共查询到20条相似文献,搜索用时 62 毫秒
1.
2.
横摆力矩和主动前轮转向结合的车辆横向稳定性模糊控制仿真 总被引:1,自引:0,他引:1
提出一种基于横摆力矩和主动前轮转向相结合的车辆横向稳定性控制方法,以横摆角速度和侧偏角为控制目标,利用前馈补偿和模糊控制产生横摆力矩和附加的前轮转角,通过控制制动力的分配以及对转向角的修正,使车辆转向行驶时的横摆角速度和侧偏角很好地跟踪参考模型.对转向轮阶跃输入和正弦输入两种工况分别进行了仿真研究,采用横摆力矩和主动前轮转向相结合控制方法,车辆转向时的瞬态及稳态响应优于单独的横摆力矩控制,表明该方法能有效地控制车辆横摆角速度和侧偏角,提高车辆转向时的横向稳定性,同时能有效地减轻驾驶员操纵负担. 相似文献
3.
4.
研究汽车转向稳定性控制问题.针对线控转向系统的可变转向特性对汽车操纵稳定性的影响,为保证行驶安全,建立基于车辆横摆角速度与稳态横摆角速度之差(反馈系数F1)以及车辆侧向加速度与理想侧向加速度之差(反馈系数F2)反馈的驾驶员模型.结合整车模型和综合评价指标函数,分别对反馈系数F1(F2=0)、F2(F1 =0)和F1、F2进行优化,对线控转向系统的行驶状态进行仿真并与无反馈控制的驾驶员模型进行了比较.仿真试验结果表明:基于侧向加速度与横摆角速度共同反馈的方法,对前轮转角进行补偿,可较好的控制车辆的侧向位移、侧向加速度、横摆角速度和质心侧偏角,提高车道跟踪性能、方向稳定性能、降低驾驶员的转向负担,提高汽车的操纵稳定性. 相似文献
5.
李志明 《计算机测量与控制》2014,22(10):3353-3355
为了提高车辆的操稳性,提出了新型主动前轮独立转向系统,介绍了主动前轮独立转向的工作原理和结构形式,建立了系统数学模型;提出了主动前轮独立转向的控制策略,上层控制器采用PI控制,由横摆角速度偏差得出总控制转角,下层控制器负责内外侧转向轮的判断以及计算内外侧转向轮具体的转角;在仿真软件MATLAB/Simulink里进行了控制策略有效性仿真,仿真结果说明对于不足转向车辆,主动前轮独立转向系统能比传统的主动前轮转向系统更有效地提高车辆操纵稳定性。 相似文献
6.
无人驾驶探测车是探测行星表面和地下未知世界的重要工具。它所面临的环境非常复杂,转向机构的性能直接关系到探测任务的成败。为了研究六轮探测车的转向特性,该文建立丁它的运动模型,按照质心零侧偏角控制策略进行了合理简化。分析了其稳态响应特性;同时得到了质心侧偏角、横摆角速度、侧向加速度与前轮转角的传递函数,在此基础上,对研究的样车进行了前中后轮转角成比例控制的六轮转向车辆的运动学仿真,并与四轮转向和前轮转向进行了对比。结果表明,六轮转向小车的瞬态响应特性更为优越,对提高小车的转向性能非常有利。该结果可为结构设计提供参考。 相似文献
7.
为提高传统线控转向车辆转向稳定性,提出一种基于相平面预警边界的主动安全控制策略。首先,建立质心侧偏角与质心侧偏角速度■相平面图;其次,针对传统相平面稳定区域划分所用双线法在低路面附着系数时存在不足,提出“平行四边形“边界法改善相平面稳定区域的划分,并以稳定域边界建立预警边界模型。然后基于预警边界设计线控转向主动安全控制器,设计预警度PID控制器和横摆角速度滑模控制器联合决策横摆力矩,以保持车辆稳定行驶,避免失稳状态从而起到主动安全作用;最后,结合Simulink和CarSim联合仿真结果表明,控制器能够有效避免线控转向车辆失稳,提高了主动安全性。 相似文献
8.
9.
4WS整车虚拟样机建模与动力学仿真 总被引:1,自引:0,他引:1
为了改善汽车在高速行驶转弯时的操纵稳定性,运用动力学仿真软件ADAMS,在其专业汽车模块ADAMS/CAR下研究了4WS汽车建模及其瞬态和稳态操纵动力学特性。以质心侧偏角和横摆角速度响应为评价指标,在角阶跃输入下高速转弯时,对前后轮转角成比例关系的4WS汽车和FWS汽车分别做了动力学仿真研究。对比分析了两者的质心侧偏角和横摆角速度响应特性,从分析结果得出,后轮主动参与转向,总体上有助于改善汽车在高速行驶转弯时的动力学响应特性,但是不同的因素也会对操纵稳定性产生不利的影响。 相似文献
10.
11.
S. Shaw 《Journal of Computer Assisted Learning》1993,9(2):93-99
Abstract This paper describes an approach to the design of interactive multimedia materials being developed in a European Community project. The developmental process is seen as a dialogue between technologists and teachers. This dialogue is often problematic because of the differences in training, experience and culture between them. Conditions needed for fruitful dialogue are described and the generic model for learning design used in the project is explained. 相似文献
12.
European Community policy and the market 总被引:1,自引:0,他引:1
C. Lloyd 《Journal of Computer Assisted Learning》1993,9(2):86-91
Abstract This paper starts with some reflections on the policy considerations and priorities which are shaping European Commission (EC) research programmes. Then it attempts to position the current projects which seek to capitalise on information and communications technologies for learning in relation to these priorities and the apparent realities of the marketplace. It concludes that while there are grounds to be optimistic about the contribution EC programmes can make to the efficiency and standard of education and training, they are still too technology driven. 相似文献
13.
融合集成方法已经广泛应用在模式识别领域,然而一些基分类器实时性能稳定性较差,导致多分类器融合性能差,针对上述问题本文提出了一种新的基于多分类器的子融合集成分类器系统。该方法考虑在度量层融合层次之上通过对各类基多分类器进行动态选择,票数最多的类别作为融合系统中对特征向量识别的类别,构成一种新的自适应子融合集成分类器方法。实验表明,该方法比传统的分类器以及分类融合方法识别准确率明显更高,具有更好的鲁棒性。 相似文献
14.
Wayne O’Brien Author Vitae 《Journal of Systems and Software》2008,81(11):1997-2013
Development of software intensive systems (systems) in practice involves a series of self-contained phases for the lifecycle of a system. Semantic and temporal gaps, which occur among phases and among developer disciplines within and across phases, hinder the ongoing development of a system because of the interdependencies among phases and among disciplines. Such gaps are magnified among systems that are developed at different times by different development teams, which may limit reuse of artifacts of systems development and interoperability among the systems. This article discusses such gaps and a systems development process for avoiding them. 相似文献
15.
16.
This paper presents control charts models and the necessary simulation software for the location of economic values of the control parameters. The simulation program is written in FORTRAN, requires only 10K of main storage, and can run on most mini and micro computers. Two models are presented - one describes the process when it is operating at full capacity and the other when the process is operating under capacity. The models allow the product quality to deteriorate to a further level before an existing out-of-control state is detected, and they can also be used in situations where no prior knowledge exists of the out-of-control causes and the resulting proportion defectives. 相似文献
17.
潘丽 《自动化与仪器仪表》2014,(7):80-82
自然界的绝大部分信号都是以模拟的形式存在,因此模拟信号的采集转换存储在数字时代十分关键。文章讨论了在雷达信号处理领域基于AD9626的AD采集存储卡的设计原理、硬件结构和程序设计与芯片配置等问题,为今后相关领域的研究提供了可参考的方案。 相似文献
18.
张涛 《计算机测量与控制》2015,23(1):86-89
为了设计一种具有低成本、低功耗、易操作、功能强且可靠性高的煤矿井下安全分站,针对煤矿安全生产实际,文章提出了采用MCS-51系列单片机为核心、具有CAN总线通信接口的煤矿井下安全监控分站的设计方案;首先给出煤矿井下安全监控分站的整体构架设计,然后着重阐述模拟量输入信号处理系统的设计过程,最后说明单片机最小系统及其键盘、显示、报警、通信等各个组成部分的设计;为验证设计方案的可行性与有效性,使用Proteus软件对设计内容进行仿真验证,设计的煤矿井下安全监控分站具有瓦斯、温度等模拟量参数超标报警功能和电机开停、风门开闭等开关量指示功能;仿真结果表明:设计的煤矿井下安全监控分站具有一定的实际应用价值. 相似文献
19.
Going through a few examples of robot artists who are recognized worldwide, we try to analyze the deepest meaning of what
is called “robot art” and the related art field definition. We also try to highlight its well-marked borders, such as kinetic
sculptures, kinetic art, cyber art, and cyberpunk. A brief excursion into the importance of the context, the message, and
its semiotics is also provided, case by case, together with a few hints on the history of this discipline in the light of
an artistic perspective. Therefore, the aim of this article is to try to summarize the main characteristics that might classify
robot art as a unique and innovative discipline, and to track down some of the principles by which a robotic artifact can
or cannot be considered an art piece in terms of social, cultural, and strictly artistic interest.
This work was presented in part at the 13th International Symposium on Artificial Life and Robotics, Oita, Japan, January
31–February 2, 2008 相似文献
20.
Jacob Palme 《Software》1979,9(9):741-747
The COM teleconferencing system was designed to be easy to use for both beginners and people with much computer experience. A number of design choices in organizing the human-computer interface were considered very carefully. These design problems are not unique for teleconferencing applications, but will appear in many other developments of human-computer interfaces for non-computer specialists. This report discusses naming conventions, menu format, user commands, help facility and the treatment of ‘type ahead’ from the users. 相似文献