LD纵向泵浦腔内倍频激光器腔参数的选择

从理论上研究了在一定长ＫＴＰ情况下ＬＤ纵向泵浦Ｎｄ：ＹＶＯ４／ＫＴＰ腔内倍频激光器的绿光输出与腔长、输出镜曲率半径及泵浦光斑半径等参数的关系。根据分析选择了一组实验参数，在入射泵浦功率为６６８．７ｍｗ时获得了１５３．９ｍｗ的绿光输出，光一光转换效率为２３％。将实验结果与理论计算值进行了比较，两者符合较好。     

LD纵向泵浦Nd：S－VAP晶体激光特性研究

Ｎｄ：Ｓ—ＶＡＰ晶体是一种新型激光工作物质。我们通过纵向ＬＤ泵浦Ｎｄ：Ｓ－ＶＡＰ晶体研究了它的激光特性，得到基横模（ＴＥＭ００）输出，泵浦阈值为１１ｍｗ，斜效率为２６．７％。     

Nd：MgO：LiNbO3晶体的荧光光谱及其双晶体腔内互倍频实验

采用激光感生荧光技术测量了Ｎｄ：ＭｇＯ：ＬｉＮｂＯ３晶体的偏振荧光光谱，简要地说明了Ｎｄ：ＭｇＯ：ＬｉＮｂＯ３双晶体腔内互倍频的基本原理，并在实验中用染料激光作泵浦源实现了其双晶体腔内互倍频运转；得到５４３ｎｍ横模倍频绿光单端输出约ＹＭＷ，腔前泵浦阈值约３８ＭＷ，总转换效率约为１．３％。     

全固化Nd：YVO4绿光激光器

本文介绍了一种新型微型全固化绿光激光器。采用激光二极管端面泵浦Ｎｄ：ＹＶＯ４激光晶体，用ＫＴＰ作为非线性倍频晶体，当泵浦光功率为３６０ｍＷ时，获得５３０ｎｍ波长、９．３ｍＷ的基横模绿光输出，总的光－光转换效率为２．４％。     

同步泵浦飞秒非临界相匹配红外光参量振荡器

采用非临界相匹配方式，制成一台同步泵浦飞秒红外光参量振荡器。其输出波长的调谐是靠改变泵浦光掺钛蓝宝石激光器的输出波长而得以实现的，其调谐范围为１．０８～１．１３ｕｍ。在９０ｆｓ．１．１ｗ左右的掺钛蓝宝石激光器的泵浦下，同步泵浦光参量振荡器的输出功率为１００ｍｗ．而脉竟只有６０ｆｓ左右。     

角调谐飞秒同步泵浦KTP红外光参量振荡器

用平均输出功率为１．１Ｗ，脉宽为９０ｆｓ的商用再生锁模Ｔｉ：Ｓａｐｐｈｉｒｅ激光器作为泵浦源，用ＫＴＰ作为非线性光学介质，制成一台同步泵浦飞秒光学参量振荡器。其输出调谐范围为１．０４μｍ至１．２６μｍ，平均输出功率在１００ｍｗ左右，脉宽仅约１００ｆｓ。     

可调谐环形单模光纤激光器

本文介绍掺饵光纤形成的环形单模光纤激光器。当使用１．４８μｍ半导体激光器作泵浦源时，可调谐谱宽可达３０ｎｍ（从１．５３μｍ到１．５６μｍ），最大输出功率＞１ｍｗ，带宽＜２ｎｍ。     

高效率Nd：YVO_4激光器的特性研究

报道激光二极管泵浦的Ｎｄ：ＹＶＯ４激光器的激光特性研究。激光晶体Ｎｄ：ＹＶＯ４厚度为１ｍｍ，基横模（ＴＥＭ００模）输出功率为２７３ｍｗ，斜率效率为４１％。     

LD泵浦Nd：YAG微片激光器的单纵模运转

继去年我们在国内首先实现了ＬＤ泵浦Ｎｄ：ＹＡＧ微片激光器的室温连续单横模运转之后，最近又观测到了稳定的单纵模输出。当泵浦电流从７００ｍＡ增加到９００ｍＡ，或当上下左右平移微片时，无论是脉冲工作，还是连续运转，均能输出单纵模，波长为１．０６４μｍ且无跳模。     

Nd：YCOB晶体的脉冲激光特性

利用氙灯泵浦Nd:Ca4YO(BO3)3晶体获得了1．06－0．53μm的自倍频激光输出,阈值泵浦能量小于3．0J,自由振荡自倍频绿光最大输出为1．08mJ。利用脉冲调Q染料激光泵浦该晶体,获得最大自由频绿光输出为1．03mJ,阈值泵浦能量小于2．00mJ。     

Room-temperature operation of quantum cascade lasers at a wavelength of 5.8 μm

The room-temperature generation of multiperiod quantum-cascade lasers (QCL) at a wavelength of 5.8 μm in the pulsed mode is demonstrated. The heterostructure of a quantum-cascade laser based on a heterojunction of InGaAs/InAlAs alloys is grown by molecular-beam epitaxy and incorporates 60 identical cascades. The threshold current density of the stripe laser 1.4 mm long and 22 μm wide is ~4.8 kA/cm² at a temperature of 303 K. The maximum power of the optical-radiation output from one QCL face, recorded by a detector, is 88 mW. The actual optical-power output from one QCL face is no less than 150 mW. The results obtained and possible ways of optimizing the structure of the developed quantum-cascade lasers are discussed.     

Low-threshold dye laser pumped by visible laser diodes

The author describes a continuous-wave (CW) dye laser has been pumped by laser diodes for the first time. Two 10-mW visible laser diodes were polarization-combined to pump a rhodamine 700 dye jet laser. The absorbed pump threshold power was 5.6 mW, and 0.28 mW of output power was produced at 758 nm. The resonator was scalable and generated over 360 mW with a slope efficiency of 57% when pumped with a DCM dye laser at 660 nm     

低功率激光二极管抽运的室温运转Yb:YAG激光器

报道了低功率激光二极管(LD)抽运的1030nm Yb:YAG全固态激光器。由于Yb:YAG为准三能级结构,自吸收损耗大,振荡阈值高,因此采用双路偏振耦合系统增加注入功率密度,并通过降低晶体掺杂浓度,选取合适晶体厚度,用半导体制冷器(TEC)有效制冷,在线性腔中实现了1030nm波长稳定输出。Yb:YAG晶体Yb离子掺杂原子数分数为8%,几何尺寸为11mm×0.7mm,晶体面对输出镜一端镀940nm高反膜,使未被吸收的抽运光反射回去,再次抽运晶体,从而提高了抽运光的利用效率,当注入功率为2W时,1030nm输出功率为192.8mW,光-光转换效率为9.6%,2h内稳定度小于3.5%。     

Alternate doping of p-type and n-type impurities for AlGaInPselfaligned stepped substrate (S3) lasers

The authors fabricated lateral pn junctions in AlGaInP by alternate doping on a stepped substrate composed of (100) and (411)A faces with Zn and Se. It was found that the alternately-doped area on the (100) face becomes a uniform n-type conduction region; this is attributed to carrier depletion in lightly Zn-doped regions. The alternately-doped area on the (411)A face becomes a uniform p-type conduction region due to strong Zn diffusion over the lightly Se-doped regions. Using alternate doping, the authors fabricated a selfaligned stepped substrate (S³) laser. The low resistivity and high-power operation (50°C 35 mW) of this laser are comparable to those of lasers fabricated using simultaneous impurity doping     

High-power broadly tunable erbium-doped silica fibre laser

A Ti:sapphire laser at 980 nm has been used to pump a grating-tuned erbium-doped silica fibre laser. 540 mW launched pump power produces up to 270 mW tunable output near 1.55 mu m, with more than 250 mW obtainable from 1.52 to 1.57 mu m.<>     

LD抽运内腔倍频532nm微型环形腔激光器的设计

简述了内腔倍频 5 32nm环形激光器的原理。根据实验要求 ,采用Nd∶YVO4和KTP作为激光晶体和倍频晶体 ,设计了可调谐的环形腔倍频激光器。实验结果表明 ,所设计的激光器最大可输出 2mW的单纵模绿光 ,绿光可调谐范围 2 0GHz ,满足设计要求。     

High-power and highly reliable 780 nm band AlGaAs laser diodes withrectangular ridge structure

A record light output power of 240 mW has been achieved for the 780 nm band AlGaAs laser diodes by using a rectangular ridge structure. The laser diodes have been operated for >1000 h at 60°C under 150 mW pulsed operation     

准连续双包层光纤激光在周期性极化铌酸锂晶体中倍频产生59mW绿光

将周期性极化晶体和双包层光纤激光相结合获得绿光激光输出,是实现高光束质量、全固化、小型化、高效率绿光激光器的一个非常有前途的方向.采用周期性极化铌酸锂晶体(PPLN)光栅周期6.5 μm,长20 mm,宽5mm,厚0.5 mm,对种子光注入式掺Yb双包层光纤激光器的准连续输出进行了倍频.研究了倍频光功率和转换效率随抽运光功率的变化关系,保持PPLN的控制温度为193.1℃,在抽运功率为650 mW时,得到6.7%的最高谐波转换效率,在抽运功率为970 mW时,得到了59 mW的最高绿光功率输出.     

Visible laser sources based on frequency doubling in nonlinearwaveguides

This paper reviews nonlinear quasi-phase-matching (QPM) waveguides and laser diodes with application to conversion of infrared laser diode wavelengths to the visible. The discussion of nonlinear QPM waveguides includes Ti-diffusion poled and E-field poled LiNbO₃ and KTP waveguides. Up to 25 mW of blue output power has been demonstrated for 120-mW infrared power injected into a nonlinear waveguide. Semiconductor laser sources suitable for frequency doubling are discussed, including distributed Bragg reflection (DBR) lasers operating at up to 200 mW output power, master oscillator power amplifiers with over 1 W output power, and wavelength-tunable flared semiconductor lasers with over 0.5 W output. A compact blue laser with 1-4 mW output power at 425-nm wavelength has been demonstrated based on a DBR laser frequency doubled in a nonlinear waveguide     

1064 nm脉冲激光前置放大器研究

采用级联波分复用的泵浦耦合方式,对平均功率0.5 mW、脉宽20 ns、重复频率50 kHz的小信号纳秒脉冲进行单模放大,采用分段泵浦技术,优化两级泵浦功率值,获得了平均功率26 mW,信噪比25 dB的脉冲输出,相应增益为17.1 dB。为高功率放大提供了性能优良的脉冲种子源。