The size and density of Ag nanoparticles on n-layer MoS2 exhibit thicknessdependent behavior. The size and density of these particles increased and decreased, respectively, with increasing layer number (n) of n-layer MoS2. Furthermore, the surface-enhanced Raman scattering (SERS) of Ag on this substrate was observed. The enhancement factor of this scattering varied with the thickness of MoS2. The mechanisms governing the aforementioned thickness dependences are proposed and discussed.
In-plane symmetry is an important contributor to the physical properties of two-dimensional layered materials, as well as atomically thin heterojunctions. Here, we demonstrate anisotropic/isotropic van der Waals (vdW) heterostructures of ReS2 and MoS2 monolayers, where interlayer coupling interactions and charge separation were observed by in situ Raman-photoluminescence spectroscopy, electrical, and photoelectrical measurements. We believe that these results could be helpful for understanding the fundamental physics of atomically thin vdW heterostructures and creating novel electronic and optoelectronic devices.
Hexagonal ultrathin WO3 nano-ribbons (HUWNRs) of subnanometer thicknesses, 2–5 nm widths, and lengths of up to several micrometers were prepared by a solvothermal method. The as-prepared HUWNRs grow along the [001] direction, and the main exposed facet is the (120) crystal plane. The HUWNRs exhibit good electrochemical performance as an anode material in lithium ion batteries because of their unique structure. It is believed that these unique materials may be applied in many fields.
Because of the coupling between semiconducting and piezoelectric properties in wurtzite materials, strain-induced piezo-charges can tune the charge transport across the interface or junction, which is referred to as the piezotronic effect. For devices whose dimension is much smaller than the mean free path of carriers (such as a single atomic layer of MoS2), ballistic transport occurs. In this study, transport in the monolayer MoS2 piezotronic transistor is studied by presenting analytical solutions for two-dimensional (2D) MoS2. Furthermore, a numerical simulation for guiding future 2D piezotronic nanodevice design is presented.
Hydrogen production from steam or autothermal alcohol reforming has been widely studied, but these methods require high temperatures and emit CO2. Here, we present a new strategy for the simultaneous room-temperature production of hydrogen and other chemicals without the emission of CO2, via the photoelectrochemical reforming of biomass-derived alcohols. The measured hydrogen quantum efficiencies reach around 80% across the entire visible solar spectrum from 450 to 850 nm, achieving an ultrahigh hydrogen production rate of 7.91 μmol/(min·cm2) under AM 1.5G illumination.
In this study, a potentially universal new strategy is reported for the large-scale, low-cost fabrication of visible-light-active highly ordered heteronanostructures based on the spontaneous photoelectric-field-enhancement effect inherent in pyramidal morphology. The hierarchical vertically oriented arrayed structures comprise an active molecular co-catalyst at the apex of a visible-light-active large band gap semiconductor for low-cost solar water splitting in a neutral aqueous medium without the use of a sacrificial agent.
Two-dimensional ZrS2 materials have potential for applications in nanoelectronics because of their theoretically predicted high mobility and sheet current density. Herein, we report the thickness and temperature dependent transport properties of ZrS2 multilayers that were directly deposited on hexagonal boron nitride (h-BN) by chemical vapor deposition. Hysteresis-free gate sweeping, metalinsulator transition, and T–γ (γ ~ 0.82–1.26) temperature dependent mobility were observed in the ZrS2 films.
In this paper, we propose a novel construction of silicon nanowire (SiNW) negative-AND (NAND) logic gates on bendable plastic substrates and describe their electrical characteristics. The NAND logic gates with SiNW channels are capable of operating with a supply voltage as low as 0.8 V, with switching and standby power consumption of approximately 1.1 and 0.068 nW, respectively. Superior electrical characteristics of each SiNW transistor, including steep subthreshold slopes, high Ion/off ratio, and symmetrical threshold voltages, are the major factors that enable nanowatt-range power operation of the logic gates. Moreover, the mechanical bendability of the logic gates indicates that they have good and stable fatigue properties.
We demonstrate an easy and scalable low-temperature process to convert porous ternary complex metal oxide nanoparticles from solution-synthesized core/shell metal oxide nanoparticles by thermal annealing. The final products demonstrate superior electrochemical properties with a large capacity and high stability during fast charging/discharging cycles for potential applications as advanced lithium-ion battery (LIB) electrode materials. In addition, a new breakdown mechanism was observed on these novel electrode materials.
Extracellular matrix (ECM) plays a very important role in regulating cell function and fate. It is highly desirable to fabricate biomimetic models to investigate the role of ECM in stem cell differentiation. In this study, arginine–glycine–aspartate (RGD)-modified gold nanoparticles (Au NPs) with tunable surface ligand density were prepared to mimic the ECM microenvironment. Their effect on osteogenic and adipogenic differentiation of human mesenchymal stem cells (MSCs) was investigated. The biomimetic Au NPs were taken up by MSCs in a ligand density-dependent manner. The biomimetic NPs with a high RGD density had an inhibitive effect on the alkaline phosphatase (ALP) activity, calcium deposition, and osteogenic marker gene expression of MSCs. Their effect on oil droplet formation and adipogenic marker gene expression was negative when RGD density was low, while their effect was promotive when RGD density was high. The biomimetic Au NPs regulated the osteogenic and adipogenic differentiation of MSCs mainly through affecting the focal adhesion and cytoskeleton. This study highlights the roles of biomimetic NPs on stem cell differentiation that could provide a meaningful strategy in fabricating functional biomaterials for tissue engineering and biomedical applications.
Silk is a widely available, edible, biocompatible, and environmentally sustainable natural material. Particulate matter (PM) pollution has drawn considerable attention because it is a serious threat to public health. Herein, we report a human-friendly silk nanofiber air filter, which exhibits superior filtration efficiency for both PM2.5 and submicron particles with obviously low pressure drop and low basis weight compared to typical commercial microfiber air filters. Additionally, other functions such as antibacterial activity could be easily integrated into the silk nanofiber air filters, enabling the fabrication of multifunctional air filters. All the above characteristics, combined with the natural abundance and biocompatibility of silk, suggest a great potential for the use of silk nanofibers as air filters, especially as comfortable and personal air purifiers.
Copper sulfide (Cu7S4) nanoparticles coated with an ultra-high payload (~5.0 × 107 fluorine atoms per particle) of fluorinated ligands (oleylamine functionalized 3,5-bis(trifluoromethyl)benzaldehyde, 19FOAm) exhibited a single intense 19F magnetic resonance (MR) signal and efficient near infrared photothermal performance in water medium. In vivo assessment revealed strong 19F MR signals at cancerous lesions and effective inhibition of tumor growth after photothermal treatment, indicating the great potential of these fabricated nanoprobes for simultaneous 19F MR imaging and photothermal therapy.
To achieve better control of the formation of silver sulfide (Ag2S) nanoparticles, ultrasmall Ag nanoclusters protected by thiolate ligands (Ag44(SR)30 and Ag16(GSH)9) are used as precursors, which, via delicate chemistry, can be readily converted to monodisperse Ag2S nanoparticles with controllable sizes (4–16 nm) and switchable solvent affinity (between aqueous and organic solvents). This new synthetic protocol makes use of the atomic monodispersity and rich surface chemistry of Ag nanoclusters and a novel two-phase protocol design, which results in a well-controlled reaction environment for the formation of Ag2S nanoparticles.
Yolk–shell architectures have attracted extensive attention owing to their unique structure and infusive applications. MoS2 is regarded as one of the most promising catalytic materials for hydrogen evolution by the splitting of water. In this work, a simple self-template solvothermal approach is developed for the synthesis of novel MoS2 yolk–shell microspheres with a hierarchical porous structure by reacting MoO2 microspheres with L-cysteine. A dissolutionrecrystallization formation mechanism is proposed for the MoS2 yolk–shell microspheres. Owing to structural superiority, the new material architecture exhibits improved photoelectrochemical properties, including efficient hydrogen evolution reaction catalytic activities, a high photocurrent density, a small overpotential, and a low charge-transfer resistance.
Nanoporous (NP) Si/Cu composites are fabricated by means of alloy refining followed by facile electroless dealloying in mild conditions. NP-Si/Cu composites with a three-dimensional porous network nanoarchitecture with different Cu contents are obtained by changing the feeding ratio of alloy precursors. Owing to the rich porosity and integration of conductive Cu into a nanoporous Si backbone, the NP-Si85Cu15 composite exhibits modified conductivity and reduced volumetric expansion/fracture during repeated charging-discharging processes in lithium-ion batteries (LIBs), thus exhibiting much higher cycling reversibility than NP-Si92Cu8 and pure NP-Si. With the advantages of unique performance and easy preparation, NP-Si/Cu composite has potential for application as an advanced anode material for LIBs.
Metal nanowire networks represent a promising candidate for the rapid fabrication of transparent electrodes with high transmission and low sheet-resistance values at very low deposition temperatures. A commonly encountered challenge in the formation of conductive nanowire electrodes is establishing high-quality electronic contact between nanowires to facilitate long-range current transport through the network. A new system involving nanowire ligand removal and replacement with a semiconducting sol-gel tin oxide matrix has enabled the fabrication of high-performance transparent electrodes at dramatically reduced temperatures with minimal need for post-deposition treatment.
A thermal emitter composed of a frequency-selective surface metamaterial layer and a hexagonal boron nitride-encapsulated graphene filament is demonstrated. The broadband thermal emission of the metamaterial (consisting of ring resonators) was tailored into two discrete bands, and the measured reflection and emission spectra agreed well with the simulation results. The high modulation frequencies that can be obtained in these devices, coupled with their operation in air, confirm their feasibility for use in applications such as gas sensing.
Manipulating the alignment of liquid crystals (LCs) is a hot and fundamental issue for their applications in block copolymers, photonics, actuators, biosensors, and liquid-crystal displays. Here, the surface characteristic of Cu2O nanocrystals was well controlled to manipulate the orientation of the LCs. The mechanism of the orientation of the LCs induced by Cu2O nanocrystals was elucidated based on the interaction between the LCs and Cu2O nanocrystals. To comprehensively prove our assumption, different types of LCs (nematic, cholesteric, and smectic) as well as the same type of LCs with different polarities were selected in our system. Moreover, the photomechanical behaviors of the LC polymer composites demonstrated that the alignment of LCs can be effectively manipulated using Cu2O nanocrystals.
Sandwich structured graphene-wrapped FeS-graphene nanoribbons (G@FeS-GNRs) were developed. In this composite, FeS nanoparticles were sandwiched between graphene and graphene nanoribbons. When used as anodes in lithium ion batteries (LIBs), the G@FeS-GNR composite demonstrated an outstanding electrochemical performance. This composite showed high reversible capacity, good rate performance, and enhanced cycling stability owing to the synergy between the electrically conductive graphene, graphene nanoribbons, and FeS. The design concept developed here opens up a new avenue for constructing anodes with improved electrochemical stability for LIBs.
Manipulating the polarization of light at the nanoscale is essential for the development of nano-optical devices. Owing to its corrugated honeycomb structure, two-dimensional (2D) layered black phosphorus (BP) exhibits outstanding in-plane optical anisotropy with distinct linear dichroism and optical birefringence in the visible region, which are superior characteristics for ultrathin polarizing optics. Herein, taking advantage of polarized Raman spectroscopy, we demonstrate that layered BP with a nanometer thickness can remarkably alter the polarization state of a linearly-polarized laser and behave as an ultrathin optical polarization element in a BP-Bi2Se3 stacking structure by inducing the exceptionally polarized Raman scattering of isotropic Bi2Se3. Our findings provide a promising alternative for designing novel polarization optics based on 2D anisotropic materials, which can be easily integrated in microsized all-optical and optoelectronic devices.
