Thermal Expansion and Isothermal Compressibility of TlIn1 – xNdxSe2 (0 ≤ x≤ 0.08) Crystals

The thermal expansion coefficient () and isothermal compressibility ( _T ) of TlIn_{1 – x} Nd _x Se₂(0 x 0.08) crystals were measured between 77 and 400 K. In the range 77–160 K, both and _T increase with temperature, the increase in being much steeper. At higher temperatures, and _T change very little. The observed composition dependences of and _T are interpreted in terms of energy-band structure.     

Thermal Conductivity of the Four-Leg Spin-Ladder System La2Cu2O5 Single Crystal

We have investigated the magnetic susceptibility, , and the thermal conductivity, , in magnetic fields for the four-leg spin-ladder system La₂Cu₂O₅ single crystal. The in a magnetic field parallel to the ladder exhibits a kink at 130 K in correspondence to the magnetic ordering. The along the ladder exhibits a peak at 25 K and a shoulder at 14 K, which are probably related to the thermal conductivity due to magnons, _magnon, and that due to phonons, _phonon, respectively. The perpendicular to the ladder, on the other hand, exhibits only one broad peak related to _phonon. The observed large anisotropy of has been explained based upon the anisotropy of _magnon.     

Thermal transport properties of helium near the superfluid transition. II. Dilute3He-4He mixtures in the superfluid phase

Measurements of the average thermal conductivity _exp hQ/T and of the thermal relaxation time to reach steady-state equilibrium conditions are reported in the superfluid phase for dilute mixtures of³He in⁴He. Hereh is the cell height,Q is the heat flux, andT is the temperature difference across the fluid layer. The measurements were made over the impurity range 2×10^–9<X(³He)<3×10^–2 and with heat fluxes 0.3<Q<160 µW/cm². Assuming the boundary resistanceR _b , measured forX<10^–5, to be independent ofX over the whole range ofX, a calculation is given for _exp. ForQ smaller than a well-defined critical heat fluxQ _c (X) X ^0.9, _exp is independent of Q and can be identified with the local conductivity _eff, which is found to be independent of the reduced temperature = (T–T)/T for –10^–2. Its extrapolated value at T is found to depart forX10^–3 from the prediction X ^–1 , tending instead to a weaker divergence X ^–a witha0.08. A finite conductivity asX tends to zero is not excluded by the data, however. ForQ >Q _c (X), a nonlinear regime is entered. ForX10^–6, the measurements with the available temperature resolution are limited to the nonlinear conditions, but can be extrapolated into the linear regime forX2×10^–7. The results for _exp(Q),Q _c (X), and _eff(XX) are found to be internally consistent, as shown by comparison with a theory by Behringer based on Khalatnikov's transport equations. Furthermore, the observed relaxation times (X) in the linear regime are found to be consistent forX>10^–5 with the hydrodynamic calculations using the measured _eff(X). ForX<10^–5, a faster relaxation mechanism than predicted seems to dominate. The transport properties in the nonlinear regimes are presented and unexplained observations are discussed.     

Nonlinear asymptotic theory of hypersonic flow past a circular cone

Summary The hypersonic small-disturbance theory is reexamined in this study. A systematic and rigorous approach is proposed to obtain the nonlinear asymptotic equation from the Taylor-Maccoll equation for hypersonic flow past a circular cone. Using this approach, consideration is made of a general asymptotic expansion of the unified supersonic-hypersonic similarity parameter together with the stretched coordinate. Moreover, the successive approximate solutions of the nonlinear hypersonic smalldisturbance equation are solved by iteration. Both of these approximations provide a closed-form solution, which is suitable for the analysis of various related flow problems. Besides the velocity components, the shock location and other thermodynamic properties are presented. Comparisons are also made of the zeroth-order with first-order approximations for shock location and pressure coefficient on the cone surface, respectively. The latter (including the nonlinear effects) demonstrates better correlation with exact solution than the zeroth-order approximation. This approach offers further insight into the fundamental features of hypersonic small-disturbance theory.Notation a speed of sound - H unified supersonic-hypersonic similarity parameter, - K hypersonic similarity parameter, M - M freestream Mach number - P pressure - T temperature - S entropy - u, v radial, polar velocities - V freestream velocity - shock angle - cone angle - density - density ratio, /() - ratio of specific heats - polar angle - stretched polar angle, / - (), (), () gage functions     

On the nano-size intergrowth of Sr4Fe6O13±δ and (Sr1?xLax)FeO3?δ phases in the mixed conductor Sr3.6La0.4Fe6Oz

The microstructures of mixed-conducting Sr₄Fe₆O_13±, and Sr_3.6La_0.4Fe₆O _z (nominal composition) have been studied by electron microscopy. The lanthanum free material shows a microstructure containing mainly Sr₄Fe₆O_13±, with some 5 vol% Sr_1–y La _y Fe₁₂O₁₉embedded as micron-size inclusions. The lanthanum-containing material revealed a significantly different microstructure consisting of 20 vol% micron-size Sr_1–y La _y Fe₁₂O₁₉embedded in 40 vol% (Sr_0.85La_0.15)FeO_3–tetragonal perovskite, and 40 vol% of plate-shaped nano-scale intergrowths between (Sr_1–x La _x )FeO_3–and Sr₄Fe₆O_13±phases. Domains with dimensions of 20–50 nm are observed in the tetragonal perovskite when viewed along its fourfold axis. From compositional analysis it is concluded that there is little or no solubility of La in the Sr₄Fe₆O_13±phase. The observed microstructure is important input in explaining the significant effect of La addition on the transport properties of Sr₄Fe₆O_13±materials.     

Martensitic transformations in Ti-Mo alloys

A detailed investigation has been made of the structure of alloys of the Ti-Mo system containing up to 10wt% Mo, water-quenched from the-phase region. With increase in molybdenum content, the martensite structure changes from hexagonal () to orthorhombic () at 4 wt% Mo, and at 10 wt% Mo, the structure is completely retained . For alloy compositions <4 wt% Mo, there is a diffusional component in the transformation of the -phase at the quench rates employed. There is a transition, with increase in molybdenum content, in morphology (from massive to acicular) and in substructure (from dislocations to twins). However, the transitions in crystallography, morphology and sub-structure are not directly related to one another except for an abrupt loss of dislocation substructure at the/ transition. The to crystallographic transition has the characteristics of a second order transformation, and evidence has been obtained of the existence of a spinodal within the metastable orthorhombic system. The orthorhombic martensites of Ti-6 and 8 wt% Mo decompose during quenching producing a fine modulated structure within the martensite plates, consistent with a proposed spinodal mode of decomposition.     

Simulation of the Process of Water Freezing in a Round Pipe

The problem of freezing of pure water in a round pipe is treated with due regard for convection under asymmetric thermal boundary conditions in the absence of motion along the pipe. The problem is solved numerically using the control volume approach, SIMPLER algorithm, and the enthalpy method. Results are obtained for three Grashof (Gr) and six Biot (Bi) numbers: Gr = 1.55 × 10⁶, Bi = 0.305 (0 < ), Bi = 0.044 ( < 2); Gr = 1.24 × 10⁷, Bi = 0.610 (0 < ), Bi = 0.087 ( < 2); Gr = 9.89 × 10⁷, Bi = 1.220 (0 < ), Bi = 0.174 ( < 2). The correctness of calculation of the problem disregarding free-convection flows is analyzed.     

γ ? α2 Phase transformation in fractured high temperature stress rupture Ti-48Al-2Nb(at.%)

The ₂ phase transformation in fractured high temperature stress rupture Ti-48Al-2Nb(at.%) alloy has been studied by analytical electron microscopy. ₂ and phases were found at grain boundaries. ₂ layers that suspended in layers and interfacial ledge higher than 2d ₍₁₁₁₎ at /₂ interfaces were observed in the lamellar grains. These facts indicated that ₂ phase transformation and dynamic recrystallization have occurred during high temperature stress rupture deformation. It can be concluded that deformation induced ₂ phase transformation and dynamic recrystallization resulted in the presence of particles at grain boundaries. A structural and compositional transition area between deformation-induced ₂(or ) and its adjacently original (or ₂) phases was found by HREM and EDS and is suggested as a way to transform between and ₂ phase during high temperature stress rupture deformation. The transition area was formed by slide of partial dislocations on close-packed planes and diffusion of atoms.     

On internal stress and activation volume in polymers

The two-site model is developed for the analysis of stress relaxation data. It is shown that the product of d In (– )/d and (- _i) is constant where is the applied stress, _i is the (deformation-induced) internal stress and = d/dt. The quantity d In ( )/d is often presented in the literature as the (experimental) activation volume, and there are many examples in which the above relationship with (- _i) holds true. This is in apparent contradiction to the arguments that lead to the association of the quantity d In (– )/d with the activation volume, since these normally start with the premise that the activation volume is independent of stress. In the modified theory presented here the source of this anomaly is apparent. Similar anomalies arise in the estimation of activation volume from creep or constant strain rate tests and these are also examined from the standpoint of the site model theory. In the derivation presented here full account is taken of the site population distribution and this is the major difference compared to most other analyses. The predicted behaviour is identical to that obtained with the standard linear solid. Consideration is also given to the orientation-dependence of stress-aided activation.     

Complex microstructural changes in as-cast eutectoid Zn-Al alloy

Phase transformations and microstructural changes of an as-cast eutectoid Zn-Al alloy (ZnAl₂₂Cu₂) were investigated during isothermal holding. The typical dendritic structures consisted of _s phase as a core with the edge of decomposed _s phase and decomposed _s in the interdendritic regions. A series of complex phase transformations was observed. Both decompositions of _s and _s were determined at an early stage of ageing and a four-phase transformation, _f+T+, was observed at the boundaries of _f phase and the phase, instead of clearly observed at the boundaries of phase, in a solution-treated Zn-Al alloy during prolonged ageing.