共查询到20条相似文献,搜索用时 359 毫秒
1.
《Planning》2016,(2)
为了解辽宁省主要水源水库的富营养化状况,利用相关加权综合营养状态指数TLI(∑)等方法,研究了辽宁省大伙房水库、汤河水库、碧流河水库、柴河水库、观音阁水库和桓仁水库6座水源水库在2008—2009年期间水体的富营养化状况。结果表明:除碧流河水库外,其他5座水库均达到富营养化状态;按聚类分析,6座水库共分为3类,碧流河水库单独为一类,水质最好,柴河水库单独为一类,富营养化水平较高,水质较差,其余水库为一类,水质状况相对较好;主成分分析显示,对水体富营养化影响较大的水化学因子是氨态氮、硝酸氮、总磷。根据对辽宁省水源水库水质状况的调研结果,作者提出了对辽宁省水源水库水环境有效保护和治理的建议:(1)成立水源地保护组织,对水源水库进行综合治理;(2)禁止网箱养鱼,大力发展保水渔业;(3)规范水利工程,投入人力和物力对水源水库加强生物和化学监测,对潜在的生态风险及时预警或预报;(4)对已发生严重富营养化的水库应考虑采取生态学手段进行生态修复。 相似文献
2.
《Planning》2022,(2)
为了解辽宁省主要水源水库的富营养化状况,利用相关加权综合营养状态指数TLI(∑)等方法,研究了辽宁省大伙房水库、汤河水库、碧流河水库、柴河水库、观音阁水库和桓仁水库6座水源水库在2008—2009年期间水体的富营养化状况。结果表明:除碧流河水库外,其他5座水库均达到富营养化状态;按聚类分析,6座水库共分为3类,碧流河水库单独为一类,水质最好,柴河水库单独为一类,富营养化水平较高,水质较差,其余水库为一类,水质状况相对较好;主成分分析显示,对水体富营养化影响较大的水化学因子是氨态氮、硝酸氮、总磷。根据对辽宁省水源水库水质状况的调研结果,作者提出了对辽宁省水源水库水环境有效保护和治理的建议:(1)成立水源地保护组织,对水源水库进行综合治理;(2)禁止网箱养鱼,大力发展保水渔业;(3)规范水利工程,投入人力和物力对水源水库加强生物和化学监测,对潜在的生态风险及时预警或预报;(4)对已发生严重富营养化的水库应考虑采取生态学手段进行生态修复。 相似文献
3.
4.
《Planning》2022,(6)
根据2012年对北京市奥林匹克公园龙形水系水质逐月监测结果,采用综合营养状态指数法(TLI)和水质综合标识指数法(WQI)分别对该水系水体富营养化现状和水质级别进行评价。结果表明:龙形水系水质偏碱性,水中溶解氧常年处于过饱和状态,化学耗氧量(COD Mn)、生化需氧量(BOD5)、悬浮物、叶绿素a、总氮和总磷等水质指标随时间变化较大,水体中总磷一直维持在较低水平,是龙形水系水体富营养化的限制因子;水系水体营养状态从春季到秋季由轻富营养到中营养转变,其水质级别基本上都在Ⅲ类水质标准以上,达到了水环境功能目标要求;沉水植物种植水域水质优于非沉水植物种植水域;水系河道设计也能影响水系的水质。本研究结果可为北京市奥林匹克公园龙形水系水环境保护提供科学依据。 相似文献
5.
《Planning》2015,(9)
针对冰封期水库水体具有独特特征及冬季市区供水存在异味问题,在2012年11月至2013年2月期间,对处于冰封期的呼和浩特市水源地金海水库的理化指标和浮游藻类进行了监测,并将其结果与夏季监测值进行了对比分析,得出了其变化趋势。结果表明:水库水质良好,但存在轻度污染;水体中共检测到浮游藻类6门24属27种,其主要优势种为绿藻、硅藻和隐藻;相关性分析表明叶绿素a(Chla)、总磷(TP)与浮游藻类数量呈正相关关系,而总氮(TN)则无明显的相关性,溶解氧(DO)和透明度(SD)均呈负相关关系;冰封期水体的理化指标与夏季的相比,高锰酸钾指数(CODMn)、TN和TP值较大,而Chla、pH和SD值略小;夏季的浮游藻类数量明显高于冬季,但不同的季节优势种类存在区别,由此可得冰封期水质较差与浮游藻类的种类和数量存在一定的联系。 相似文献
6.
由于近年来干旱少雨,水库储水量大大减少,水体自净能力降低,以及水库周围环境的影响,加快了水体富营养化进程。某些特征藻类(蓝藻、绿藻)异常增殖,使水体水质恶化,大量藻类繁殖及其它微生物的生长,引起水中不良嗅味产生,由此严重干扰给水处理过程,嗅味问题可以通过增大混凝剂投加量强化工艺过程、提高加氯量和更换炭滤池的活性炭加以解决。 相似文献
7.
《Planning》2016,(1)
目的研究厦门市汀溪水库水体中微囊藻毒素与主要环境因子之间的相关性,为建立微囊藻毒素的预警监测机制提供科学依据。方法于2009—2010年对厦门市汀溪水库水质中MC-LR和MC-RR、叶绿素a(chla)、总氮、总磷、氨氮、硝酸盐氮、高锰酸盐指数、五日生化需氧量、溶解氧、透明度、水温、pH进行监测,按照《地表水环境质量标准》(GB 3838-2002)Ⅱ类水体限值进行评价,采用SPSS 19.0统计软件分别将MC-LR和MC-RR与主要环境因子进行相关性分析。结果水库水体的营养状况为中营养到轻度富营养水平,MC-LR和MC-RR的检出率分别为43.48%和56.52%,检出浓度范围分别为0.0025~0.238μg/L和0.0012~0.162μg/L。MC-RR与透明度呈显著负相关(P<0.05),其余因子与MC含量的相关性均不具有统计学意义。结论汀溪水库水体处于较低程度的营养化水平,运用多因素逐步回归发现MC-RR主要影响因素为总氮、透明度(R~2=0.419,P<0.006)。 相似文献
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
Textilbeton ist ein neuer, effektiver und sehr innovativer Baustoff zur Verstärkung von Tragwerken. Im Rahmen der laufenden Forschung stehen die weitere Verbesserung des Verstärkungsverfahrens und die stetige Weiterentwicklung der Faser‐Matrix Kombination im Mittelpunkt der Untersuchungen. Aufgrund der hohen Garnzugfestigkeiten sind bei Verwendung textiler Bewehrungen aus Carbon sehr effektive Verstärkungen herstellbar. Bei ungünstiger Konfiguration der textilen Bewehrungen können jedoch verbund‐ und festigkeitsschädigende Rissbildungen innerhalb zugbeanspruchter Textilbetonbauteile auftreten. Diese Rissbildungseffekte werden in Abhängigkeit von der Belastung maßgeblich durch die wirkenden Verbundkräfte und die verarbeitungsbedingte Garnwelligkeit beeinflusst. Dabei ist die Gefahr eines Verbundversagens durch Delamination besonders in den Bereichen der Lasteinleitung in die textile Bewehrung, wie z. B. Endverankerungen und Übergreifungsstößen, kritisch. Dies führt zu einer Reduzierung der nutzbaren Zugtragfähigkeit der textilen Bewehrung im Gesamtbauteil. Um die Effizienz der textilen Bewehrung zu erhöhen, wurde daher ein verbessertes Textilherstellungsverfahren auf Basis der Nähwirktechnik entwickelt. Dadurch wird die ungünstig wirkende Garnwelligkeit deutlich reduziert. Der vorliegende Aufsatz beschreibt vergleichende Untersuchungen der Verbund‐ und Festigkeitseigenschaften zugbeanspruchter Textilbetonbauteile. Die Ergebnisse zeigen, dass mit der Entwicklung des erweiterten Nähwirkprozesses ein maßgeblicher Schritt im Hinblick auf eine weitere Verbesserung der Eigenschaften des Textilbetons erreicht werden konnte. Efficiency Increase of Textile Reinforced Concrete by Use of Textile Reinforcements from the Extended Warp Knitting Process The composite material textile reinforced concrete (TRC) is a new, effective and very innovative method for the strengthening of load bearing structures. Apart from further improvements to the strengthening methods, a continual further development of the fibre‐matrix combination is at the centre of ongoing research. Due to the high tensile strengths of textile reinforcements made of carbon, it enables very effective strengthening of concrete constructions. However, if the textile fabrics are unfavourably configured, bond and strength damaging crack formations within TRC members can occur. Depending on the load, these crack formation effects are substantially influenced by the bond and the size of yarn undulation, which depends on the processing of the fabric. The danger of bond failure by delamination, which particularly occurs in areas of concentrated load introduction into the textile reinforcement, such as final anchorages and overlaps, is especially critical. It results in a reduction of the usable tensile load bearing capacity in the entire member. For this reason, an improved textile manufacturing method based on warp knitting technology was developed. By means of this method, yarn undulation can be reduced considerably. The article on hand describes comparative examinations of the bond and strength properties of tensile loaded TRC elements. The results show that the development of the extended warp knitting process was a substantial step toward a further improvement of the properties of TRC. 相似文献
18.
19.
The Italian construction industry was rocked by the scandals regarding procurement by the public sector during the early 1990s. Although not confined to construction, the role of the state in construction demand meant that it was one of the most heavily implicated sectors. Known as 'tangentopoli', the scandals have prompted a major reform of public sector procurement in the Italian industry which, combined with changes required to conform with EU directives, is leading to a profound cultural change in the industry. This paper provides an authoritative review of the changes in the procurement codes and the roles and relationships within the construction industry. It shows how the project management of public sector programmes is being strengthened, and how the procurement of the design and construction processes is being separated to provide greater transparency in the process. Although it is too soon to tell what the actual impact of these changes will be upon construction industry practice, some suggestions are made in the concluding comments. En Italie, le secteur de la construction a ete secoue par les scandales concernant les approvisionnements par le secteur public au debut des annees 1990. Bien que n'etant pas limitee a la construction, la part de l'Etat dans la demande pour les travaux de construction temoignait que c'etait bien l'un des secteurs les plus impliques. Connus sous l'appellation de 'tangentopoli', ces scandales ont declenche une vague de reformes qui a touche les approvisionnements par le secteur public qui, combines aux changements necessaires pour se conformer aux directives de l'UE, conduisent a un profond changement culturel de cette industrie. La presente communication constitue une etude documentee des changements qui affectent les codes d'approvisionnement ainsi que les roles et les relations qui s'etablissent au sein de l'industrie de la construction. Elle montre comment la gestion de projets, lorsqu'il s'agit de programmes du secteur public, se trouve renforcee et comment la fourniture de prestations d'etudes et de travaux de construction joue en faveur d'une plus grande transparence du procede. Bien qu'il soit trop tot pour dire quel impact auront ces changements sur les pratiques dans le secteur de la construction, l'auteur conclut en faisant certaines recommandations. 相似文献
20.