Speed limit of all-optical gate switches using cascaded second-order nonlinear effect in quasi-phase-matched LiNbO/sub 3/ devices

In all-optical gate switches that employ the cascaded second-order nonlinear effect in quasi-phase-matched (QPM) LiNbO/sub 3/ devices, walkoff between the fundamental and second harmonic pulses is very large. The authors experimentally show that crosstalk of the switch induced by such walkoff limits the switching speed, but that the switching speed can significantly be enhanced by walkoff compensation. Using a 20-mm-long QPM LiNbO/sub 3/ waveguide device, the authors switch one of twin pulses separated by 6.25 ps without crosstalk, showing the possibility of switching a 160-Gb/s signal.     

Third harmonic generation of Nd:YAG laser light in periodicallypoled LiNbO3 waveguide

The authors propose and first demonstrate an LiNbO₃ waveguide device with cascading quasi-phase-matched second harmonic generation and quasi-phase-matched sum-frequency generation for generation of a third harmonic wave. Ultraviolet light of 355 nm wavelength, which was the shortest value ever reported for LiNbO₃ waveguide wavelength-convertors, was obtained with Nd:YAG laser light     

Increased acceptance bandwidth for quasi-phasematched secondharmonic generation in LiNbO3 waveguides

The authors demonstrate waveguide second harmonic generation using a variable-spaced phase-reversed quasi-phasematched grating that has an acceptance bandwidth 15 times greater than a uniformly quasi-phasematched interaction of the same length     

A Harmonic Rejection Filter Designed by an Exact Method

An exact design procedure for band-stop filters is used to design a transmission-line filter with one point of perfect match at a fundamental frequency and one point of infinite attenuation at a harmonic frequency. This design method is based on the mapping of the response of a low-pass prototype into that of a transmission line filter. Here a three-element Chebyshev filter is chosen as the prototype and the otherwise general procedure is adapted for the special case of rejection of the second harmonic.     

Dual-mode composite-right/left-handed transmission line ring resonator

The phase response of composite right/left-handed transmission lines is used in the design of a dual-mode ring resonator. The phase can be designed to change the spacing of the resonant modes. Simulation and measured results for a dual-mode ring demonstrate this technique. The designed structure exhibits the elimination of the singlemode resonance at the second harmonic.     

Impact of second harmonic injection on the linearity and linear gain of RF/microwave amplifiers

This article reviews the development and applications of harmonic injection technique. It discusses the impact of second harmonic injection on the linearity and linear gain of amplifiers. It reveals that amplifier characteristics and input drive level determine whether second harmonic injection enhances or reduces the linear gain of an amplifier. Furthermore, a method has been developed to predict this behaviour which can be used to identify amplifiers that are best suited to harmonic injection or build amplifiers that may particularly be used with harmonic injection. For experimental investigation, a second harmonic injected amplifier was used that employs a frequency-doubler. In laboratory experiments, third-order intermodulation distortion was suppressed by 18?dB at the expense of 0.7?dB linear gain whereas theoretical analysis has predicted that second harmonic injection could compromise the linear gain of the amplifier by up to 1.3?dB for 20?dB distortion suppression.     

基于GaN器件的连续型高效宽带功率放大器设计*

提出一种高效宽带功率放大器的设计方法,并基于GaN HEMT 器件CGH40010F 设计了验证电路。利用功放管输出寄生参数的等效网络,将基于连续型功放理论得到的负载阻抗转换到封装参考面上,并利用多谐波双向牵引技术对转换后的负载阻抗进行适当调整,使二次谐波负载阻抗位于高效率区以及基频负载阻抗能够获得高功率附加效率和高输出功率。谐波阻抗位于高效率区使得匹配网络的设计简化为基频匹配网络的设计,降低了对谐波阻抗匹配的难度和宽带匹配网络设计的复杂度。实验结果表明:在1GHz -3GHz 工作频带(相对带宽100%)内,功率附加效率在53%-64.6%之间,输出功率为39.5±2dBm,增益为11.5±2dB,二次谐波小于-15dBc,三次谐波小于-25dBc。     

Quasi-phase-matched second harmonic generation in a LiTaO3 waveguide

The authors report third-order quasi-matched (QPM) second harmonic generation (SHG) in a LiTaO₃ channel waveguide. A deep domain-inverted region is first fabricated by a proton-exchange and heat treatment technique. Then a uniform and low-pass channel waveguide is fabricated by pyrophosphoric acid proton exchange. Consequently, 12 mW of blue light is obtained at 424 nm wavelength with a conversion efficiency of 6%. The observed FWHM (full-width half maximum) temperature acceptance width for SHG power is 3.2°C and FWHM wavelength acceptance bandwidth for that is 0.2 nm. It is also shown that diffraction limited focusing of the generated blue light may be obtained     

Design of push-push and triple-push oscillators for reducing 1/f noise upconversion

In this paper, 1/f noise upconversion in push-push and triple-push oscillators is studied, and the design requirements for minimizing 1/f noise upconversion are presented. In push-push oscillators, the presence of the large second harmonic components may degrade the waveform symmetry of the oscillation waveforms, leading to the significant 1/f noise upconversion. To minimize 1/f noise upconversion in push-push oscillators, the phases of Fourier coefficients of all harmonics need to be equal. In triple-push oscillators, the waveform symmetry can easily be achieved by eliminating all even harmonic components. The experimental results show that around 15-dB phase-noise improvement at 100-kHz offset frequency can be obtained by satisfying the waveform symmetry condition in push-push and triple-push oscillators.     

Dynamics of Q-switched and mode-locked intracavity secondharmonic generation in a ring laser

The temporal dependence, spectral characteristics, and efficiency of a multimode Q-switched ring laser containing an intracavity second harmonic generator is described. Numerical studies show that such lasers are stable and efficient. Comparison with Q-switched lasers (not containing a second harmonic generator) demonstrates that the intracavity second harmonic generation lasers can be even more efficient than the fundamental laser due to nonlinear output coupling. General considerations for the operation of such lasers are described. Spectral characteristics of the output as a function of the gain of the active medium and the spectrum of the injected pulse are discussed. Instabilities at very high second harmonic conversion are observed     

Suppression of Second and Third Harmonics Using $lambda/$4 Low-Impedance Substrate IntegratedWaveguide Bias Line in Power Amplifier

In this letter, a low-impedance substrate integrated waveguide (SIW) bias line is proposed to suppress second and third harmonics in power amplifier. Such a bias line consists of a 4 low-impedance microstrip line and a shorted SIW that can operate as a radio frequency block and suppress any harmonic signals from entering the dc source. Since the frequency of the second harmonic components is lower than the inherent cutoff frequency of the SIW, second harmonic components are blocked. At the same time, third harmonic components are shorted by the shorted SIW. Measured results show that second and third harmonic components can be reduced by 25 dB and 13 dB, respectively, compared to the outcomes using conventional 4 high-impedance microstrip bias line. Also, both 1 dB compression point and power added efficiency are improved slightly.     

Nonlinear optimization tools for the design of microwave high-conversion gain harmonic self-oscillating mixers

A new optimization method is presented for the design of microwave high-conversion gain harmonic self-oscillating mixers (SOMs). It is based on the control of the harmonic content of the transistor input-voltage waveform of the self-oscillation, through the use of a nonperturbing auxiliary generator and a substitution generator. The combination of the two generators allows obtaining the optimum harmonic content of the transistor-gate voltage waveform for a maximum conversion gain. Two different downconverter circuits have been designed using this method, a second harmonic SOM and a third harmonic SOM, obtaining a high conversion gain. A good agreement between the simulated and experimental results has been found.     

MIMO组合波谐波雷达技术研究

针对传统谐波雷达自身信号泄漏大、虚警高、信噪比低、弱目标检测能力差、电磁兼容设计严格、系统复杂等问题,提出MIMO(Multiple-Input Multiple-Output)组合波谐波雷达技术。研究了MIMO 组合波谐波雷达工作原理,采用组合波接收方式,代替传统单发单收谐波雷达的二次谐波,建立了MIMO组合波谐波雷达信号模型,研究了MIMO组合波谐波雷达的成像原理及数字波束形成技术,并进行了仿真。仿真表明,MIMO组合波谐波雷达能够有效提高系统的隔离度,减少了系统设计的复杂度。利用了MIMO雷达的多自由度优势,有效提高了谐波雷达检测弱目标的能力。     

Harmonic-Suppressed Bandpass Filter Based on Discriminating Coupling

This letter presents a novel method to suppress harmonic responses of parallel-coupled bandpass filters. The harmonic suppression is based on discriminating coupling. The coupling coefficient at fundamental resonant frequency can be tuned to desirable values whereas it is zero at the second harmonic. Hence, the coupling region blocks the second harmonic but still allows the transmission of signals at passband frequency. Benefiting from this feature, the second harmonic can be suppressed without degrading the passband performance. Furthermore, no additional circuit is needed. For demonstration purpose, two example filters are implemented. The experimental results are presented to verify the proposed method.      

Photoelectric instability in optical fibre resulting in spontaneous second harmonic generation

The self-organised second harmonic generation (SHG) in optical fibres is explained as a consequence of a convective instability leading to spontaneous formation of the chi /sup (2)/ grating due to the growth of small fluctuations. The authors show that the observed SHG should be interpreted as amplification of noise.<>     

A modified beam propagation method to model second harmonicgeneration in optical fibers

A finite-difference implementation of the beam propagation method (BPM) is used to solve the paraxial, scalar wave equation with a nonlinear source term. A transparent boundary condition capable of handling asymmetric modes is incorporated in the finite-difference algorithm. This nonlinear BPM is used to model the generation and propagation of second harmonic light in an optical fiber which has been prepared for second harmonic generation (SHG) by the formation of a _χ⁽²⁾ grating. This method can be used to predict the guided mode in which the generated second harmonic light propagates based on the modes of the writing (fundamental and second harmonic) and reading (fundamental only) light. The effects of self-phase modulation (SPM) and cross-phase modulation (XPM) are included in the model     

Proximity Coupled Microstrip Patch Antenna With Reduced Harmonic Radiation

The purpose of this work is to propose a new method to suppress the harmonic radiation from a microstrip patch antenna with proximity coupled feeding line implemented in a multilayer substrate. The goal of the design is the suppression of the resonances at the 2nd and 3rd harmonic frequencies to reduce spurious radiation due to the corresponding patch modes to avoid the radiation of harmonic signals generated by non-linear devices at the amplifying stage. The study shows the possibility of controlling the second harmonic resonance matching by varying the length of the feeding line. On the other hand, the suppression of the third harmonic is achieved by using a compact resonator. This resonator consists of a printed metallization with a via connected to the ground plane (mushroom type) in a multilayer configuration. Comparing with conventional electromagnetically coupled patch antenna, the radiated power of the proposed antenna at the 2nd and 3rd harmonic frequencies is reduced by 14 dB and 8 dB, respectively.      

基于棱镜实现三倍频谐波分离

基于棱镜的色散特性,提出一种楔形窗口与聚焦透镜组合的方式,解决了高功率激光装置三倍频谐波分离所存在的问题,即三倍频的高通量传输和靶面辐照。结合“神光Ⅱ”装置多功能高能激光系统有关参数进行系统设计,确定了楔形窗口参数,并对其所引起的B积分和间距误差进行了分析。通过实验测试,三倍频传输通量由0.7～1J/cm2提高到2.8J/cm2,同时靶面三倍频和二倍频分离间距达到2.85mm,实现了高功率激光装置高通量传输的三倍频谐波分离。     

Preliminary Design of a Ka-Band Second Harmonic Gyroklystron Amplifier

The preliminary design of a Ka-band, second harmonic, three cavities gyroklystron amplifier is presented. The beam-wave interaction in the second harmonic gyroklystron amplifier is studied by using a particle-in-cell code, and the validity of the design of the microwave circuit is also discussed. The results show that this gyroklystron can produce an output peak power of over 200kW with 20dB gain and 20% maximum efficiency at 35GHz.