共查询到19条相似文献,搜索用时 93 毫秒
1.
2.
本文论述分析一种新型CD-CD变换器-固定频率钳位零电压开并准谐振DC-DC变换器的电路拓扑结构和基本原理,讨论谐振条件,并对电路工作过程进行计算机辅助分析。 相似文献
3.
4.
5.
从DC-DC变换器的技术指标出发,设计了一种大负载输出集成变换器。针对峰值电流模控制下,占空比>50%出现的次谐波振荡问题,引入了斜坡补偿电路。通过采用自适应斜坡补偿电路,提高系统带负载能力。利用动态箝位电路,消除斜坡补偿对带载能力的影响,有效提高了芯片输出电流的能力 相似文献
6.
讨论了航天DC-DC混歙订成电路的拓朴结构。通过对几种电路的性能比较,提出了适合航天应用的DC-DC变换器的最佳拓朴结构。论述了PWM-LIN变换器的控制方法,该方法对于确保二次稳压DC-DC变换器较高的功率具有重要意义,亦可大大提高混合集成电路的成品率。 相似文献
7.
基于Zeta变换器的单相功率因子校正电路 总被引:1,自引:0,他引:1
分析了基于Zeta变换器的功率因子校正(PFC)电路;研究了工作在不连续导电模式的Zeta变换器实现功率因子校正的机理;推导出了保证电路实现功率因子接近1的临界电感值。SPICE仿真和实验结果都证明了理论分析是正确的,为设计功率因子校正的Zeta变换器提供了理论依据。 相似文献
8.
本文介绍了一输出电压为160V的小型DC/DC变换器的电路设计及产品性能。并详细叙述了这种开关型DC/DC变换器中,高频升压变压器的设计方法以及为抑制噪声,提高电路保护能力所采取的措施措施。 相似文献
9.
为强化DC/DC变换技术的实践教学,基于多绕组变压器和反激电路原理,开发一套DC/DC变换器教学系统。设计变换器的拓扑结构,分析工作原理及控制策略,计算变换器系统参数,建立数字仿真模型,设计变换器主电路、输出电压采样电路、开关管驱动电路等来搭建变换器实验平台。实验教学应用表明,该变换器实现宽输入/输出电压范围功能的同时,能够提高学生的电力电子技术综合实践能力。 相似文献
10.
11.
Bor-Ren Lin 《International Journal of Electronics》2013,100(8):1332-1345
The main objective of this paper is to present a direct current to direct current topology with high circuit efficiency. In this studied circuit, two full-bridge circuits and a half-bridge circuit connected in parallel are introduced to achieve the advantages of low switching loss, less primary current, low conduction loss and low filter size compared to the traditional parallel full-bridge converters. The circuit diagram, operation principles, steady-state analysis and experiments are provided to demonstrate the effectiveness of the studied topology. Finally, a 1.44-kW laboratory prototype is constructed to verify the validity of the theoretical analysis. Experimental results show that highest efficiency of 95.3% can be achieved. 相似文献
12.
The proposed circuit is a multiple output quasi-resonant (QR) zero-current switching (ZCS) switched-capacitor (SC) converter with a bidirectional power flow control conversion scheme. The principles of the proposed multiple output QR ZCS SC bidirectional dc–dc converter are described using a detailed circuit model for analysis. Simulation and experimental results are carried out to verify the validity and the soft switching performance of the proposed converter. The maximum efficiency achievable is about 94 and 92% for the forward and reverse power flow control schemes, respectively. The output voltage can be regulated by changing the switching frequency for the designed compensated closed-loop controller. 相似文献
13.
设计了一种可以与晶体管跨导运算放大器特性高度比拟的运放宏模型.用该宏模型替换采样/保持电路和MDAC模块中的晶体管级放大器电路,进行FFT分析;在仿真结果相差3.2%的情况下,仿真时间为原来的1.7%,大大缩短了流水线ADC的验证周期.在该方法的指导下,设计了一个10位20 MS/s 流水线A/D转换器.在2.3 MHz输入信号下测试,该A/D转换器的ENOB为8.7位,SFDR为73 dBc;当输入信号接近奈奎斯特频率时,ENOB为8.1位. 相似文献
14.
在开关电源中,加入有源功率因数校正电路,可使功率因数达到0.99以上,并把电源输入电流的波形失真减小到5%以下,大大减小开关电源对电网的污染。IR1150是有源功率因数校正电路专用控制器,其采用单周期控制原理,控制电路简单,易于设计、调试,可大大减小体积、降低成本。文中详细介绍了IR1150的内部电路,管脚排列及功能,还详细分析、设计出400 W的样机。 相似文献
15.
16.
ABSTRACTAn interleaved frequency control soft switching converter is studied for solar power or fuel cell power applications. The proposed circuit topology contains two parallel current-fed circuit cells with interleaved pulse-width modulation operation. Thus, the ripple currents at input and output terminals are decreased. In each circuit cell, the proposed current-fed dc-dc converter includes boost circuit and resonant circuit to achieve current ripple-free on low voltage side and less switching losses on active devices. The boost circuit and the resonant circuit have same active devices to decrease power switches. Due to the resonant behaviour, the reverse recovery current loss on secondary diodes is removed. The voltage doubler circuit topology is accomplished on secondary-side to reduce diode counts and conduction loss. The performance and effectiveness of the developed interleaved PWM current-fed converter are verified and confirmed by experiments. 相似文献
17.
介绍一种为反激式DC-DC开关电源设计的限流电路,通过限流对芯片工作的模式切换进行控制,同时为芯片提供过流保护。首先,如果连接在外部限流引脚的限流电阻Rx不变,内部限流电路采用温度补偿技术使得限流值随温度的变化最小。其次,通过调节限流电阻Rx的阻值,使芯片的参考限流值控制在初始限流值的30%~100%之间。最后,分别介绍了限流设定和限流比较模块电路的设计方法和工作原理,实现了通过限流电路对开关电源工作模式的判别和控制。最后,给出了相应的TSMC 0.5 um工艺下的仿真结果,并对仿真结果进行分析。 相似文献
18.
介绍了一种高精度电荷平衡式电压频率转换器的电路设计与工艺制作,并给出研究结果。设计的电路输入电压范围为0~10MHz,在满刻度为1MHz下,其非线性度小于0.5%。该电路可广泛应用于航空、航天、雷达、通讯、导航以及远距离传输等领域。 相似文献