield). Notably, the present method can accomplish the S‐benzylation of unprotected mercaptobenzoic acids, which is chemoselective and leaves the carboxyl group intact. Furthermore, the direct substitution of allylic and propargylic alcohols also proceeded smoothly in good yields.

     

Catalytic Aerobic Photo‐oxidation of a Methyl Group on a Heterocycle to Produce an Aldehyde via Homolytic C?I Bond Cleavage caused by Irradiation with Visible Light

A new catalytic method was developed for photo‐oxidizing the methyl group on aromatic heterocycles such as benzothiazole, benzoxazole, and quinoline to produce the corresponding aldehyde. This is the first report of the metal‐free catalytic synthesis of benzothiazole‐2‐carboxaldehydes using molecular oxygen as the terminal oxidant.

     

A field study on serum vitellogenin levels in male Reeves' pond turtles (Chinemys reevesii) from estrogen-contaminated sites and a reference site

To ascertain whether wild male turtles were influenced by environmental estrogens, we examined serum vitellogenin (VTG) levels of male Reeves' pond turtles (Chinemys reevesii) collected from four study sites (A-D) in Kyoto, Japan. Sites A-C, which were impacted by domestic or industrial wastewater and effluents from sewage treatment plants, were chosen as contaminated sites, and site D was intended as a reference site. This contaminated/reference site characterization was confirmed by measuring estrogenic activities of the water samples collected at each site for over a year. Serum VTG levels in the turtles were quantified by an enzyme-linked immunosorbent assay established previously. Estrogenic activities of the water samples were measured using a previously validated yeast two-hybrid assay and expressed as the estradiol-17beta equivalent. Estrogenic activity was observed at high levels at sites A-C, but was almost undetected at site D throughout the sampling period: the mean and range were 0.74 (<0.07-2.1), 0.52 (0.17-1.6), 1.7 (<0.07-7.3), and 0.07 (<0.07-0.62) ng/l at sites A-D, respectively. Significant differences were found only in site D versus sites A, B, and C. Therefore, site D and sites A-C were confirmed to be a reference site and contaminated ones, respectively. Overall, 320 male turtles were captured and examined. The majority of the turtles showed normal VTG values (0.10-0.74 microg/ml). Although only five turtles from sites A-C showed unusually high VTG values (1.1-5.9 microg/ml, nearly one order of magnitude higher than normal values but much lower than values in adult females), there was no significant difference in the incidence of these high values between sites A-C and site D. Moreover, among the five turtles, one turtle was captured again 2 months later, but its VTG value dropped to the normal level. The unusually high VTG values may therefore be transient elevation caused by incidental and/or individually specific agents. Excluding the unusually high values, the mean serum VTG (accompanied with the range) was 0.22 (0.10-0.74), 0.27 (0.11-0.62), 0.27 (0.17-0.68), and 0.23 (0.10-0.57) microg/ml at sites A-D, respectively. There were no significant differences in the mean VTG values among sites A-D. Although it should be clarified how and why the unusually high VTG values occurred at sites A-C, our results suggested that wild male C. reevesii turtles would not be significantly affected by xenobiotic estrogens at environmentally relevant levels in terms of serum VTG elevation.     

Effect of BN nanoparticle content in SiC matrix on microstructure and mechanical properties of SiC/SiC composites

BN-nanoparticle-containing SiC-matrix-based composites comprising SiC fibers and lacking a fiber/matrix interface (SiC/BN + SiC composites) were fabricated by spark plasma sintering (SPS) at 1800°C for 10 min under 50 MPa in Ar. The content of added BN nanoparticles was varied from 0 to 50 vol.%. The mechanical properties of the SiC/BN + SiC composites were investigated thoroughly. The SiC/BN + SiC composites with a BN nanoparticle content of 50 vol.%, which had a bulk density of 2.73 g/cm³ and an open porosity of 5.8%, exhibited quasiductile fracture behavior, as indicated by a short nonlinear region and significantly shorter fiber pullouts owing to the relatively high modulus. The composites also exhibited high strength as well as bending, proportional limit stress, and ultimate tensile strength values of 496 ± 13, 251 ± 30, and 301 MPa ± 56 MPa, respectively, under ambient conditions. The SiC fibers with contents of BN nanoparticles above 30 vol.% were not severely damaged during SPS and adhered to the matrix to form a relatively weak fiber/matrix interface.     

Preparation of smooth and dense composite films consisting of MEHPPV and neat C60 by means of electrophoretic deposition

A procedure to prepare flat and dense composite films of a conjugated polymer poly[2-methoxy-5-(2′-ethylhexyloxy)-1,4-phenylene vinylene] (MEHPPV) and various amounts of neat C₆₀ by means of electrophoretic deposition from dilute suspensions is reported. It has been observed that deposition from suspensions containing both components results in pinhole-free films, which are applicable to photovoltaic devices, while inhomogeneous films are formed from the suspensions containing only one of the components. The applicability of electrophoretic deposition to obtain polymer-C₆₀ composite films showing photovoltaic effects has been successfully demonstrated.     

International mobility of researchers in robotics,computer vision and electron devices: A quantitative and comparative analysis

We investigated author information in scientific articles by approximately 7,000 researchers for a quantitative analysis of researchers’ international mobility. From top journals, we traced the movements of more than 2,200 researchers in the research domains of robotics, computer vision and electron devices. We categorized countries’ characteristics for the balance between the inflow and the outflow of researchers moving internationally. Flow patterns of international mobility confirm that the United States, China and India exhibit the greatest global flows of researchers, with Singapore and Hong Kong attracting remarkable numbers of researchers from other countries. International mobility focusing on institutions reveals that universities in Singapore receive as many foreign researchers as do research universities in the United States. Furthermore, firms and international collaborative research institutes act as alternative receivers to the universities in the electron devices research domain.     

Biocompatibility of a-C:H film coating for synthetic vascular graft

Amorphous hydrogenated carbon (a-C:H) films have many excellent properties such as biocompatibility, anti-corrosion, and chemical stability. Therefore, there are many reports on application of a-C:H film as surface modification technique for biomaterials. However, it is difficult to deposit a-C:H film on complex structures such as artificial heart blood pump and synthetic vascular grafts. In our previous work, we have developed an electrode which is adapted to such irregular structures for plasma CVD technique.In this study, a-C:H film was deposited on a synthetic vascular graft inner-wall by r.f. plasma CVD technique with cylindrical electrode. The purpose of such coating is improvement of biocompatibility of the vascular graft. The biocompatibility of the a-C:H film was evaluated by cytocompatibility and plasma protein adhesion. For the a-C:H film deposition, cytocompatibility and protein adsorbent of the vascular grafts were improved for biological response under cell culture with mouth fibroblasts and plasma proteins (albumin, fibrinogen, and globulin), respectively. This study indicates that the a-C:H films coatings is expected to surface modification for medical appliances.