共查询到20条相似文献,搜索用时 390 毫秒
1.
介绍了运用计算机系统及VB编程技术、实现机组运行过程中热工参数等实时监测和机组运行经济性的在线计算的监测系统。该系统应用研华工控机采用智能数据采集网络,以VB6.0为核心结合各种编程语言编制专用软件。可实时监测运行参数,并判断运行参数的正确性,可为运行人员及管理人员提供操作和决策上的可靠依据。 相似文献
2.
为确保220 kV浑河变电所监控系统的可靠、高效运行,将网络技术、通信技术和计算机技术综合应用于变电站自动化系统中,并接入网络.采用基于B/S的三层体系结构,将运行监测与办公管理融为一体,实现了调度管理部门对继电保护信息监测与管理的双重需求.实例应用结果表明.该系统可大幅降低运行人员的劳动强度,为变电站的无人值班奠定了基础. 相似文献
3.
介绍汽轮发电机组在线监测与故障诊断系统,分析了该系统的基本组成、主要功能以及实现方法。该系统集成了传感器技术、信号处理技术、故障诊断技术和网络技术等先进技术,已在十多家电厂运行多年,并不断获得改进,现成为比较完善的系统,是今后我们进一步发展状态检修的基础。 相似文献
4.
大型电站性能监测分析与诊断技术研究 总被引:2,自引:3,他引:2
针对大型火力发电站这一复杂系统探讨了热力、机械、电气与效率的联合监测与诊断技术,通过对火电站热力系统的模型分析,效率计算,锅炉、汽轮机、发电机等设备的监测与诊断,建立了一个大型火电站分布式智能监测与诊断“原型系统”。“原型系统”是在微型计算机网络环境下,采用C语言实现,并利用仿真模型在实验室条件下对所开发的原型系统进行了试验与验证,给出了原型系统状态监测、数据分析与故障诊断的运行结果。 相似文献
5.
6.
7.
8.
《电力信息与通信技术》2015,(6)
根据同步发电机励磁控制系统的典型监测和控制功能,在满足励磁控制需求的基础上,文章基于TCP/IP网络通信协议开发了网络化监测和控制软件,给出了一种在Internet环境下基于虚拟专用网络(Virtual Private Network,VPN)技术的励磁系统远程监测和控制实施方案。实际测试表明,文章所设计的系统不仅能够实现励磁系统重要参数和状态的实时监测,而且能够进行故障报警等重要数据的采集,同时能够实现运行参数的修改和运行模式的控制。 相似文献
9.
10.
11.
12.
This paper presents a comparative study of sliding mode, artificial neural network and model reference adaptive speed observers for a speed sensorless permanent magnet synchronous generator (PMSG) in wind energy conversion system (WECS). Wind velocity and position sensorless operating methods for wind generation system using observer are proposed only by measuring phase voltages and currents. Maximum wind energy extraction is achieved by running the wind turbine generator in variable-speed mode. In addition the three speed observers are compared to verify the robustness against parameter variations. 相似文献
13.
西气东输工程燃气轮机驱动压缩机组控制系统负荷控制功能不完善,造成机组在压力自动控制模式下,燃机、压缩机的转速和排气温度等重要参数在运行过程中极不稳定,并呈现周期性振动特性,对燃机重要部件造成严重的低周疲劳损伤。本文对机组的控制方式进行了研究,分析了机组功率、转速、排气温度波动的机理,通过合理调整控制器参数解决了机组关键参数波动的问题,显著改善了机组的运行稳定性和可靠性,对于提高机组的使用寿命、降低热部件的疲劳损耗具有主要作用。所做工作对机组控制系统的设计和调整具有参考价值。 相似文献
14.
15.
The difference in dynamic behaviour of wind turbines connected to different size networks is analysed for synchronous and induction generators. Modal analysis has been applied to equivalent mechanical models of the wind turbine generator and the grid connection to show the difference in dynamics for a wind turbine generator connected to a large (interconnected) utility network or an (isolated) diesel micro-grid. Frequency domain analysis of these models has been used to quantify the effect of system parameters, such as enhanced drive train damping, diesel governor action and generator slip, on dynamic interaction. It has been shown that for wind turbines connected to a large grid an induction generator can reduce dynamic interaction. In contrast, for an isolated diesel micro-grid the diesel governor response and the compliance of the diesel generator dominate the system's dynamics, and the choice of either generator option for the wind turbine is dictated by other factors. 相似文献
16.
17.
为研究风气互补发电系统对电网的影响,首先搭建了由风电机组、燃气轮机、电网线路、静止无功补偿器、电力系统稳定器和大型水力发电机组成的仿真系统,并对该系统的负载侧和电网线路中部节点进行了稳定性分析。仿真结果表明,电网在加载了风气互补系统后运行能保持稳定,并能在发生短时故障后恢复到原来状态。该文为进一步研究风气互补系统与电网的相互影响提供了良好的模型基础。 相似文献
18.
燕山铜铁公司2号高炉送风机的拖动系统由电机拖动改为汽轮机拖动后,由于管道;中洗油质太脏导致启动不顺利,处理后发生联轴器长度设计不合理导致风机振动大;更改联轴器长度后,经过现场动平衡和调整高调机构间隙后,机组整体运行状态良好。 相似文献
19.
Yoichi Kinoue Toshiaki Setoguchi Tomohiko Kuroda Kenji Kaneko Manabu Takao Ajit Thakker 《热科学学报(英文版)》2003,12(4):323-327
The Wells turbine for a wave power generator is a self-rectifying air turbine that is available for an energy conversion in an oscillating water-air column without any rectifying valve. The objective of this paper is to compare the performances of the Wells turbines in which the profile of blade are NACA0020, NACA0015, CA9 and HSIM15-262123-1576 in the small-scale model testing. The running characteristics in the steady flow, the start and running characteristics in the sinusoidal flow and the hysteretic characteristics in the sinusoidal flow were investigated for four kinds of turbine. As a conclusion, the turbine in which the profile of blade is NACA0020 has the best performances among 4 turbines for the running and starting characteristics in the small-scale model testing. 相似文献
20.
水轮发电机组的直接自适应模糊控制 总被引:3,自引:0,他引:3
提出了一种新颖的直接自适应模糊控制方法。基于筒化了的T-S(Takagi-Sugeno)模糊推理规则,采用神经网络权值的联想式学习修正方法,对T-S模糊推理规则进行在线修正,给出了盯应的神经网络实现结构,从而实现了不需要建立受控对象模型的直接自适应模糊控制。对一混流式水轮机组的仿真控制实验结果证明了所提出方法具有设计简单、鲁棒性强的优点,能适应水轮机组在不同工况下的控制要求。 相似文献