A multilevel PWM strategy suitable for high‐voltage motor direct drive systems with consideration of the adverse effect of dead time

Recently, high‐voltage motor direct drive systems have been put to practical use, and various multilevel PWM strategies have also been proposed. This paper describes a multilevel PWM strategy [our group calls it the Carrier Phase Selection Method (CPS)] that has the lowest line voltage harmonic distortion in order to prevent the degradation of high‐voltage motor winding insulations. This method takes the adverse effect of dead time into consideration, and it controls the shift direction of a carrier phase. Therefore, a favorable output waveform without instantaneous voltage surges is achieved even if the line voltage level changes. Moreover, the switching transitions across all switching devices are well‐balanced, so the utilization of inverter unit cells is equalized. This is an important factor when designing the entire system. Based on simulation and experimental results, it is shown that this CPS method is particularly effective in high‐voltage motor direct drive systems. © 2008 Wiley Periodicals, Inc. Electr Eng Jpn, 165(2): 77–88, 2008; Published online in Wiley InterScience ( www.interscience.wiley.com ). DOI 10.1002/eej.20474     

Significant improvement of magnetic properties and corrosion resistance in evaporated Co-Ni recording media

An addition of a very small amount of Pr in Co-Ni films of a recording medium improves both corrosion resistance and frequency response. The columnar grains, which are induced by oblique incidence of evaporation, becomes remarkably finer by the addition of rare-earth elements. The TEM image of the cross section of the films shows a dense packed structure. High magnetization and a better corrosion resistance are considered to be due to the dense packed structure. The fine grain improves the frequency response. Among several rare-earth elements, especially Pr doping yields a best recording performance.     

Variations in polymeric structure of ferroelectric poly(vinylidene fluoride) films during annealing at various temperatures

To clarify the thermal degradation mechanisms of uniaxially drawn poly(vinylidene fluoride) (PVDF) films, variations due to annealing in the polymeric structures of the films were investigated using the small‐angle X‐ray scattering (SAXS) and Fourier transform infrared (FTIR) spectroscopy. The films were composed of lamellar crystals that were stacked perpendicular to the stretch direction. Although the crystallinity of the films decreased during annealing in the temperature range above the preannealing temperature, the lamellar structure was maintained even after the annealing process. There are two kinds of irreversible relaxation mechanisms during the annealing process of the films, including both a decrease in crystallinity within the lamellae and also thickening of the lamellae. A significant lamella thickening effect was observed when the films were annealed above ～ 100°C. FTIR spectra suggested some disordered structures are developed during thickening of the lamellae. Furthermore, a long‐range periodic structure was formed in the films that were annealed above the melting temperature of PVDF. The polymeric structures formed during the fabrication process (including high‐order structures and disorders in molecular conformation) were clarified as having a significant influence on the annealing behavior of ferroelectric PVDF films. © 2008 Wiley Periodicals, Inc. J Appl Polym Sci, 2009     

Morphology of nanoholes formed in silicon by wet etching in solutions containing HF and H2O2 at different concentrations using silver nanoparticles as catalysts

Holes with diameters of tens of nanometers were bored in Si(1 0 0) in aqueous solutions containing hydrofluoric acid and hydrogen peroxide utilizing silver nanoparticles as catalysts. The holes grew deeply in the [1 0 0] direction when the concentration of hydrogen peroxide was about 0.18 M. In addition to these vertical holes, holes were generated horizontal to the surface in the 〈1 0 0〉 directions near the surface of the sample. We found that the silver particles making the deep holes in the [1 0 0] direction were more spherical than those making the horizontal holes near the surface. These results indicate that the shape of the silver particles is an important factor controlling the direction of the holes. When the hydrogen peroxide concentration was increased to 1.8 M, as well as the vertical and horizontal holes, a microporous layer was formed on the top surface region. On the other hand, when the hydrogen peroxide concentration was lowered to 0.0018 M, holes did not show any preference for growing direction and were crooked. Even in HF solutions that did not contain hydrogen peroxide, holes were generated at a very slow rate in random directions if the solutions contained oxygen.     

Thermal conductivity of non-stoichiometric americium oxide: A molecular dynamics study

The aim of this paper is to investigate the influence of multi-valency of americium in its oxide for the lowering of the thermal conductivity and the uncertainty in measurement. In the present study, thermal conductivity of non-stoichiometric americium oxide was evaluated up to 2000 K by the non-equilibrium molecular dynamics calculations using the Born-Mayer-Huggins interatomic potential with the partially ionic model. The oxygen-to-americium ratio (O/Am) was varied from 1.6 to 1.9, which corresponded to the variation of the ratio of Am³⁺/Am⁴⁺. So, we prepared potential parameters for both Am³⁺ and Am⁴⁺. The calculated thermal conductivity of non-stoichiometric americium oxide decreased with an increase of temperature, and the degree of the temperature dependence became smaller with a decrease of the O/Am ratio. This was mainly caused by the phonon-scattering due to oxygen vacancies induced with Am³⁺ ions. Comparing two supercells in which (1) short-range ordered Am³⁺ clusters were contained and (2) Am³⁺ ions were randomly distributed, the thermal conductivity of the former seemed to be somewhat larger than that of the latter.     

Microstructure Control of Sintered Porous Yttria-Stabilized Zirconia as a Durable Thermal Shielding Material

The microstructure of a thermal shielding material affects its thermal conductivity and mechanical property. In this study, the effects of the sintering temperature and the polymethyl methacrylate powder as a pore-former on the microstructure of a sintered porous yttria-stabilized zirconia (YSZ), which is used as a durable thermal shielding material, were investigated. It became clear that the microstructure of the sintered YSZ could be controlled by the particle size and the amount of the pore-former and the sintering temperature. The effect of the yttria amount in the YSZ on the microstructure was also clarified.     

Reconstruction of lake-level and climate changes in Lake Qarun,Egypt, during the last 7000 years

Sediment cores from Lake Qarun provide a record of mid-late Holocene climatic changes in Northern and Eastern Africa as well as environmental changes due to the activities of ancient Egyptians. We used sedimentological, mineralogical, and geochemical analyses of the cores to investigate long-term variations in lake level due to changing hydrologic inputs. An age model based on three paired ¹⁴C and paleomagnetic measurements suggests that the base of the sediment cores is as old as ∼ 5000 B.C.E. Geochemical analyses indicated that lake sediments were derived from Nile floods with an admixture of Saharan sand. Laminated endogenic carbonate-rich clayey silt lithofacies with benthic diatoms are indicative of relatively low lake levels, saline waters and dry conditions; massive lithofacies with planktonic diatom species are indicative of relatively high lake levels, fresh waters and humid conditions. Faintly laminated clayey silt lithofacies suggest intermediate conditions. Variations in lithology as well as diatom composition suggest that the lake level has varied from relatively high levels in its early history to lower levels in later years although there have been numerous cycles in water level over the past 7000 years. A combination of climate changes in the source area of the Nile River as a result of monsoon dynamics; climatic changes in the setting area of the Lake Qarun; and human activities through the dynasties in Egypt produced these variations in lake level.     

PZT MIM capacitor with oxygen-doped Ru-electrodes for embedded FeRAM devices

An add-on-type, Pb(Zr,Ti)O/sub 3/ (PZT) metal-insulator- (MIM) capacitor on Al multilevel interconnects is developed for embedded FeRAM devices, concluding that the oxygen-doping into the ruthenium (Ru) electrodes is crucial for obtaining large remnant polarization under a limited process temperature below 450/spl deg/C. The oxygen-doped, Ru bottom-electrode with a granular structure reduces the PZT sputtering temperature below 450/spl deg/C to obtain the ferroelectric perovskite-phase. On the other hand, oxygen doping into the Ru top-electrode suppresses the reductive damage at the interface between the top-electrode and the PZT, keeping the leakage current low. The PZT MIM capacitor with these oxygen-doped, Ru electrodes exhibits the remnant polarization of 21 /spl mu/C/cm/sup 2/ on the Al multilevel interconnects with no degradation of the interconnect reliability, thus applicable to the embedded FeRAM in 0.25 /spl mu/m-CMOS logic LSIs.