共查询到20条相似文献,搜索用时 109 毫秒
1.
汪修尧 《有色金属(选矿部分)》1990,(6):1-5
矿石性质复杂,浮选分离难度大,主要原因是:黄铁矿易浮,在石灰的高碱性矿浆中(游离氧化钙含量高达863克/米~3)难以被抑制;高碱性介质中铅离子含量高,导致黄铁矿受到活化而易浮;铜、铅矿物紧密共生。通过研究,采用亚硫酸-石灰法成功地实现了铜铅银矿物与易浮黄铁矿的浮选分离;采用硫化钠与活性炭脱药、五硫化二磷及硫酸铜与亚硫酸氢钠组合药剂法,也成功地实现了铜铅矿物的浮选分离。连续浮选扩大试验获得了良好指标。 相似文献
2.
孙长泉 《有色金属(选矿部分)》1991,(4):18-21
接触交代矽卡岩类型磁铁矿中一般均含有铜元素。由于形成时期不同,铜的赋存状况各有差异,有的以自然铜状态存在,但含量很低,不够综合回收品位,但经磁选将大量的磁铁矿选出后,自然铜大部分在磁选尾矿中得到富集,再经过重选进一步富集后,可用浮选方法综合回收。 相似文献
3.
4.
本文概述了白云鄂博稀土资源的主要特点及其与选矿的关系,总结了回收稀土的选矿生产流程及存在的主要问题。讨论了弱磁—强磁—浮选新工艺流程回收稀土的合理性以及稀土矿物和其它矿物的分选行为。认为适宜的入选原料是提高稀土产量和质量的关键。新工艺回收稀土的品位和回收率均有较大幅度提高。 相似文献
5.
电沉积Ni-W-P-SiC复合材料的组织及结构 总被引:4,自引:0,他引:4
X—射线衍射仪测定表明,当Ni—W—P—SiC复合镀层中的磷含量大于8wt%时,镀层在镀态时呈非晶态结构;α—SiC微粒的存在并不影响复合镀层的结构,也不参与结构的转变。热处理温度对Ni—W—P—SiC复合镀层的组织结构有一定的影响,当温度升到300~400℃时,产生Ni3P粒子,起到沉淀硬化作用,因此,复合镀层的硬度最高;若继续升高温度,Ni3P粒子长大,然后集聚并粗化,导致镀层软化,硬度下降。扫描电镜证明,α—SiC微粒在复合镀层中的分布较均匀。添加剂的加入,有利于提高复合镀层的晶化温度。 相似文献
6.
7.
介绍TN—C—S系统的特点,通过石佛水厂公寓楼启用时电气异常现象的处理,说明在TN—C—S系统中,PEN线必须规范连接。 相似文献
8.
复杂难选钼铜硫多金属矿选矿技术研究 总被引:4,自引:4,他引:0
原矿中钼品位为0.081%,铜含量很低为0.04%,而硫含量较高为2.70%,钼铜硫矿物之间以及它们与脉石矿物之间嵌布粒度微细,并且铜硫之间及与其他硫化矿物之间呈微细粒互相包裹,脉石矿物异常好浮。为了同时回收该矿石中的目的矿物,研究采用了合理有效的选矿流程方案及药剂制度,使难选铜、钼、硫矿物得到有效的回收,获得钼精矿品位46.10%、回收率83.43%,铜精矿品位11.92%、回收率74.40%,硫精矿品位45.35%、回收率90.51%的良好选矿指标。 相似文献
9.
10.
11.
12.
13.
14.
15.
Conclusions The deformation of the blocky mass around a working can be interpreted as displacement of the material in a convergent radial
channel with an aperture angle of 360°. A kinematic scheme permitting the formulation of the problem in statically determined
form (similar to the classical scheme for calculation of the pressure of the earth at a supporting wall) is constructed.
Axisymmetric solutions for different levels of block interaction on contact are given. Estimates of the carrying capacity
are obtained in the case of rigid-plastic contact between the block and in conditions of dry friction. It is shown that this
scheme admits of transition in the limit to the accurate solution of the Lame problem in the continuum formulation.
Cases in which increase in the relative slip between the blocks leads to decrease in the interaction force between them (weakening)
are considered. With slight weakening, the deformation is a stable process. If the weakening is greater than a critical level,
the solution becomes unstable, which indicates the uncontrollable release of stored elastic energy from the mass.
Institute of Mining, Siberian Branch, Academy of Sciences of the USSR, Novosibirsk. Translated from Fiziko-Tekhnicheskie Problemy
Razrabotki Poleznykh Iskopaemykh, No. 6, pp. 7–15, November–December, 1990. 相似文献
16.
1. | A working and a rock mass around it may be defined by one dimensionless parameter λ≥0. This parameter predetermines the behavior of the rock mass with any changes of mine pressure and support resistance. |
2. | With 0≤λ<1 prediction of the behavior is clear: Reaction of the rock mass to any changes in mine pressure and support resistance will have a stable character. |
3. | If λ>1 then stability for the reaction is only retained up to a certain critical condition. Parameters of the critical condition depend on mine pressure, the degree of weakening at contacts between blocks, geometrical dimensions and elasticity moduli. With a changeover through the critical condition there is uncontrolled dynamic release of potential elastic energy for the rock mass. |
17.
I. D. Chashchin 《Journal of Mining Science》1991,27(4):337-343
Institute of Mining, Siberian Branch, Academy of Sciences of the USSR, Novosibirsk. Translated from Fiziko-Tekhnicheskie Problemy
Razrabotki Poleznykh Iskopaemykh, No. 4, pp. 77–85, July–August, 1991. 相似文献
18.
New, more exact approximated solution to the direct problem of identifying a signal of a vertically oriented magnetic dipole
on a borehole axis is reported. This solution makes possible to process the data of the high-frequency induction logging isoparametric
sounding, including negative values of the measured phase difference. The new approximation enables taking into account the
variable borehole radius that is of special importance when a highly-conductive drilling mud is used. As the obtained expression
is explicit, it can be used for the quick data processing and for solving inverse problems of the borehole geophysics.
__________
Translated from Fiziko-Tekhnicheskie Problemy Razrabotki Poleznykh Iskopaemykh, No. 4, pp. 3–9, July–August, 2006. 相似文献
19.
20.
A promising alternative to hydraulic fracturing is proposed for enhancing oil recovery in a reservoir with satisfactory vertical
permeability by way of creating hydraulic communication between a well and the reservoir via two in-line holes of a small
diameter. An approximated calculation of stationary productivity of this system is presented. An analysis of this system efficiency
is performed by comparing its conductivity and productivity coefficients with the same coefficients of a created fracture
having the length and opening equatable with the length and diameter of the hole.
__________
Translated from Fiziko-Tekhnicheskie Problemy Razrabotki Poleznykh Iskopaemykh, No. 5, pp. 20–28, September–October, 2006. 相似文献