共查询到19条相似文献,搜索用时 963 毫秒
1.
将双级矩阵变换器(two-stage matrix converter,TSMC)作为感应电机的驱动装置,针对传统矢量控制中感应电机参数变化造成控制系统解耦不充分的问题,提出了基于合成矢量的TSMC驱动感应电机电流控制策略。对TSMC与感应电机合成矢量的数学模型进行推导和合理的简化。利用合成矢量根轨迹法设计出一种基于复数比例–积分控制器的电流闭环控制系统,解决了随着系统频率增加控制系统控制性能大大下降的问题,并降低了常规解耦控制系统对电机参数的依赖性。仿真结果表明:TSMC能提供满足感应电机调速要求的高质量输出电压和电流,所提出的控制策略能有效改善控制系统的动态和稳态性能。 相似文献
2.
本文结合矩阵变换器、双馈感应电机(DFIG)风力发电系统的优点,导出了双馈电机风力发电系统在同步旋转dq坐标轴下的矢量控制数学模型;针对常规矢量控制中存在电流耦合情况,设计一种新型、简易的电流前馈解耦控制方案.在此基础上,建立基于矩阵变换器交流励磁磁场定向电流解耦矢量控制策略.MATLAB仿真结果表明,当有功、无功功率变化时,电流解耦控制具有良好动态性能.本文设计了11kW风力发电试验装置并进行离、并网实验,当双馈电机处于亚同步、超同步状态时,双馈电机定子电压和频率均能保持稳定,实现变速恒频运行.实验结果表明,基于矩阵变换器交流励磁双馈风力发电系统是可行的,并具有一定的实用价值. 相似文献
3.
介绍了一种拓扑结构与众不同的矩阵变换器--间接式矩阵变换器,并将其应用于感应电机矢量控制系统.在详细介绍间接式矩阵变换器的工作原理、控制策略及换流方法的基础上,将间接式矩阵变换器与感应电机矢量控制理论相结合,提出一种新颖的感应电机矢量控制系统.该系统在实现对电机矢量控制的同时,能够实现能量的双向传递,减少电网的谐波污染,同时又可以使电网侧的双向开关在零电流时动作,无需采用四步换流策略,由此降低了控制过程的复杂性.最后,利用Matlab软件对所提系统进行仿真,仿真结果验证了该系统的可行性. 相似文献
4.
无刷双馈电机(BDFM)调速系统可以大大降低调速装置的容量,在大功率调速系统中有着广阔的应用前景,但由于缺乏有效的控制策略,阻碍了其应用和推广,因此迫切需要新型的控制策略来改善其性能,以扩大其应用范围。在同步参考系的矢量解耦数学模型基础上,利用同步角和转矩的关系,提出了一种简单实用的矢量解耦控制,采用这种控制方法,使BDFM的矢量控制变得与普通感应电机的矢量控制一样简单,能用于调速性能要求较高的调速系统。 相似文献
5.
6.
7.
8.
9.
提出了一种T型三电平逆变器馈电双三相PMSM驱动系统直接转矩控制(DTC)策略。该系统既具有多相电机转矩脉动小、电流应力小和故障容错能力强的优点,也继承了T型三电平电机驱动谐波性能好、可靠性高的特点。该文所提出的基于双空间矢量调制(SVM)技术的直接转矩控制策略保留了DTC快速动态响应特性。与基于空间矢量解耦(VSD)的SVM技术相比,双SVM技术避免了复杂的矢量合成过程,并具有良好的谐波控制效果。所提出的控制策略还设计了谐波电流闭环控制器,能够有效抑制由绕组不对称、反电动势谐波、死区等非线性因素引起的低次谐波电流。通过实验验证了所提出的T型三电平逆变器馈电双三相PMSM驱动系统DTC策略的有效性。 相似文献
10.
11.
永磁同步电机是典型的非线性多变量强耦合系统,在同步旋转坐标系下dq轴电流存在耦合,传统的PI控制器无法实现解耦,提出一种基于内模控制原理和空间矢量算法相结合的高性能永磁同步电机解耦控制方法,用内模控制策略控制理想电机模型,对定子电流交叉耦合电势动态解耦,提高系统的动态响应性能,同时在整个电流闭环过程中对参数摄动和外扰动具有良好的鲁棒性,这种方法不需要额外的电机参数和检测硬件,实验结果验证了方法有效可行。 相似文献
12.
I Introduction Matrix converter(MC)is a modern energyconversion device that has been developed over the lastthree decades[1~5].Matrix converter fed motor drive issuperiorto pulse width modulation(PWM)inverter drivessince it provides bi-directional power f… 相似文献
13.
14.
15.
研究了一种适用于矩阵变换器供电的异步电机调速系统组合控制策略.同时实现了矩阵变换器的空间矢量调制和异步电机的定子磁场定向直接转矩控制(DTC).通过Matlab软件仿真和电力电子实验平台上的试验结果表明,采用这一控制策略的调速系统具有良好的静、动态性能,并且保持了单位功率因数. 相似文献
16.
Plunkett Allan B. D'Atre John D. Lipo Thomas A. 《Industry Applications, IEEE Transactions on》1979,(4):430-437
Conventional methods of controlling an induction motor utilize regulation of stator current and motor slip frequency in order to maintain system stability. This control strategy requires a shaft speed feedback and fast-response current regulation. An alternative method of controlling an induction motor is presented which achieves the necessary system stabilization by controlling only the motor frequency. The control inherently regulates the motor torque angle by properly adjusting the phase of the converter firing signals. By synchronizing the inverter firing pulses to the motor back electromotive force (EMF) possible adverse inverter operating modes are avoided. The concept of synchronous control eliminates the preprogrammed functional relations previously required and allows the control to adapt to any desired motor flux level. Any desired outer regulating loop can be incorporated to form a fast-response wide-range ac drive system. 相似文献
17.
18.
19.
Bojoi R. Lazzari M. Profumo F. Tenconi A. 《Industry Applications, IEEE Transactions on》2003,39(3):752-760
A direct rotor-field-oriented control of a dual-three phase induction motor drive is described in this paper. The induction machine has two sets of stator three-phase windings spatially shifted by 30 electrical degrees. The stator windings are fed by a current-controlled pulsewidth-modulation (PWM) six-phase voltage-source inverter. Three key issues are discussed: (1) the machine dynamic model is based on the vector space decomposition theory; (2) the PWM strategy uses the double zero-sequence injection modulation technique which gives good results with low computational and hardware requirements; and (3) to eliminate the inherent asymmetries of the drive power section, a new current control scheme is proposed. Experimental results are presented for a 10-kW dual three-phase induction motor drive prototype. 相似文献