共查询到19条相似文献,搜索用时 187 毫秒
1.
2.
3.
目前,不少焦化厂仍采用饱和器法生产硫铵。饱和器法的主要缺点之一,是生产的硫铵颗粒比较细,除了给硫铵的贮存和运输带来困难外,还影响到农田的施肥并降低肥效。因此,生产大颗粒硫铵,仍然是改善硫铵质量的重要问题。几年来,我们厂在这方面做了一些工作,并收到了一定的效果。 一、原因分析 相似文献
4.
本文从理论上分析了饱和器内铜质结晶管和母液喷射管腐蚀破坏的原因,并用电子能谱和扫描电镜两种实验方法测定了腐蚀产物的组成成份,从而提出了结晶管和母液喷射管的初步防腐措施。 相似文献
5.
6.
分析了3种水合物合成反应器(搅拌式反应器、鼓泡式反应器和喷淋式反应器)的原理及特点。提出了一种水合物快速、高效制备的新型工艺———喷淋-鼓泡装置和喷淋-搅拌装置双级串联系统,介绍了工艺流程,建立了水合物制备仿真监控系统。介绍了水合物的分解。 相似文献
7.
本文根据热力学和传热学理论,考虑因水蒸发或凝结而引起的喷淋水量和空气含湿量沿蒸发式冷凝器高度的变化,建立蒸发式冷凝器的热质传递数学模型,并对模型进行了合理简化,推导出描述这一热质传递过程常微分方程组的分析解。所得分析解给出了蒸发式冷凝器高度上空气含湿量、比焓、温度和水温等各参数的分布情况,并讨论了空气质量流量、喷淋水量等参数对蒸发式冷凝器换热性能的影响。蒸发式冷凝器数学模型的解析解可用于蒸发式冷凝器传热传质性能的理论分析及设计校核计算,具有较高的理论及应用价值。 相似文献
8.
为进一步研究压缩机能耗及蒸发式冷凝器换热性能,本文采用对比实验的方法,研究了冷凝器进风温度,进风湿度以及喷淋水量等因素对空冷与蒸发式冷凝器的压缩机能耗及换热性能的影响。通过研究表明,冷凝器进风空气湿度对压缩机耗功量的影响较小,而压缩机耗功量随进风温度的增加而增加,随喷淋水量增加呈先减小后增加的趋势,喷淋水量在不同的进风温度工况下存在最佳值,蒸发式冷凝器管外复合换热系数随进风温度的增加而递减,随喷淋水量增加而增大。 相似文献
9.
王瑞李先庭石文星王宝龙宋鹏远 《暖通空调》2016,(7):63-69
溶液喷淋换热器广泛应用于从空气中吸热、吸湿的各类暖通空调系统中。针对溶液喷淋在暖通空调领域的应用现状,分别从溶液喷淋除湿系统、溶液喷淋式无霜空气源热泵和溶液喷淋式全热回收3个方面介绍了国内外相关的研究工作,并提出了一些今后溶液喷淋系统的研究方向。 相似文献
10.
11.
The paper deals with the air composition in pressure saturators used for dissolved air flotation. Two mathematical models are developed: a kinetic model for describing the change in saturator air composition with time from start-up to eventual equilibrium, and an abbreviated model for only predicting the saturator air composition once equilibrium is reached. Both derivations are based on mole balances for the two major components of atmospheric air, nitrogen and oxygen, and the equilibrium between saturator air and outflowing water as predicted by Henry's law. The models take factors into account which had hitherto been ignored, such as saturator efficiency, saturator pressure and the oxygen saturation level in the incoming water. The kinetic model gives a clear demonstration of the changes in air composition after saturator start-up and how different operating parameters affect the rate of change. It is demonstrated that laboratory saturators, operated at low hydraulic loading, could take many hours to attain equilibrium, which could explain anomalous measurements reported in the literature. Both mathematical models were tested with data collected from a laboratory saturator operated under conditions similar to those encountered at full-scale. The experimentally determined values agree well with the predicted results, with the exception that the actual saturator air composition converges towards an equilibrium concentration which is slightly less enriched in nitrogen than predicted by the theoretical models. 相似文献
12.
The performance of laboratory-scale dissolved air flotation plants treating abattoir wastewater has been measured for saturator pressures from 100 to 500 kPa, wastewater suspended solids concentrations from 170 to 2100 mg 1−1 and air-to-solids ratios from 0 to 0.17. Maximum removal efficiencies for chemical oxygen demand, suspended solids and fat were 70, 50 and 95% respectively, at high wastewater suspended solids contents and high air-to-solids ratios. Pressure did not greatly influence the size of the bubbles generated in the process, or the removal efficiencies. High air-to-solids ratios were necessary to obtain maximum removal efficiencies and to prevent appreciable settling of the suspended solids. 相似文献
13.
为研究Q190s喷涂型高强聚脲材料对结构抗冲击性能的影响,对Q190s喷涂型高强聚脲材料的常规性能与热力学性能进行了试验研究,并制作了6块聚脲-钢板复合结构,以研究聚脲-钢板复合结构在落球冲击作用下的抗冲击性能,并利用有限元软件ANSYS/LS-DYNA对相应结构进行了有限元分析。试验结果表明,Q190s型聚脲材料具有良好的抗冲击能力,且不同的喷涂方式对聚脲-钢板复合结构的抗冲击性能具有不同影响。有限元结果与试验结果吻合较好,验证了有限元模拟的准确性与试验的真实性。 相似文献
14.
15.
16.
SARS病疫的肆虐和对HVAC设计规范的思考 总被引:1,自引:0,他引:1
就新风量的设计标准 ,空气过滤要求与过滤器的设计选用 ,送风量与排风量的平衡 ,军团菌与喷淋式冷却塔 ,及制冷系统与制冷机房的安全设计与安全运行等 5个问题 ,对国家标准《采暖通风与空气调节设计规范》报批稿提出了应急修改建议 ,供有关主管部门研究考虑和同行讨论。 相似文献
17.
18.
介绍了芯模振动制管工艺及径向挤压制管工艺的原理及优缺点,通过对两种制管工艺的原材料与技术经济指标等进行对比分析,指出了芯模振动制管工艺具有成本低、管子质量好、制管种类多等优点,但其表面光洁度不如径向挤压制管工艺。此外,对两种制管工艺制管时产生裂缝的原因、模具要求、芯模振动制管工艺的振动频率等问题进行了探讨,并提出各企业应根据自身情况及工艺特点选择合适的制管工艺。 相似文献
19.
介绍了采用厌氧-SBBR工艺处理焦化废水的材料、工艺流程及方法,研究了该工艺的可行性,确定了最佳运行参数,并与单一的SBBR工艺进行了比较,提出厌氧-SBBR工艺的优势,从而进一步推广该工艺的应用。 相似文献