| MVR空心桨叶干燥污泥的特性及动力学 |
| |
| 引用本文： | 郑玲玲,程榕,郑燕萍,杨阿三,孙勤.MVR空心桨叶干燥污泥的特性及动力学[J].化工进展,2016,35(Z1):53-57. |
| |
| 作者姓名： | 郑玲玲 程榕 郑燕萍 杨阿三 孙勤 |
| |
| 作者单位： | 浙江工业大学化学工程学院, 浙江 杭州 310014 |
| |
| 摘 要： | 基于空心桨叶干燥机建立了一套机械蒸汽再压缩式热泵干燥系统,将相同质量的污泥(100±0.1)kg,在真空压力约为95kPa、压缩机出口蒸汽温度为95~115℃进行恒温干燥实验,从而得到污泥干燥过程中含水率以及干燥速率等变化曲线,压缩机出口蒸汽温度为95~115℃,污泥临界湿含量从0.22增加到0.34。引入5种常用的污泥干燥模型,利用Origin软件对实验数据进行分段拟合分析,得到污泥加速阶段和降速阶段的干燥动力学模型MR=exp(-ktn)。以分段函数形式表示的干燥方程分别为:MR=exp-(2.78×10-4T-0.01896)t1.596],(加速阶段);MR=0.894-0.564(1.737×10-4T-8.05×10-3)t(恒速阶段);MR=exp-(2.26×10-4T-0.01365)t1.984](降速阶段)。对实验得到的干燥模型进行验证,计算得到各干燥阶段污泥湿含量平均相对误差,并将实验所得干燥曲线和干燥速率曲线与模型计算值进行比较,可以看出分段处理能较好的描述污泥干燥规律。
|
| 关 键 词： | 机械蒸汽再压缩技术 干燥 压缩机 模型 干燥动力学 干燥方程 |
| 收稿时间： | 2016-01-29 |
Drying properties and kinetics of MVR technology applied to the hollow blade dryer drying sludge |
| |
| ZHENG Lingling,CHENG Rong,ZHENG Yanping,YANG Asan,SUN Qin.Drying properties and kinetics of MVR technology applied to the hollow blade dryer drying sludge[J].Chemical Industry and Engineering Progress,2016,35(Z1):53-57. |
| |
| Authors: | ZHENG Lingling CHENG Rong ZHENG Yanping YANG Asan SUN Qin |
| |
| Affiliation: | College of Chemical Engineering, Zhejiang University of Technology, Hangzhou 310014, Zhejiang, China |
| |
| Abstract: | Based hollow paddle dryer set up a mechanical vapor recompression heat pump vacuum drying system.The vacuum pressure was about 95kPa, the same mass of sludge(100±0.1)kg at a constant temperature drying experiment at 95-115℃.Get the moisture content of the sludge drying process curves and drying rate curves.The outlet steam temperature of the compressor was 95-115℃, and the critical moisture content of the sludge was increased from 0.22 to 0.34.Five kinds of sludge drying models were introduced.The experimental data were segmented fitting analysis by using origin software and obtain sludge drying kinetics model MR=exp(-ktn), Dried equation with piecewise function expressed respectively:MR=exp-(2.78×10-4T-0.01896)t1.596](acceleration phase);MR=0.894-0.564(1.74×10-4T-8.05×10-3)t(constant speed phase);MR=exp-(2.26×10-4T-0.01365)t1.984](deceleration phase).The drying model was verified by experiments, the average relative error of wet content of sludge in each drying stage was calculated, and the resulting experimental drying curves and drying rate curves were compared with the predicted values. It can be seen that the segmentation process can better describe the sludge drying law. |
| |
| Keywords: | mechanical vapor recompression drying compressor model drying kinetics drying equation |
| 本文献已被 CNKI 等数据库收录！ |
| 点击此处可从《化工进展》浏览原始摘要信息 |
|
点击此处可从《化工进展》下载全文 |
|
